ZFV916Y - Fridge ZANUSSI - Free user manual and instructions

USER MANUAL ZFV916Y ZANUSSI

VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support

SAFETY INFORMATION AND INSTALLATION carefully the Safety chapters before any use or maintenance of the appliance.

Refer to the separate Installation Instructions booklet for Safety Information and Installation. Read

3 Second motor speed

8 Hob to Hood function

5 Maximum motor speed

DAILY USE USING THE HOOD Check the recommended speed according to the table below.

While heating up food, cooking with covered pots. While cooking with covered pots on multiple cooking zones or burners, gentle frying. While boiling and frying big quantities of food without a lid, cooking on multiple cooking zones or burners. While boiling and frying big quantities of food without a lid, big humidity.

Refreshes the air in kitchen after cooking at a very low noise level. It can be activated and de-activated by touching the symbol. The function turns off automatically after 60 minutes. Use after cooking only. that time, the appliance returns to its previous speed settings.

It is recommended to leave the hood operating for approximately 15 minutes after cooking.

When the function is turned on, additional touch on the button does not have any effects.

The control Panel is a sensor field.

Touch the symbols for 1 second to activate the functions.

ACTIVATING AND DEACTIVATING THE FILTER NOTIFICATION Filter alarm reminds to change or clean the charcoal filter and clean the grease filter. The filter indicator

To operate the hood:

1. Turn on the appliance by pressing the symbol. You can now activate the functions. 2. To activate the function touch the symbol. 3. If needed, touch the light symbol illuminate the cooking surface. To turn off the appliance press the again.

is turned on (red) for 30 seconds if the grease filter must be cleaned. The filter indicator flashes (red) for 30 seconds if the charcoal filter must be replaced or cleaned.

Refer to filter alarm in care and cleaning chapter.

1. Switch on the control panel. 2. Make sure that the icons are turned off. 3. To activate or deactivate the charcoal filter

HOB TO HOOD FUNCTION It is an automatic function which connects the hob with a hood. Both the hob and the hood have an infrared signal communicator. Speed of the fan is defined automatically on basis of mode setting and temperature of the hottest cookware on the hob.

You can also operate the fan using the hob manually. The function can be activated from panel of the hob.

If the charcoal filter notification is activated, the filter icon

If the charcoal filter notification is

For more information how to use the function refer to the hob user manual.

deactivated, the filter icon

ACTIVATING MAXIMUM MOTOR SPEED When you press the button

, the Maximum Motor Speed starts to operate for 8 minutes. After

CARE AND CLEANING CLEANING THE GREASE FILTER Each filter must be cleaned at least once a month.

Filters are mounted with the use of clips and pins on the opposite side. To clean the filter: 1. Pull the cover to open it.

REPLACING THE CHARCOAL FILTER The charcoal filter must be replaced if the filter alarm is on.

Refer to the filter alarm in this chapter.

The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter.

2. Press the handle of the mounting clip on the filter panel underneath the hood (1).

WARNING! The charcoal filter is

NON-washable! The filter cannot be regenerated! To replace the charcoal filter: 1. Remove the grease filters from the appliance. Refer to "Cleaning the grease filter" in this chapter. 2. Turn the filter counterclockwise (1) and then pull (2).

1 3. Slightly tilt the front of the filter downwards (2), then pull. Repeat the first two steps for all filters. 4. Clean the filters using a sponge with non abrasive detergents or in a dishwasher.

To mount the filters back follow the steps in reverse order.

The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the performance of the appliance.

5. To mount the filters back follow the first two steps in reverse order. Repeat the steps for all filters if applicable.

FILTER ALARM Refer to activating and deactivating the filter alarm in daily use chapter.

Refer to cleaning the grease filter in this chapter.

Refer to cleaning the charcoal filter or replacing the charcoal filter (depends on filter type).

WARNING! The charcoal filter is nonwashable!

The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter.

To replace the filter: 1. Remove the grease filters from the appliance. Refer to "Cleaning the grease filter" in this chapter. 2. To install a new filter, perform the same steps in reverse order. In any case, it is necessary to replace the filters at least every four months.

REPLACING THE LAMP This appliance is supplied with a LED lamp and separate control gear (LED driver). These parts can be replaced by a technician only. In case of any malfunction refer to "Service" in the "Safety

Instructions" chapter.

ENVIRONMENTAL CONCERNS with the symbol with the household waste.

Return the product to your local recycling facility or contact your municipal office.

Recycle materials with the symbol

. Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked

8 Funksioni “Hob to Hood”