User manual BOSCH Pressure washer : 34 free PDF user manuals

Q: How do I connect the water hose to the UniversalAquatak 130 pressure washer?

To connect the water hose to your BOSCH UniversalAquatak 130 pressure washer, follow these steps: Connect one end of the water hose (not included) to the cold water tap Connect the other end of the hose to the device, to the designated water inlet Fully open the tap to supply the device Important points: The minimum required supply flow rate is 7 l/min The water temperature must not exceed 40 °C The maximum inlet pressure is 1 MPa The water hose is not included with the device If you want to use rainwater or water from a tank, the UniversalAquatak 130 has a suction option (kit sold separately) with a hose and suction filter included.

Q: Should oil be used for the maintenance of the Bosch Aquatak 100 Plus pressure washer?

For the Bosch Aquatak 100 Plus pressure washer, it is not necessary to use oil for its operation or regular maintenance. This device is designed to operate without the addition of oil, which makes it easier to use and maintain. However, to ensure a long lifespan and good performance, it is important to: Regularly clean the water filter to avoid blockages. Check the condition of the seals and connections. Store the device in a dry place and protect it from frost. If you notice leaks or mechanical problems related to the pump, it is advisable to contact an authorized Bosch service center for professional assistance.

Q: Why is my Bosch Aquatak ECO pressure washer leaking water?

A water leak on a Bosch Aquatak ECO pressure washer can have several causes. Here are the main possible reasons and how to check them: 1. Check the fittings and hoses Make sure all fittings, including the water inlet and outlet hoses, are tight and properly installed. Inspect the hoses for any cracks, cuts, or wear that could cause a leak. 2. Check the pump and seals A leak at the pump may indicate a worn or damaged seal. In this case, it is recommended to have the seals checked or replaced by a professional. 3. Overpressure and safety system If the washer is equipped with an overpressure safety system, a leak may occur if the pressure is too high. Check that the operating pressure complies with the manufacturer's specifications. 4. Water tank (if applicable) If your model has a built-in water tank, inspect it for any cracks or damage that could lead to a leak. In summary, to resolve a water leak on your Bosch Aquatak ECO, start by checking the fittings and hoses, then inspect the pump and seals. If the problem persists, it is advisable to contact a qualified after-sales service for appropriate diagnosis and repair.

Models BOSCH Pressure washer most viewed

User manual BOSCH Pressure washer : user manuals and guides in PDF

Models BOSCH Pressure washer most viewed

Other categories BOSCH

Recent questions about Pressure washer BOSCH