User manual BOSCH Chainsaw : 21 free PDF user manuals

Q: What are the dimensions of the chain for the BOSCH AKE 30 electric chainsaw?

The BOSCH AKE 30 electric chainsaw uses a chain with the following precise specifications: Chain pitch: 3/8 inch (notation 3/8" - 90) Link thickness: 1.1 mm (or 0.043 inch) Number of links: 45 Guide bar length: 30 cm These dimensions are essential for ordering a compatible replacement chain. If you need to change the chain, make sure the new chain exactly meets these specifications, especially the pitch (3/8 inch) and the number of links (45). You will find the authentic Bosch replacement references under the numbers: F 016 800 256 for the chain only F 016 800 259 for the chain and guide bar set The correct link thickness (1.1 mm) is important to ensure a secure fit on the guide and proper chain tension. Only use chains compatible with your AKE 30 model to ensure optimal and safe operation.

Q: How to reinstall and tension the chain on a BOSCH AKE 45 S electric chainsaw?

To reinstall and tension the chain on your BOSCH AKE 45 S electric chainsaw, follow the steps below: Reinstalling the chain: Unplug the device to avoid any accidental start-up. Remove the chain guide cover by unscrewing the bolts using the provided wrench. Remove the chain guide to access the chain. Position the chain on the chain guide ensuring that the cutting teeth are facing forward. Replace the chain guide on the chainsaw aligning it correctly. Re-screw the cover of the chain guide by tightening the bolts by hand to hold it in place. Tensioning the chain: Locate the tensioning mechanism usually located on the side of the chainsaw (button or screw). Turn the mechanism clockwise to tension the chain. Check the tension : the chain should be well-tensioned but able to turn freely around the chain guide. Ensure that the bolts of the cover are tightened properly to secure everything. Make sure that the chain is neither too loose nor too tight to ensure optimal and safe operation of your chainsaw.

Q: Where is the fuse located on the BOSCH AKE 35 S electric chainsaw?

The BOSCH AKE 35 S electric chainsaw does not have an accessible fuse like some other electrical devices. Instead, it is equipped with a built-in thermal circuit breaker that protects the motor against overloads and overheating. What to do in case of a power issue or if the chainsaw does not start? Unplug the device from the electrical outlet to ensure your safety. Inspect the power cord for any damage, cuts, or poor connections. Allow the chainsaw to cool down if it has been used intensively. The thermal circuit breaker may have tripped to protect the motor. Wait about 30 minutes for the device to cool down. Plug the chainsaw back in and check if it works again. If after these steps the chainsaw still does not work, it is recommended to contact a Bosch after-sales service or a qualified professional for proper diagnosis and repair.

Models BOSCH Chainsaw most viewed

User manual BOSCH Chainsaw : user manuals and guides in PDF

Models BOSCH Chainsaw most viewed

Other categories BOSCH

Recent questions about Chainsaw BOSCH