User manual BOSCH Dishwasher : 1 297 free PDF user manuals

Q: What does error code E;24 mean on my BOSCH SHX84AAF5N dishwasher?

The error code E;24 indicates a drainage problem. Your BOSCH SHX84AAF5N dishwasher is not draining water properly. Here are the three main causes and how to resolve them: Blocked drainage hose - Check that the drainage hose is not bent, kinked, or obstructed. Straighten it and rinse it if it is dirty. Blocked drain pump turbine - Remove the cover of the drain pump located at the bottom of the wash chamber. Clean around the turbine (valves) to remove any debris or food residue. Firmly replace the cover. Your home's drainage line - Ensure that the drainage line of your home's plumbing is not clogged. Start by checking the drainage hose for kinks or blockages. If the problem persists, inspect the pump turbine as described above.

Q: Why can't I change the wash cycle?

If your Bosch SHE3AR56UC dishwasher does not allow you to change the wash cycle, several factors may be at play: Check the child lock An active child lock prevents cycle selection. If the Child Lock indicator is on, press and hold the < button until this indicator turns off to disable the lock. Stop the current cycle You cannot change cycles while a program is active. To interrupt the cycle: Press and hold the Start button until the Active indicator turns off Wait about 1 minute for the draining to finish Press On/Off to reset the appliance Check the delayed start If you have activated the delayed start for 3, 6, or 9 hours, this may prevent cycle changes. Resetting the appliance should lift this blockage. Ensure the door is closed properly The door must be fully locked before you can select a new cycle using the Cycle Select buttons (arrows). Once these checks are completed, press On/Off to turn on the appliance, use the arrow buttons to choose your program from the seven available (Heavy Wash, Auto Wash, Normal Wash, Delicate Wash, Express Wash, Half Load, Rinse & Hold), then press Start .

Q: How to install or replace the front panel of the BOSCH SBV6ZB801E dishwasher?

Mounting the front panel (front door) Preparation Check that the insulation piece has been positioned correctly and secured inside the appliance Ensure that the hinges are correctly inserted into the front door Installation Procedure Close the inner door without slamming it Push the front door upwards under the control panel Press and secure the panel against the inner door Fasten with two metal screws 4 x 11 mm on one side Fasten with four metal screws 4 x 11 mm on the other side Required Tools Torx T20 screwdriver with drilling Torx T15 screwdriver Warning: Properly position the cables and secure them with tape before closing. Misplaced cables can be damaged when closing the door.

Q: Is there a drying cycle only on the Bosch SHP65T56UC?

No, this Bosch SHP65T56UC model does not offer a drying cycle only. However, it has several options to optimize drying: Extra Shine™ - Increases the temperature and extends the drying time for better results with most cycles (except rinse) Intensive Drying - Accessible via settings d:00/d:01, this option uses a higher temperature during the final rinse to improve drying To optimize drying, also adjust the rinse aid dispenser between r:00 and r:06 according to your needs (r:05 being the default value). Note that plastic dries less effectively than porcelain due to its material properties.

Q: Does the control panel of the Bosch SMT8ZC801A dishwasher move when the door is opened and closed?

The control panel of the Bosch SMT8ZC801A dishwasher is a fixed element, securely anchored to the appliance's chassis. It shows no movement - neither up nor down - when the door is opened or closed. The door itself has hinges and a closing system independent of the panel. Only the door moves during its operation. This ensures the durability of the touch or button panel and prevents premature wear of the electrical connections. If you observe abnormal movement of the panel during operation, it could indicate a mechanical issue with the chassis or the front panel fixings.

Q: Why does the fuse or circuit breaker trip with my BOSCH SRS3012?

The BOSCH SRS3012 requires a power supply of 220-240 V, 50 Hz, 10 A . If the fuse or circuit breaker trips regularly, several causes are possible: 1. Insufficient fuse Check in your electrical panel that the dishwasher circuit has a protection (fuse or circuit breaker) of at least 10 A . If a 6 or 8 A protection is installed, it will be too sensitive and will trip too often. 2. Overload of the electrical circuit If other high-power devices are connected to the same circuit (radiator, oven, cooktop, washing machine), the total consumption may exceed the limit and trigger the protection. Try plugging the BOSCH SRS3012 into a dedicated or less loaded circuit. 3. Sensitive residual current circuit breaker (RCCB) If your installation is equipped with a 30 mA residual current circuit breaker (RCCB), it may be more sensitive to small current leaks from the dishwasher. Test by temporarily plugging into another outlet with less sensitive protection. 4. Fault in the appliance If the fuse trips only during the startup or operation of the BOSCH SRS3012, the appliance may have an internal fault (short circuit, moisture). In this case, stop using it and contact a repair technician. Tips: Start by checking the amperages of your protection and the absence of other large consumers on the same circuit. If the problem persists, consult a qualified electrician.

Q: How to stop a washing cycle on the BOSCH SHE53CE5N dishwasher and why does the cycle continue after turning off and on again?

On the BOSCH SHE53CE5N, there is no specific stop button to interrupt an ongoing cycle. However, you can pause the cycle by opening the door - the machine automatically stops as soon as you open it (be careful of steam and hot water). Regarding your issue of the cycle continuing after turning off/on: according to the manual, this is normal. The dishwasher operates as follows: After pressing the Start button, you must close the door within 4 seconds If the door remains open for more than 4 seconds, the program pauses You then need to press the Start button again to restart the cycle If your machine restarts the cycle even after a complete shutdown using the On/Off button, this could indicate: A previous cycle waiting to resume (check that the door was closed in time) A stuck button or an electronic control issue To completely resolve the issue, try opening the door for a few minutes after turning off to really interrupt the cycle, then turn the device off again.

Q: What are the recommendations for installing the drain hose of the SHXM4AY56N dishwasher?

Although the user manual does not contain detailed installation instructions (which can be found in the separate installation document provided with the appliance), here are the key points mentioned in the notice regarding the drain hose: Key Installation Points Install the drain hose with a high loop - This is crucial for the proper functioning of the appliance Avoid kinks or bends that could block the water flow Ensure that the hose is not clogged or blocked Related Error Codes If you encounter the error E:24 during use, it generally indicates that the drain hose is kinked, clogged, or blocked. In this case, check that the high loop is properly in place and that the hose is not damaged. For detailed installation instructions with diagrams and precise measurements, refer to the specific installation document provided with your SHXM4AY56N dishwasher.

Q: I cannot change the program from Speed 60 to Normal - how can I unlock the selection?

If your BOSCH SHE43DM5N dishwasher is stuck on Speed 60 and refuses to switch to Normal , here are the solutions to try in order: Quick Checks Step 1: Stop the current cycle — Briefly press the On/Off button to turn off the dishwasher. Wait 10 seconds, then turn it back on. You can then select another program. Step 2: Check the door — The door must be completely closed . If it is ajar, program selections are locked for safety reasons. Step 3: Press the buttons firmly — Use firm and sustained pressure (not just a light touch) on the Normal selection button. The buttons on this model sometimes require prolonged pressure. If the problem persists The manual for the SHE43DM5N does not mention a specific lock for Speed 60. If after these checks you remain stuck, it may indicate a mechanical fault with the selector or an electronic issue. In this case, contact BOSCH customer service — they can access the complete technical diagnosis of your appliance.

Q: How to switch from the Speed 60 program to the Normal cycle on the BOSCH SHE43DM5N?

To switch from the Speed 60 program to the Normal cycle on your BOSCH SHE43DM5N dishwasher, you must first turn off the device before selecting the new program. Here are the steps: Briefly press the On/Off button to turn off the dishwasher Press the On/Off button again briefly to turn the device back on Select the Normal program by pressing the corresponding button on the control panel. This program washes everyday dishes without baked-on residues, saving energy and water Select any desired options if needed Press the Start button to begin the cycle Close the door within 4 seconds after pressing Start. If the door remains open for more than 4 seconds, the program will pause and you will need to press Start again to resume washing Important: All buttons on this dishwasher use touch technology and only require a light touch. A brief press is enough for the system to register your command. If the Speed 60 program continues to blink after attempting to change it, completely turn off the device for a few seconds before turning it back on and repeat the procedure. The Normal cycle is ideal for your daily loads. If you want to set Normal as a favorite for quicker access, you can use the Home Connect app available for smartphones or press and hold the Favorite button for 3 seconds to save your current selection.

Models BOSCH Dishwasher most viewed

User manual BOSCH Dishwasher : user manuals and guides in PDF

Models BOSCH Dishwasher most viewed

Other categories BOSCH

Recent questions about Dishwasher BOSCH