The screen of my DigiLevel Plus 60 lights up and then immediately turns off when I press the start button. Why?

Q: The screen of my DigiLevel Plus 60 lights up and then immediately turns off when I press the start button. Why?

Possible cause: According to the specifications of the Laserliner DigiLevel Plus 60, the device has an automatic shut-off function after 3 minutes of inactivity . If the screen lights up and then immediately turns off after pressing the POWER/OFF button (button 4), there are two possible causes: Checks to perform: Battery status : The device uses 2 AAA/LR03 batteries. Weak or depleted batteries can cause unstable starting. Replace the batteries with new ones and try again. Prolonged button press : Make sure to briefly press the POWER/OFF button to turn on the device. A prolonged or repeated press may be interpreted as a shutdown command. Battery contacts : Check that the battery contacts are not dirty or oxidized. Clean them lightly with a dry cloth if necessary. Defective battery or circuit : If the problem persists after replacing the batteries and checking the contacts, there may be a fault in the power circuit. In this case, contact the manufacturer Laserliner for further diagnosis or repair. If the screen lights up normally but the device turns off after a few seconds of use, this may also indicate that the batteries are insufficiently charged to maintain operation.

Question

Accepted Answer

Possible cause: According to the specifications of the Laserliner DigiLevel Plus 60, the device has an automatic shut-off function after 3 minutes of inactivity. If the screen lights up and then immediately turns off after pressing the POWER/OFF button (button 4), there are two possible causes:

Checks to perform:

Battery status: The device uses 2 AAA/LR03 batteries. Weak or depleted batteries can cause unstable starting. Replace the batteries with new ones and try again.
Prolonged button press: Make sure to briefly press the POWER/OFF button to turn on the device. A prolonged or repeated press may be interpreted as a shutdown command.
Battery contacts: Check that the battery contacts are not dirty or oxidized. Clean them lightly with a dry cloth if necessary.
Defective battery or circuit: If the problem persists after replacing the batteries and checking the contacts, there may be a fault in the power circuit. In this case, contact the manufacturer Laserliner for further diagnosis or repair.

If the screen lights up normally but the device turns off after a few seconds of use, this may also indicate that the batteries are insufficiently charged to maintain operation.

User manual Laserliner Measuring equipment : user manuals and guides in PDF

Models Laserliner Measuring equipment most viewed

Other categories Laserliner

Recent questions about Measuring equipment Laserliner