Q: How to charge the battery of the HUSQVARNA LC 348VE?

Battery: The HUSQVARNA LC 348VE is equipped with a 12V / 2.5Ah lead battery that normally charges while mowing. Charging steps: Disconnect the battery cable from the battery Connect the battery cable to the charger Plug the charger into a wall outlet (220V, 50Hz) Important conditions: Do not charge at a temperature below +5°C Charge the battery once or twice during the mowing season Before wintering, ensure that the battery is fully charged Maintenance: The lead battery does not require special maintenance. However, a used battery should never be disposed of as household waste - take it to a specialized workshop or a collection point.

Q: How to start the HUSQVARNA ROYAL 43 EL electric mower?

To start your HUSQVARNA ROYAL 43 EL mower , follow these three essential steps: Step 1 - Press the lock button (G1): Press and hold the lock button on the control panel. Step 2 - Operate the start/stop lever (G2): Press one of the start/stop levers towards the upper handle while keeping the lock button pressed. Step 3 - Release the lock button: Continue to press the start/stop lever towards the upper handle and release the lock button (G3). Once started, your mower will operate as long as you hold the start/stop lever towards the handle. To stop the device, simply release this lever. Important: Before starting, ensure that the mower is properly plugged into an electrical outlet. Do not operate the device if you are tired, ill, or under the influence of alcohol, drugs, or medication. Always keep your feet away from the blades when starting the engine.

Q: Where is the battery located on the ROYAL 43 SE mower?

The battery of the ROYAL 43 SE mower is located under a cover, behind the motor . To access it, you must first stop the mower and disconnect the spark plug before removing the screws from the cover. Battery Specifications Voltage: 12V rechargeable Type: Lead-acid battery Full charge time: 24 hours Charger: Supplied with the machine Recommended Maintenance To maintain battery performance, perform a minimum recharge every six months, even if the mower is not used regularly. For complex interventions or mandatory annual maintenance, consult an authorized Husqvarna dealer.

Q: What type of engine oil to use for the HUSQVARNA LB48V?

The HUSQVARNA LB48V requires a high-quality SAE 30 four-stroke oil . HUSQVARNA recommends using its specific four-stroke oil, but any high-quality four-stroke oil compatible with this specification is suitable. Important: never use two-stroke oil, as it would damage the engine. Capacity and maintenance Tank capacity: 0.6 liters Check: before each start with the gauge located on the filler cap Drain: annually or every 25 hours of operation Regularly check the oil level to ensure optimal performance and longevity of your Briggs & Stratton mower's engine.

Q: Is the Husqvarna LC 48 (SE) mower equipped with a 2-stroke or 4-stroke engine?

The HUSQVARNA LC 48 mower (and its self-propelled variant LC 48 SE ) is equipped with a 4-stroke engine from Briggs & Stratton . Unlike a 2-stroke engine, the oil circuit is completely independent of the fuel. The manual clearly states: “Never use 2-stroke engine oil” , which confirms the 4-stroke design of the engine. This engine has a displacement of 190 cm³ with a speed of 2900 rpm . It runs on unleaded gasoline with a minimum of 77 octanes. The fuel tank has a capacity of 1.2 liters , while the oil tank holds 0.6 liters . For engine maintenance, use only SAE 30 oil . The manual recommends HUSQVARNA four-stroke oil, but any good quality four-stroke oil is suitable. The oil change should be performed every year or every 25 hours of operation, whichever comes first. The ignition system uses a Champion RJ19LM spark plug with an electrode gap of 0.5 mm . The spark plug should be cleaned regularly and replaced monthly or more often if it becomes dirty. Before each use, always check the oil level, as insufficient oil can cause serious damage to the engine.

Q: How does the Bioclip function work on the HUSQVARNA LC53 E electric mower and how do I use it?

The Bioclip function on the HUSQVARNA LC53 E electric mower is a mulching feature that finely chops the cut grass and distributes it directly onto the lawn. This enriches the soil with nutrients and eliminates the need to collect the cut grass. How the Bioclip function works When the Bioclip function is activated, the cut grass is chopped into small pieces. These pieces are then evenly spread over the lawn, promoting better lawn maintenance. This method also reduces the amount of green waste to be collected. How to use the Bioclip function on the LC53 E Remove the grass collection box if it is installed. Insert the diffuser plug (or stopper) into the collection channel, in place of the box. Make sure the plug is securely in place so that the cut grass is directed towards the mulching deck. Mow normally. By following these steps, you activate the Bioclip function and enjoy effective mulching mowing with your HUSQVARNA LC53 E mower.

Q: What is the reference for the blade drive cable for the HUSQVARNA ROYAL 43 S electric mower?

The reference for the blade drive cable for the HUSQVARNA ROYAL 43 S mower is 513841000 . This cable, also known as the blade clutch cable, is an essential mechanical part that transmits the operator's command to the blade clutch. It is a wear part that can deteriorate over time and may need replacement, especially if the blade does not stop properly or if engagement becomes difficult. Before ordering this replacement cable, make sure that the reference 513841000 is indeed the one for your mower by checking the product label located on your machine or by consulting the user manual. This original Husqvarna part ensures exact compatibility and optimal performance of your mower. To replace this cable, access depends on the specific model of your mower, but generally, the cable is attached above the motor housing and connected on one side to the control lever and on the other to the blade clutch. Refer to the Maintenance section of the instruction manual for your ROYAL 43 S for detailed replacement instructions. If you are not comfortable with this intervention, an authorized Husqvarna service center can perform the replacement for you.

Question 1

The wheel drive control does not work or does not respond

Accepted Answer

If the wheel drive control lever is not responding correctly, the problem usually lies with the clutch cable adjustment. Here’s how to fix it:

Adjustment procedure (screw on the clutch cable, page 195 of the manual):

If the wheels do not move despite the lever being pressed: turn the adjustment screw counterclockwise to shorten the cable
If the mower moves on its own without pressing the lever: turn the screw clockwise to lengthen the cable

Test after each half turn to find the correct adjustment.

Before adjusting: check that the lever moves freely to the handlebar grip (no snagging, sheath intact).

If the adjustment does not resolve the issue, the cable or clutch system may be damaged and will require the intervention of an authorized HUSQVARNA repairer.

Question 2

How to charge the battery of the HUSQVARNA LC 348VE?

Accepted Answer

Battery: The HUSQVARNA LC 348VE is equipped with a 12V / 2.5Ah lead battery that normally charges while mowing.

Charging steps:

Disconnect the battery cable from the battery
Connect the battery cable to the charger
Plug the charger into a wall outlet (220V, 50Hz)

Important conditions:

Do not charge at a temperature below +5°C
Charge the battery once or twice during the mowing season
Before wintering, ensure that the battery is fully charged

Maintenance: The lead battery does not require special maintenance. However, a used battery should never be disposed of as household waste - take it to a specialized workshop or a collection point.

Question 3

How to start the HUSQVARNA ROYAL 43 EL electric mower?

Accepted Answer

To start your HUSQVARNA ROYAL 43 EL mower, follow these three essential steps:

Step 1 - Press the lock button (G1): Press and hold the lock button on the control panel.
Step 2 - Operate the start/stop lever (G2): Press one of the start/stop levers towards the upper handle while keeping the lock button pressed.
Step 3 - Release the lock button: Continue to press the start/stop lever towards the upper handle and release the lock button (G3).

Once started, your mower will operate as long as you hold the start/stop lever towards the handle. To stop the device, simply release this lever.

Important: Before starting, ensure that the mower is properly plugged into an electrical outlet. Do not operate the device if you are tired, ill, or under the influence of alcohol, drugs, or medication. Always keep your feet away from the blades when starting the engine.

Question 4

Where is the battery located on the HUSQVARNA ROYAL 43 SE mower?

Accepted Answer

The 12V battery of the HUSQVARNA ROYAL 43 SE mower is located under a cover, behind the motor.

To access the battery:

Unscrew and remove the cover located above the motor
The 12V rechargeable battery will then be accessible
A charger is provided with your mower for recharging (charging time: 24 hours)

If you need to replace the battery, make sure the replacement battery is fully charged before its first use. Refer to the dedicated section of your manual for the complete 10 steps for safe recharging and maintenance instructions.

Question 5

Where is the battery located on the ROYAL 43 SE mower?

Accepted Answer

The battery of the ROYAL 43 SE mower is located under a cover, behind the motor. To access it, you must first stop the mower and disconnect the spark plug before removing the screws from the cover.

Battery Specifications

Voltage: 12V rechargeable
Type: Lead-acid battery
Full charge time: 24 hours
Charger: Supplied with the machine

Recommended Maintenance

To maintain battery performance, perform a minimum recharge every six months, even if the mower is not used regularly. For complex interventions or mandatory annual maintenance, consult an authorized Husqvarna dealer.

Question 6

Which charger to use for the HUSQVARNA LC 353VE lawn mower?

Accepted Answer

The HUSQVARNA LC 353VE electric mower is actually a petrol mower equipped with a battery electric start. The battery is only used to power the electric start button, not to propel the mower which operates with a conventional petrol engine.

Recommended battery and charger:

Battery type: Li-Ion 10.8 V / 21.6 Wh
Required charger: Husqvarna approved charger for Li-Ion battery
Charger power supply: 100-240 V AC, 50-60 Hz (compatible with standard outlets worldwide)

Charging procedure:

Connect the charger directly to the battery
Plug the charger into a standard wall outlet (100-240 V, 50-60 Hz)
An empty battery fully charges in 2 hours
Always remove the charger from the electrical outlet first, then from the battery connector

Charging indicators: The battery has 4 LEDs to display its charge level. The charger shows a steady red light while charging and a steady green light when the battery is fully charged.

Important tips: Only use an approved Husqvarna charger, as a damaged battery reduces product safety. Always remove the battery when not using the mower or for any maintenance operation. Avoid letting the battery discharge completely, as this could damage it.

To order a replacement charger or any specific spare part, contact an authorized HUSQVARNA service center or visit www.husqvarna.com.

Question 7

What type of engine oil to use for the HUSQVARNA LB48V?

Accepted Answer

The HUSQVARNA LB48V requires a high-quality SAE 30 four-stroke oil. HUSQVARNA recommends using its specific four-stroke oil, but any high-quality four-stroke oil compatible with this specification is suitable.

Important: never use two-stroke oil, as it would damage the engine.

Capacity and maintenance

Tank capacity: 0.6 liters
Check: before each start with the gauge located on the filler cap
Drain: annually or every 25 hours of operation

Regularly check the oil level to ensure optimal performance and longevity of your Briggs & Stratton mower's engine.

Question 8

Is the Husqvarna LC 48 (SE) mower equipped with a 2-stroke or 4-stroke engine?

Accepted Answer

The HUSQVARNA LC 48 mower (and its self-propelled variant LC 48 SE) is equipped with a 4-stroke engine from Briggs & Stratton. Unlike a 2-stroke engine, the oil circuit is completely independent of the fuel. The manual clearly states: “Never use 2-stroke engine oil”, which confirms the 4-stroke design of the engine.

This engine has a displacement of 190 cm³ with a speed of 2900 rpm. It runs on unleaded gasoline with a minimum of 77 octanes. The fuel tank has a capacity of 1.2 liters, while the oil tank holds 0.6 liters.

For engine maintenance, use only SAE 30 oil. The manual recommends HUSQVARNA four-stroke oil, but any good quality four-stroke oil is suitable. The oil change should be performed every year or every 25 hours of operation, whichever comes first.

The ignition system uses a Champion RJ19LM spark plug with an electrode gap of 0.5 mm. The spark plug should be cleaned regularly and replaced monthly or more often if it becomes dirty. Before each use, always check the oil level, as insufficient oil can cause serious damage to the engine.

Question 9

How does the Bioclip function work on the HUSQVARNA LC53 E electric mower and how do I use it?

Accepted Answer

The Bioclip function on the HUSQVARNA LC53 E electric mower is a mulching feature that finely chops the cut grass and distributes it directly onto the lawn. This enriches the soil with nutrients and eliminates the need to collect the cut grass.

How the Bioclip function works

When the Bioclip function is activated, the cut grass is chopped into small pieces.
These pieces are then evenly spread over the lawn, promoting better lawn maintenance.
This method also reduces the amount of green waste to be collected.

How to use the Bioclip function on the LC53 E

Remove the grass collection box if it is installed.
Insert the diffuser plug (or stopper) into the collection channel, in place of the box.
Make sure the plug is securely in place so that the cut grass is directed towards the mulching deck.
Mow normally.

By following these steps, you activate the Bioclip function and enjoy effective mulching mowing with your HUSQVARNA LC53 E mower.

Question 10

What is the reference for the blade drive cable for the HUSQVARNA ROYAL 43 S electric mower?

Accepted Answer

The reference for the blade drive cable for the HUSQVARNA ROYAL 43 S mower is 513841000.

This cable, also known as the blade clutch cable, is an essential mechanical part that transmits the operator's command to the blade clutch. It is a wear part that can deteriorate over time and may need replacement, especially if the blade does not stop properly or if engagement becomes difficult.

Before ordering this replacement cable, make sure that the reference 513841000 is indeed the one for your mower by checking the product label located on your machine or by consulting the user manual. This original Husqvarna part ensures exact compatibility and optimal performance of your mower.

To replace this cable, access depends on the specific model of your mower, but generally, the cable is attached above the motor housing and connected on one side to the control lever and on the other to the blade clutch. Refer to the Maintenance section of the instruction manual for your ROYAL 43 S for detailed replacement instructions. If you are not comfortable with this intervention, an authorized Husqvarna service center can perform the replacement for you.

User manual HUSQVARNA Electric mower : user manuals and guides in PDF

Models HUSQVARNA Electric mower most viewed

Other categories HUSQVARNA

Recent questions about Electric mower HUSQVARNA