EFBP90681X - Built-in oven ELECTROLUX - Free user manual and instructions

USER MANUAL EFBP90681X ELECTROLUX

WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Welcome to Electrolux. Visit our website to: Get usage advice, brochures, trouble shooter, service information: www.electrolux.com Register your product for better service: www.electrolux.com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www.electrolux.com/shop

ENVIRONMENT CONCERNS Recycle the materials with the symbol

. Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office department for household waste or the shop where you purchased this product.

CUSTOMER CARE AND SERVICE We recommend the use of original spare parts.

When contacting Service, ensure that you have the following data available. The information can be found on the rating plate. Model, PNC, Serial Number. Warning / Caution-Safety information. General information and tips Environmental information. Subject to change without notice.

SAFETY INSTRUCTIONS Caution! Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. The extractor hood has been designed exclusively for domestic use.

Caution! Do not connect the appliance to the mains until the installation is fully complete.

Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply. Always wear work gloves for all installation and maintenance operations. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or knowledge, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the appliance. This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Never use the hood without effectively mounted grating! The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is nstalled must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. The flaming of foods beneath the hood itself is severely prohibited. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and ignite. Caution! Accessible parts of the hood may became hot when used with cooking appliance.

With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities. The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH).

This must be completed in accordance with the maintenance instructions provided in this manual). Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires. Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the non-observance of the instructions included in this manual. Warning! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

2. USE The hood serves to aspirate the fumes and vapors resulting from cooking.

The attached installation manual indicates the version to be used depending on the model you have, the suction version with external evacuation

internal recirculation

3. INSTALLATION The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III in accordance with installation instructions.

Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled.

The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than

50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Warning! Installation and electrical connection, may only be carried out by authorised technicians.

4. MAINTENANCE ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. DO NOT USE ALCOHOL! Warning! Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. 4.1 Grease filter - This must be cleaned once a month (or when the filter saturation indication system – if envisaged on the model in possession – indicates this necessity) using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity.

4.2 Regenerable activated charcoal filter

To regenerate the charcoal filters, place them into a baking oven preheated to 150°C. The process will take 2 to 3 hours, depending on the level of odor contamination. Caution: Avoid burning yourself! • Do not under any circumstances regenerate the active carbon filter in the microwave. • Do not under any circumstances use the pyrolysis function of the oven for the active carbon filter regenerate. • Before regeneration, clean the active carbon filter with a damp cloth. Remove the active charcoal filters from the baking oven only after they have had time to cool down. During the cooling down process unpleasant odors may develop in the air for a short period of time! The frequency of charcoal filter honeycomb element regeneration depends on the intensity of your cooking operations. We recommend to perform a regeneration every 2-3 months. Additional cleaning of the active charcoal filter with a moist cloth should be performed every 2-3 months.

5. CONTROLS The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights.

Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. The control switches are located on the unit’s front panel. Note: a remote control can be purchased apart, contact the local authorized dealer. T7

T1 Button Speed (power) of suction 1

T2 Button Speed (power) of suction 2 T3 Button Speed (power) of suction 3 T4 Button ON/OFF Speed (power) of suction 4 Note: The Speed (power) of suction 4 remains in function for 5 minutes, then the it returns to the previous setting. T5 Button for filter saturation control T6 Button OFF speed Button for control panel activationdeactivation T7 Button ON/OFF lights Button for activation/deactivation of charcoal filter saturation control Delayed switch-off function for the suction speed (power): Select the desired speed and press the same button again for more than 2 sec.; the button flashes to indicate that the function has been activated. Press again to deactivate the function. The selected speed will turn off after: Speed (power) of suction 1: 20 minutes Speed (power) of suction 2: 15 minutes Speed (power) of suction 3: 10 minutes Speed (power) of suction 4: 5 minutes

Note: The hood is equipped with a protection system against disturbances of the mains power network; in case of peaks exceeding 2kVolts, the hood will reactivate autonomously after approximately two minutes from the last disturbance.

Function Activation – Deactivation control panel

Press the T6 button for more than 5 seconds Function Activation – Deactivation control of charcoal filter saturation With the hood off press the T7 button for more than 5 seconds. Button T5 flashes: Twice to indicate that the saturation control for the charcoal filter has been activated Once to indicate that the saturation control for the charcoal filter has been deactivated Function of filter saturation control and reset At regular intervals, depending on how long the hood is used, the button T5 lights to indicate that it is necessary to carry out the maintenance of the filters according to instructions in the related paragraphs. Button T5 lights up with steady light: it is necessary to perform maintenance on the grease filter Button T5 lights up flashing: it is necessary to perform maintenance on the charcoal filter. Reset filter saturation indicator: With the hood off press the T5 button for more than 2 sec. Repet the operation if necessary.

6. LIGHTING The hood is equipped with a lighting system based on LED technology.

The LEDs guarantee an optimum lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical energy. Caution! Do not look directly into the LED light. For replacement, contact the technical service.

DE GEBRAUCHSANLEITUNG