What should I do if my SAMSON RS110A Hi-Fi system does not turn on?

Question

Accepted Answer

If your Samson RS110A Hi-Fi system does not turn on, follow these troubleshooting steps to identify and resolve the issue:

Checking the power supply and cable
Start by checking that the IEC power cable is properly connected to the AC Power Inlet on the back panel of the RS110A. Ensure that the power cord is correctly plugged into a functional wall outlet. Test this outlet by plugging in another device to confirm that it is supplying power. Also, inspect the power cable along its entire length for any cuts, wear, or visible damage, especially at the connectors. If the cord is damaged, it must be replaced immediately with a compatible cable.

Checking the voltage selector
The back panel of the RS110A has a voltage selector. Depending on the model, it should be set to 110-120V or 220-240V according to your region. If the selector is incorrectly set, the device will not turn on. Check that this voltage matches the one indicated on the back panel of your RS110A and the one supplied by your wall outlet.

Inspecting the internal fuse
The RS110A is equipped with a fuse holder on the back panel. A blown fuse can prevent the device from turning on. Before accessing the fuse, ensure that the power cable is unplugged. Locate the fuse holder and remove the fuse by gently pushing it upwards. Inspect it: a functional fuse should be clear or translucent with an intact filament inside, while a blown fuse will show a broken filament or dark discoloration. If the fuse is defective, replace it with a fuse of the same type and rating (usually 250V according to the manual). After replacement, plug the cable back in and test the power on.

Checking the power button and POWER LED
Press firmly and clearly on the POWER Switch located on the back panel of the RS110A. Wait a few seconds after pressing. Once the device is powered correctly, check that the POWER LED, located near the power button, lights up and shows a green light, indicating that the amplifier is active. The absence of this green light suggests a power issue that must be addressed before proceeding.

Restarting the device after overheating
If your RS110A has been running intensively or continuously for an extended period, it may have turned off automatically for thermal protection reasons. Cut the power by pressing the POWER button, then allow the device to cool down for at least 30 minutes in a well-ventilated area. Ensure that the ventilation grilles are not blocked by dust or debris. After this cooling period, reactivate the power and attempt to turn it on again.

If after following all these steps your RS110A still does not turn on, the issue may be internal and requires the intervention of a qualified technician. Contact Samson technical support at support@samsontech.com or at 1-800-3-SAMSON (1-800-372-6766) for return authorization and to have your device repaired.

User manual SAMSON Hi-fi system : user manuals and guides in PDF

Models SAMSON Hi-fi system most viewed

Other categories SAMSON

Recent questions about Hi-fi system SAMSON