MBL-42M - Blender MPM - Free user manual and instructions

USER MANUAL MBL-42M MPM

EN We wish you satisfaction from using the product and invite you to check a wide range of other MPM appliances

Close-up of a kitchen brush with a black handle and metal casing (no visible text or symbols)

MBL-42M

TYČOVY MIXER SADA

STABMIXER SET

MA1520317 - KOMPLEK MILATER VEPOE . FEE

MANUAL BLENDER-SET

BATIDORA DE MANO SET

MIXEUR PLONGEANT MANUEL - KIT:

KEZI MIXER - KESZLET

TRULLATORE AIMANO - SET

RANKINIS MAISYTUVAS - RINKINYS

DELENDERS - KONPEERTS

DECTNY ZESTAW

DELENDEN RECENT - ZESTAW BLENDEN DE MÔNÉ - EST

Labeled diagram of kitchen utensils including a blender, whisker, and stand mixer

Two kitchen utensils: a hand holding a stand mixer and a hand holding a digital controller, both in a kitchen setting (no visible text or symbols)

Stainless steel body Speed control + Turbo function

Kitchen countertop with kitchen utensils including blender, whisk, and juice (no visible text or labels)

Container (600 ml) with stainless steel blade / Attachment for beating egg / Two whisks for beating and dough kneading / Puree attachment / XL stainless steel mixing attachment (27 cm), fit for use in high temperatures / Lid-covered container (800 ml)

BEZPEČNOSTNÍ POKYNY PŘI POUŽÍVÁNÍ

-Read the instructions carefully before use.
-Do not handle the device with wet hands.
-Take special care when children are near the device.
- Do not use the device for purposes other than those for which it was intended.
- Do not immerse the device, cable or charger in water or other liquids.
- Do not let the power cord hang over the edge of the table/counter.
-Do not leave the device unattended during operation.
- Never use a damaged device, including one with a damaged cord or plug, in which case have it repaired at an authorised service centre.
-Do not use the device outdoors.
- Do not hang the power cable on sharp edges or allow it to come into contact with hot surfaces.
-Do not place the device on a hot surface.
- Do not place the device near other electric cookers, burners, ovens, etc.
-The device should be put on a dry, flat and stable surface.
-The device is intended for domestic use only.
-Always ensure that all parts of the device are correctly fitted before starting work.
-Use of accessories not recommended by the manufacturer may cause damage to the device, fire or personal injury.
-The device may be used by people with reduced physical, sensory or mental abilities, as well as those without prior knowledge or experience in using such types of device, provided that they either are supervised or have been instructed and informed about potential threats which they fully understood.
-The device must be kept away from children. Keep the device and cable out of the reach of children.
-Children are forbidden to perform cleaning and maintenance activities.
-Children should be supervised to ensure that they do not play with the device.
- Do not pull the plug out of the power socket by pulling the cord.

- The equipment is not designed to operate using external timers or a separate remote control.

-Do not connect the plug to the power socket with wet hands.

- For the safety of children, please do not leave freely accessible parts of the packaging (plastic bags, cardboard boxes, polystyrene, etc.).

- WARNING! Do not allow children to play with the film. Danger of suffocation!

- Check that the power parameters on the device's rating plate correspond to the parameters of your power supply network.

-CAUTION! Before starting cleaning and maintenance works, disconnect the device from the power supply network and wait until it cools down completely after work. Do not submerge the device into water!

- CAUTION! Do not use sharp objects, abrasive polishes, solvents or other strong chemicals for cleaning since their use may cause damages to the device.

- Before the first use, remove all bags, stickers, tapes and transport locks from the device and its accessories.

- Disconnect the device from the power supply each time when the device is left unattended and before any assembling, disassembling, or cleaning works.

- Wait until the motor stops completely before disassembling the device.

- Pay special attention when handling the blades, especially when removing and washing them.

- Do not exceed the maximum capacity indicated on the container.

-Allow hot ingredients to cool down before processing them.

- Clean the device, in particular parts being in direct contact with food, before first use, immediately after finishing work and if the device has not been used for a long time. The procedure is described in details in the “CLEANING AND MAINTENANCE” section.

- Keep your hands away from moving parts when the device is in operation!

- CAUTION! Avoid physical contact with the cutting blades while emptying and cleaning the device as they are very sharp and might cause serious injuries.

DESCRIPTION OF THE APPLIANCE

1. Blender housing
2. Control buttons

A. ON/OFF
B. Turbo
C. Fluent speed control knob

1. Lock buttons
2. Mixing attachment
3. Mixing container with lid (800 ml)

4. Whipping attachment for egg whites, light creams and sauces

5. Attachment for mounting mixers

6. Mixers for whipping light creams and sauces, 2 pcs
7. Puree attachment
8. Shredding kit

D. Container lid
E. Chopping knife with a stainless steel blade
F. Container for grinding (600 ml)

BEFORE FIRST USE

1. Remove the device from the box, remove all bags, labels, cardboard profiles and fillers. Make sure the device has not been damaged during transport. Contact the seller in case of any doubts.
2. Make sure the electrical mains parameters match the technical data on the device's rating plate.
3. Carefully wash and dry all elements that contact food, following the recommendation in the "CLEANING & MAINTENANCE" chapter.

BLENDER ASSEMBLY AND USE

CAUTION! Do not allow the blender housing (1) to get wet. Prior to the accessories mounting/demounting procedure, make sure the device is not connected to the power supply.

CAUTION! The temperature of food prepared with the blender must not exceed 60^ C.

The MBL-42M version of the blender is a compact device facilitating everyday meal preparation. The device is especially recommended for grinding raw and cooked vegetables, soft fruits (without seeds), preparing sauces, creams, soups, mixing liquids, etc. Prior to grinding large ingredients with a blender cut them into smaller pieces (1-2 cm).

1. Mount one of the selected accessories to the blender housing (1): mixing attachment (4), foam whipping attachment (6), mixer attachment (7) with beater mixers (8) or grinding set (10). The accessories lock when pressed into the housing (1). To disconnect the selected accessory, press the lock buttons (3) and slide them out. Pay close attention in order to avoid self injures or parts damages when disconnecting accessories.

SHREDDING KIT (10) – PREPARATION FOR WORK

1. Place the container (F) on a dry and stable surface.
2. When holding the plastic shaft, place the knife (E) into the container by putting it on the metal shaft.
3. Place food items (vegetables, fruits, nuts, meat, onions, hard cheese, hard-boiled eggs, garlic, herbs) inside the container.

CAUTION! Cut the deboned meat into small pieces, then place them in a grinding container. The maximum amount of mixed product must not exceed 200 g.

1. Put on the top cover (D) and turn it slightly clockwise to lock it.

2. After ensuring proper assemble of all components, connect the plug of the device to the power source.

3. To start blender:

- Set the speed using the fluent control knob (C), then press and hold the ON/OFF button (A).

- Press and hold the Turbo button (B) for short-term operation of the device at maximum speed. In this mode, the device can be used for a maximum of 30 seconds. After this time, turn off the device and wait for it to cool down for at least 3 minutes.

CAUTION! Before pouring the contents of the container, wait until the knife stops!

1. After the work is finished, turn the fluent control knob to the lowest speed and disconnect the device from the power source.
2. The maximum continuous operation time of the device should not be exceeded (information provided in the table below).

Appetizer type	Maximum time of continuous operation
Mixing attachment (4) 1 min
Whipping attachment for egg whites, light creams and sauces (6)	1 min
Attachment with beaters for whipping light creams and sauces (7,8)	1 min
Puree attachment (9) 1 min
Shredding kit (10) 30 sec

ATTENTION! The device should be turned off and left to cool down for a period of not less than 3 minutes after completing the full work cycle.

CLEANING AND MAINTENANCE

1. Before cleaning/maintenance disconnect the device from the power supply.
2. Clean the blender housing (1) with a damp cloth. Avoid direct contact of the blender housing with liquids; neither submerge nor wash under running water, etc.
3. Wash the other accessories in warm water with detergent, rinse and dry.
4. The puree attachment is equipped with a removable blade, which make washing hard-to-reach places easier. To disconnect it, press the blade against its base and then turn it in the direction indicated by the open padlock symbol. To install the blade back, do the opposite.
5. Periodically check parts before reassembling. Do not use the blender if the knives are jammed or rotate with difficulty.

CAUTION! Do not use sharp objects, abrasive polishes, solvents or other strong chemicals for cleaning since their use may cause damages to the device.

TECHNICAL DATA

Model MBL- 42M
Power supply 220-240 V ~ 50Hz
Power 800-1500W
Availability of the shutdown and standby mode available
Power consumption in standby mode -
Power consumption in the shutdown mode 0,1 W
Power consumption in network standby mode	-
Automatically goes into standby mode after -
Automatically goes into the shutdown mode after -
Network standby mode, if the device has a connection function with the appli cation	-
Length of mains cable 1,2 M

CAUTION! MPM agd S.A. reserves the right to technical changes.

Proper disposal of the product (waste electrical and electronic equipment)

Marking on the product indicates that after the service-life of the product expires, it should not be disposed with other type of municipal waste. Used equipment may have a negative impact on the environment and health of people due to potentially containing hazardous substances, mixtures and components. Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may cause a release of substances that are hazardous to the environment and health.

Used equipment should be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the electric waste collection points, the user should contact the municipal point of electric waste collection or used equipment processing department.

BESCHRIJVING VAN HET APPARAAT

1. Staafmixerbehuizing
2. Bedieningsknoppen