SM 515 - Blender ECG - Free user manual and instructions

USER MANUAL SM 515 ECG

1. Filler cap
2. Lid
3. Plastic mixing container 1,5 I
4. Herbs, nuts and spices grinder
5. The body of the appliance
6. Rotary switch with backlight
7. Base with non-slip feet

HR/BIH

Read carefully and save for future use!

Warning: The safety measures and instructions, contained in this manual, do not include all conditions and situations possible. The user must understand that common sense, caution and care are factors that cannot be integrated into any product. Therefore, these factors shall be ensured by the user/s using and operating this appliance. We are not liable for damages caused during shipping, by incorrect use, voltage fluctuation or the modification or adjustment of any part of the appliance.

To protect against a risk of fire or electric shock, basic precautions shall be taken while using electrical appliances, including the following:

1. Make sure the voltage in your outlet corresponds to the voltage provided on the appliance label and that the socket is properly grounded. The outlet must be installed according to valid safety instructions.
2. Do not operate blender with a damaged cord. All repairs including cord replacements shall be performed by a professional service centre! Do not remove protective covers of the appliance, risk of electric shock!
3. Protect the appliance against direct contact with water and other liquids, to prevent potential electric shock.
4. Do not operate the blender outdoors or in a moist environment and do not touch the cord or appliance with wet hands. Risk of electric shock.
5. Close supervision is necessary for operating the blender near children!
6. Do not leave the blender running unattended.
7. Pay close attention when handling and cleaning, blades are very sharp and can cause injury. Avoid contact with moving parts.
8. Use for processing food only. The highest possible temperature of processed food is 80^ . Do not use boiling food.

GB

GB

1. Switch all control elements OFF prior to disconnecting the cord from the outlet.
2. Leaving the blender cord connected to outlet unattended is not recommended. Disconnect the cord from the electrical outlet prior to performing maintenance. Do not pull the cord from the outlet by yanking the cord. Unplug the cord from the outlet by grasping the plug. Wrap the cord around the blender freely prior to putting away.
3. Do not allow the cord to touch hot surfaces or lead the cord over sharp edges.
4. Use accessories only advised by the manufacturer, otherwise you risk losing the warranty.
5. Use the blender only in accordance with the instructions given in this manual. This blender is intended for domestic use only. The manufacturer is not liable for damages caused by the improper use of this appliance.
6. Never use the blender if the blender container is damaged or the blade unit is loose or damaged.
7. Use the blender only with the lid attached. If the container turns when the motor is running, immediately turn off the blender and tighten the container to the blender's body.
8. Do not put the container filled with food or liquids in the freezer. Freezing the contents could damage the container and the blade unit.
9. This appliance should not be used by children. Keep the appliance and its power supply out of reach of children. The appliance may be used by persons with reduced physical, sensory or mental capacities or lack of experience and knowledge, if they are supervised or if they were instructed how to use the appliance safely and understand potential dangers. Children shall not play with the appliance.

Do not immerse the body of the appliance in water!

OPERATING INSTRUCTIONS

Thoroughly rinse the mixing container, the mill and the blade unit with warm water before first use. Do not use dishwasher. Then dry everything thoroughly. Be very careful when handling the blade unit, the blades are very sharp. Never immerse the body of the blender in water.

Assembling the appliance

Important: Mixing container, grinder and blade unit are subject to wear and tear. Before use, check the condition of the blade unit and in the event of damage, do not use the blender and have the damaged part replaced.

1. Make sure the blender is switched off. Place the base of the blender on a dry, even surface.
2. Put the container or grinder in its place at the base of the blender and make sure it is properly seated.
3. Plug the power cable into the power outlet.
4. Place the ingredients in the container and close the lid.
5. Processing food or beverage: place your hand on the lid and switch the blender on.
6. After every use of the blender, turn the switch to the OFF position and disconnect the cord from the outlet.
7. Always switch off the blender or the grinder before removing it and wait until the blade unit stops.
8. When removing the blender container or the grinder, lift them up vertically. If you feel resistance from the container, move it gently from side to side. Never twist the container or the grinder.
9. Do not put on the container or the grinder when the motor is on.

Blender and speed controls

The blender offers the following speeds: 1, 2 and PULSE. Pulse mode allows precise control of the mixing process - the motor is running only when you press control. When you switch to speed 1 or 2 blender is running until the you switch it back to 0.

Continual mixing

Put one hand on the lid of the container. Turn on the blender by turning the switch to the appropriate speed and mix for required time. Then switch the blender off by turning it to position 0.

Notice: Let the motor in operation not more than 1 minute or alternatively 1 minute on and 3 minutes off to prevent overheating and subsequent damage.

Controlled mixing in the pulse mode.

Put one hand on the lid of the container. Turn the switch to "PULSE" position and hold about 2 seconds. Let go of the switch and wait until the blade unit stops. Repeat the cycle until prepared food reaches the desired consistency.

Note: If necessary, the switch can be held in the "PULSE" position longer than 2 seconds.

Using the grinder

Use the grinder to grind herbs, spices and nuts.

1. Place the material in the bowl of the grinder. Fill half the space at most.
2. Place the blade unit on the bowl and secure it by turning it until the unit locks into the bayonet lock.
3. Attach the grinder to the base with the motor and make sure that it is properly seated.
4. Switch to maximum speed or use the pulse mode. Hold the container with hand during grinding.
5. Process so long until the ingredients are perfectly ground.

Notice: If the grinding should take more than 30 seconds, stop the grinding after 30 seconds and continue after a pause (5 minutes).

Useful tips

• Be careful when processing warm liquids. The hot liquid could splash out when you remove the lid.
  If you plan to add liquids to solid foods, start with little amounts of liquid. Gradually add more and more liquid through the hole in the lid.

If you are using the blender to prepare salsa or other recipes with tomatoes, onions and other vegetables, you can achieve better results with lesser speed.
If during processing the blender stops or ingredients stick to the container sides, turn off the blender, remove the lid and use a plastic spatula to remove the sticking mixture.
- Do not use the blender container for storing prepared foods or beverages.

CLEANING

Do not immerse the base with motor into water! Clean only with damp cloth.

1. Unplug the blender from the power supply.
2. Remove the container from the base of the blender. Remove the lid and pour in a cup of cleaning solution prepared from a few drops of dishwashing liquid and clean water.
3. Wash the inside of the container and lid and rinse thoroughly.
4. Wipe the blender base, the control panel and the power cord using moist cloth or sponge.
5. Carefully wash the blade unit and seal in warm soapy water and rinse thoroughly.
6. Do not wash the blade unit, seal and lid in a dishwasher.
7. When washing the container do not unscrew the blade unit from the container.

GB

TECHNICAL SPECIFICATIONS

Nominal voltage: 220 - 240V 50 / 60Hz

Nominal input power: 500 W

KB = max. 30 s (maximum grinding time - grinder)

KB = max. 60 s (maximum mixing time - blender)

Noise level: 87 dB

USE AND DISPOSAL OF WASTE

Wrapping paper and corrugated paperboard - deliver to scrapyard. Packing foil, PE bags, plastic elements - throw into plastic recycling containers.

WARRANTY: The following situations void the warranty:

Incorrect or inappropriate handling of the device, failure to observe safety measures applicable to the device, the use of force, alterations or repairs made by a party other than authorized service center.

Components subject to normal wear and tear are not covered under warranty.

DISPOSAL OF PRODUCTS AT THE END OF LIFETIME

Disposal of electric and electronic equipment (valid in EU member countries and other European countries with an implemented recycling system)

The represented symbol on the product or package means the product shall not be treated as domestic waste. Hand over the product to the specified location for recycling electric and electronic equipment. Prevent negative impacts on human health and the environment by properly recycling your product.

Recycling contributes to preserving natural resources. For more information on the recycling of this product, refer to your local authority, domestic waste processing organization or store, where you purchased the product.

This product complies with EU directive requirements on electromagnetic compatibility and electrical safety.

The instruction manual is available at website www.ecg-electro.eu.

Changes in text and technical parameters reserved.

08/05

SIGURNOSNE UPUTE

BEZBEDNOSNA UPUTSTVA

250 69 Klicany, Czech Rep. e-mail: [e-mail]

K+B Progres, a.s.

U Expertu 91 tel.: [phone]

250 69 Klicany, Czech Rep. e-mail: [e-mail]

Distributor fur DE: K+B E-Tech GmbH & Co. KG

Barbaraweg 2, DE-93413 Cham

250 69 Klicany, Czech Rep. e-mail: [e-mail]

K+B Progres, a.s.

U Expertu 91 tel.: [phone] (English)

250 69 Klicany, Czech Rep. e-mail: [e-mail]

K+B Progres, a.s.

U Expertu 91 tel.: [phone] (English)

250 69 Klicany, Czech Rep. e-mail: [e-mail]

K+B Progres, a.s.

U Expertu 91 tel.: [phone]

250 69 Klicany, Czech Rep. e-post: [e-mail]

K+B Progres, a.s.

U Expertu 91 tel.: [phone]

250 69 Klicany, Czech Rep. el. pastas: [e-mail]

K+B Progres, a.s.

U Expertu 91 tel.: [phone]

250 69 Klicany, Czech Rep. e-pasts: [e-mail]

CZ

SK

PL

HU

DE

HR/BIH

SI

SR/MNE

FR

IT

ES

ET

LT

LV