Q: How to change or replace the batteries of the SEVERIN AH 7912?

Important: according to the manual, the main device should only be opened for battery disposal . Any other opening may void your warranty. Accessing the batteries: The battery compartment is located under the device Open the cover by removing the two access screws The vacuum cleaner contains Ni-MH rechargeable batteries Before using the new device: the first charge should last about 14 hours before use. The manual for this notice does not provide detailed instructions for replacing the batteries themselves. In case of battery issues, please contact Severin Service directly to avoid voiding your warranty.

Q: What is the purpose of button 3 on the SEVERIN MW 7865 microwave?

The button 3 on the control panel of the SEVERIN MW 7865 is the Clock / Weight button. This button serves two main functions: Selection confirmation - It confirms the choice of cooking program. For example, in defrost mode (program 9), press this button to validate your selection. Settings - It allows you to set the clock of the device or to automatically select the weight in the automatic cooking programs. It is a versatile essential button on the electronic control panel of your microwave.

Q: What is the energy consumption of the SEVERIN KS 9883?

The SEVERIN KS 9883 has a daily energy consumption of 0.70 kWh/24h (measured at an ambient temperature of 25°C with a setting of 13°C), which corresponds to an annual consumption of approximately 256 kWh . This appliance has an energy efficiency rating of A+ , ensuring good energy efficiency. However, please note that actual consumption may vary depending on your daily usage and the location of the appliance in your kitchen. The product operates on a standard supply of 230V at 50 Hz and is designed for the normal climate class (range 16-32°C).

Question 1

How to cook popcorn in the SEVERIN MW 9675 microwave?

Accepted Answer

The SEVERIN MW 9675 microwave does not have a dedicated automatic program for popcorn. However, you can cook them effectively using the manual microwave mode with the right settings.

Required equipment:

A special microwave-safe popcorn container (with a vented lid) available commercially
Alternative: a covered bowl with a plate or suitable microwave film
Check the popcorn manufacturer's instructions, as times vary depending on the weight and type of kernels

Cooking procedure:

Place your popcorn container on the microwave's turntable
Press the microwave function button (not grill)
Select a power of 80 to 100% (the SEVERIN MW 9675 has a power of 700 W in microwave mode)
Set the cooking time between 2.5 and 4 minutes depending on the amount of kernels
Press the rotary control to start the cycle

Important points when cooking:

Watch closely after the first minute
The interval between pops gradually increases towards the end of cooking
Stop before the popcorn starts to burn: as soon as the pops become too spaced out, interrupt the cycle by pressing the stop button
The included turntable ensures even heat distribution for a uniform result

Start with 3 minutes at 100% as a reference, then adjust according to your brand of popcorn and your preferences. Test first with a small amount to find the optimal time for your device.

Question 2

Where can I find the function menu in Spanish for the Severin MW 7777?

Accepted Answer

The manual for the Severin MW 7777 is available in Spanish (Español) on notice-facile.com. You can access it directly via the following URL:

https://www.notice-facile.com/es/instrucciones/623867/severin+mw-7777

The Spanish version covers all functions of the combined microwave:

Microwave (power 90-900W on 10 levels)
Grill (1200W)
Very hot air and traditional heat (110-230°C)
Combined programs
Automatic programs (drinks, popcorn, pasta, potatoes, reheating, chicken, pizza, cake, defrosting)
Settings (24h clock format, timer up to 95 minutes, child lock, beep)

The content in castellano starts on page 64 of the PDF document. All function menus, programming steps, and safety tips are detailed in complete Spanish.

Question 3

Can I replace the thermostat of the SEVERIN KA 4110 myself?

Accepted Answer

No, the thermostat of the SEVERIN KA 4110 is not designed to be replaced by the user. According to the manufacturer's instructions, any replacement of internal parts - including the thermostat - must be carried out by an authorized Severin service center.

If you suspect a defect in the thermostat (for example, the coffee maker no longer heats or heats incorrectly), please contact an authorized service center directly, providing:

The model number: KA 4110
Your proof of purchase
A description of the malfunction

If the appliance is still under warranty (2 years), the intervention may be covered according to the warranty conditions.

Question 4

How to change or replace the batteries of the SEVERIN AH 7912?

Accepted Answer

Important: according to the manual, the main device should only be opened for battery disposal. Any other opening may void your warranty.

Accessing the batteries:

The battery compartment is located under the device
Open the cover by removing the two access screws
The vacuum cleaner contains Ni-MH rechargeable batteries

Before using the new device: the first charge should last about 14 hours before use.

The manual for this notice does not provide detailed instructions for replacing the batteries themselves. In case of battery issues, please contact Severin Service directly to avoid voiding your warranty.

Question 5

How to use the defrost function of the SEVERIN MW 9672?

Accepted Answer

The SEVERIN MW 9672 features an automatic defrost program with reduced power, ideal for thawing your food without cooking it. Here’s how to use it:

Set the defrost mode:

Turn the rotary knob counterclockwise until the display shows the number 9
Press the confirmation button to select the defrost program
Turn the rotary knob to display the desired defrosting time (maximum 45 minutes)
Press the rotary knob to start the program

During defrosting: The appliance operates at very low power (80 to 160 W, or P-10 to P-20) to gently thaw the food. You will receive 4 beeps when two-thirds of the programmed time has elapsed. At this point, it is recommended to turn the food and remove the portions that have already thawed, then press the rotary knob to continue the program.

After the programmed defrosting: If the food is not completely thawed, you can continue defrosting in 1-minute additional increments. Repeat the same steps for each additional minute until fully thawed.

Important for plastic packaging: If your food is stored in plastic containers not suitable for microwaves, let them sit for a few minutes at room temperature after removing them from the freezer. Wait until the food easily separates from the sides of the container before placing it in the microwave in a suitable microwave-safe container.

Question 6

What is the purpose of button 3 on the SEVERIN MW 7865 microwave?

Accepted Answer

The button 3 on the control panel of the SEVERIN MW 7865 is the Clock / Weight button.

This button serves two main functions:

Selection confirmation - It confirms the choice of cooking program. For example, in defrost mode (program 9), press this button to validate your selection.
Settings - It allows you to set the clock of the device or to automatically select the weight in the automatic cooking programs.

It is a versatile essential button on the electronic control panel of your microwave.

Question 7

What is the energy consumption of the SEVERIN KS 9883?

Accepted Answer

The SEVERIN KS 9883 has a daily energy consumption of 0.70 kWh/24h (measured at an ambient temperature of 25°C with a setting of 13°C), which corresponds to an annual consumption of approximately 256 kWh.

This appliance has an energy efficiency rating of A+, ensuring good energy efficiency. However, please note that actual consumption may vary depending on your daily usage and the location of the appliance in your kitchen.

The product operates on a standard supply of 230V at 50 Hz and is designed for the normal climate class (range 16-32°C).

Question 8

Where is the thermostat of the SEVERIN KGK 8906 refrigerator located?

Accepted Answer

The thermostat of the SEVERIN KGK 8906 refrigerator is generally located inside the appliance. To locate it:

Open the refrigerator door.
Look on the inner side walls, often on the right or left wall.
The thermostat may be a rotary knob or a dial for adjusting the temperature.
It is sometimes placed near the air vents or cooling ducts.

This position makes it easier to access and adjust the temperature according to your needs. If you do not find it immediately, also check under the interior lighting or on the upper inner part of the main compartment.

Question 9

How do I adjust the temperature of the SEVERIN KGK 8906 refrigerator?

Accepted Answer

To adjust the temperature of your SEVERIN KGK 8906 refrigerator, press the “SET” button on the control panel located inside the appliance several times until the desired setting or the “Fast Cool” indicator lights up. Setting 3 is the optimal temperature for normal use of the refrigerator.

Understanding temperature levels: the temperature is lower at settings 4 and 5, while it is higher at settings 1 and 2. The recommended temperature for the refrigerator compartment is 4 °C. After each adjustment, wait 4 to 6 hours for the temperature to stabilize, then check the result with a refrigerator thermometer placed inside to confirm that the desired temperature has been reached.

Before your first use, let the refrigerator run for 24 hours without food to allow the appliance to reach its target temperature. If you are installing the appliance for the first time, wait 30 minutes after setting it up before plugging it into the power supply.

To fine-tune your setting, keep in mind that the refrigerator has different cold zones: the warmest zone is at the top of the door, while the coldest zone is at the back wall at the bottom of the appliance. If you have too much cold (frost on the walls), increase the temperature. If cooling is insufficient, lower the temperature.

The Fast Cool function can be activated if you need to quickly cool the contents. This function automatically stops after about 26 hours, and the temperature then returns to the previously set setting.

To optimize cooling, you can also adjust the air circulation using the regulator located at the back of the refrigerator compartment. If you turn this regulator to the right, the temperature increases in the freezer and decreases in the refrigerator. If you turn it to the left, the temperature decreases in the freezer and increases in the refrigerator. Quickly return it to the middle position after adjustment to maintain balance.

Note that the freezer temperature cannot be adjusted: it is automatically set to -18 °C or lower. This ensures optimal preservation of your frozen foods.

Question 10

How to use the defrost function of the SEVERIN MW 9722 microwave?

Accepted Answer

The defrost function of the SEVERIN MW 9722 microwave is designed to safely and effectively defrost frozen food. Here’s how to use it:

Steps to use the defrost function:

Place the frozen food in a microwave-safe container.
Select the defrost function on the control panel. This function is usually indicated by the word "Defrost" or a snowflake symbol.
Indicate the weight of the food if the microwave prompts you, so that the defrosting time is adjusted accordingly.
Start the defrosting by pressing the start button.
Monitor and turn the food if necessary during the process to ensure even defrosting.

This function allows you to defrost your food without cooking it, by distributing heat in a controlled manner. Be sure to check the progress to prevent some parts from starting to cook.

User manual SEVERIN : user manuals and guides in PDF

Models SEVERIN most viewed

Browse manuals SEVERIN by appliance type

Recent questions about devices SEVERIN