Q: How to disassemble the telescopic tube of the SEVERIN SC 7173?

The disassembly mechanism of the tube of your SEVERIN SC 7173 vacuum cleaner is generally located at the junction between the tube and the handle. Procedure to follow: Look for a release button or a locking ring at the junction point of the tube and the handle Press the button OR turn the ring counterclockwise Gently pull the tube towards you to disassemble it If the part is stuck, try to clean around the junction area with a damp cloth to remove dust or debris Tip: Refer to pages 1-5 of your PDF manual (assembly/disassembly section) to see the exact diagram of your model. If the tube remains stuck after cleaning, avoid forcing it to prevent damaging the mechanism.

Q: How to separate the top from the bottom of the Severin SC 7177?

According to the manual for the Severin SC 7177, the top and bottom can only be separated during the initial assembly of the device. Once assembled and the two clicks are registered, they are not intended to be disassembled later. However, several parts are easily removable for maintenance : Brush roller - Push the slider on the side to loosen and remove Freshwater tank - Press the release button to detach Dirty water tank - Press the release button to detach Filters (3 pieces) - Accessible after removing the dirty water tank: non-woven filter, lamellar filter, and round filter in the base unit Important: The device must never operate without its filters installed, and the main body should not be immersed in water for safety reasons. For any repairs beyond standard maintenance, please contact customer service.

Q: How to change or replace the batteries of the SEVERIN AH 7912?

Important: according to the manual, the main device should only be opened for battery disposal . Any other opening may void your warranty. Accessing the batteries: The battery compartment is located under the device Open the cover by removing the two access screws The vacuum cleaner contains Ni-MH rechargeable batteries Before using the new device: the first charge should last about 14 hours before use. The manual for this notice does not provide detailed instructions for replacing the batteries themselves. In case of battery issues, please contact Severin Service directly to avoid voiding your warranty.

Question 1

My SEVERIN S'POWER extremXL CY 7085 vacuum cleaner turns on for a few seconds and then turns off. How can I resolve this issue?

Accepted Answer

If your SEVERIN S'POWER extremXL CY 7085 turns off after a few seconds of operation, it is usually due to an integrated protection system that detects an anomaly. Here are the main causes and solutions:

1. Clogged filters (most common cause)

Dirty filters slow down the airflow and activate the protection:

Clean the washable foam by rinsing it under running water, then let it dry for 24 hours at room temperature before reinstalling it
Tap and scrub the slit filter with a soft brush (never put it in the washing machine)
Also clean the outlet filter in the same way

2. Full dust container

Empty the dust container as soon as the MAX indicator is reached. A cluttered container slows down the airflow and causes a safety shutdown.

3. Forbidden objects vacuumed

Make sure you haven't accidentally vacuumed:

Ashes or embers (strictly prohibited)
Broken glass or sharp objects that could obstruct the airflow
Liquids or sticky substances

Quick solution

Start by completely cleaning the double filtration (foam + slit filters) and emptying the container. This resolves the issue in most cases. If the problem persists after these steps, contact SEVERIN customer service via www.severin.com/go/to/8360.

Question 2

Why is my SEVERIN S'Power Nonstop ECO MY 7116 vacuum cleaner not suctioning properly and overheating?

Accepted Answer

If your S'Power Nonstop ECO MY 7116 vacuum cleaner is not suctioning properly and starts to overheat, it is usually due to blocked air circulation. Here are the solutions to apply in order:

1. Empty and clean the tank

Even if the tank appears clean, a buildup of dust reduces suction. Empty it completely before each prolonged use.

2. Clean the filters (critical step)

The vacuum cleaner has a double filtration system: washable motor filter + exhaust filter. Both must be cleaned regularly:

Rinse the filters with lukewarm water
Let them dry for about 24 hours at room temperature (do not put in the washing machine or dishwasher)
Reinstall them completely dry

Clogged filters cause both loss of suction and overheating, as the motor has to work harder.

3. Check for obstructions

Inspect the flexible hose, the switchable brush, and all ducts for blockages of fibers or debris.

4. Let it cool down if the thermal protection has been triggered

If the device stopped suddenly, the built-in overheating protection has activated. Wait 45 minutes before restarting, allowing the motor to cool completely.

If after completely cleaning the filters and emptying the tank the problem persists, there may be an internal obstruction or a mechanical defect requiring servicing.

Question 3

How to install the dust filter of the SEVERIN HV 7155?

Accepted Answer

Here is the procedure to install the dust filter (motor protection filter, reference 2242-048) in your SEVERIN HV 7155:

Before you begin

Make sure the device is completely turned off
Check that the filter is perfectly dry (allow about 24 hours of drying after cleaning)

Installation steps

Turn the vacuum cleaner so that the dust container is facing up
Turn the dust container lid counterclockwise and remove it
Place the motor protection filter in the dust container
Pull the foam cover to position it correctly on the filter
Replace the dust container lid and lock it by turning it clockwise until it clicks into place

Important: The filter must be completely dry before reuse. Never use the device without an installed filter, as this could damage the motor.

Question 4

How to disassemble the telescopic tube of the SEVERIN SC 7173?

Accepted Answer

The disassembly mechanism of the tube of your SEVERIN SC 7173 vacuum cleaner is generally located at the junction between the tube and the handle.

Procedure to follow:

Look for a release button or a locking ring at the junction point of the tube and the handle
Press the button OR turn the ring counterclockwise
Gently pull the tube towards you to disassemble it
If the part is stuck, try to clean around the junction area with a damp cloth to remove dust or debris

Tip: Refer to pages 1-5 of your PDF manual (assembly/disassembly section) to see the exact diagram of your model. If the tube remains stuck after cleaning, avoid forcing it to prevent damaging the mechanism.

Question 5

How to separate the top from the bottom of the Severin SC 7177?

Accepted Answer

According to the manual for the Severin SC 7177, the top and bottom can only be separated during the initial assembly of the device. Once assembled and the two clicks are registered, they are not intended to be disassembled later.

However, several parts are easily removable for maintenance:

Brush roller - Push the slider on the side to loosen and remove
Freshwater tank - Press the release button to detach
Dirty water tank - Press the release button to detach
Filters (3 pieces) - Accessible after removing the dirty water tank: non-woven filter, lamellar filter, and round filter in the base unit

Important: The device must never operate without its filters installed, and the main body should not be immersed in water for safety reasons. For any repairs beyond standard maintenance, please contact customer service.

Question 6

How to change or replace the batteries of the SEVERIN AH 7912?

Accepted Answer

Important: according to the manual, the main device should only be opened for battery disposal. Any other opening may void your warranty.

Accessing the batteries:

The battery compartment is located under the device
Open the cover by removing the two access screws
The vacuum cleaner contains Ni-MH rechargeable batteries

Before using the new device: the first charge should last about 14 hours before use.

The manual for this notice does not provide detailed instructions for replacing the batteries themselves. In case of battery issues, please contact Severin Service directly to avoid voiding your warranty.

Question 7

Where can I buy a new hose for the SEVERIN BR 7953 vacuum cleaner?

Accepted Answer

For the SEVERIN BR 7953 vacuum cleaner, the hose and its fittings are key parts to replace if damaged. The manual states that replacement dust bags are available from SEVERIN Service under reference SB 9083, and HEPA filters under reference SB 9053. For the hose itself, there is no specific reference listed, but you can contact SEVERIN service directly to find out the exact reference for the compatible hose for this model.

Official purchasing channels: SEVERIN Service (the authorized official distributor) offers original parts directly. You can contact them in France to order the hose, ensuring perfect compatibility with your vacuum cleaner and certified quality. Delivery times are generally 5 to 10 working days.

Specialized online retailers: Several platforms offer SEVERIN spare parts, including Spareka, FixPart, Mistervac, and SOS-Accessoire. These sites list compatible hoses for the BR 7953. Repair kits for TubeFix fittings specifically designed for this model are also available at Mistervac. Be sure to check the reference for the BR 7953 model before ordering.

Physical stores: Appliance stores and authorized SEVERIN dealers can order hoses for the BR 7953 if they do not have them in stock. Do not hesitate to ask for the technical sheet of your device to facilitate the order. You can also consult authorized SEVERIN service centers, which generally have all original parts in stock and can ensure replacement if necessary.

Tip: If you need to order urgently, have the serial number or the nameplate of your vacuum cleaner (usually located under the device or at the back of the motor) ready. This will allow the retailer to instantly verify compatibility and expedite your order.

Question 8

How to assemble the SEVERIN S'powers nonstopXL MY 7115 vacuum cleaner?

Accepted Answer

The SEVERIN S'powers nonstopXL MY 7115 is a bagless vacuum cleaner with a maximum power of 700 W and a 2.5-liter tank. Its assembly is simple and takes only a few minutes.

Before you begin: Ensure that the device is completely unplugged from the electrical outlet. Do not install any accessories or parts while the vacuum cleaner is plugged in. All components must be in perfect condition, as damaged nozzles or accessories can scratch surfaces.

Assembly steps:

1. Attach the handle: Align the handle with the designated location on the main body of the vacuum cleaner. Push it firmly until you hear a click, indicating that it is securely locked in place.
2. Install the dust container: Ensure that the 2.5-liter container is clean and dry. Align it with its housing on the body of the device and push it until it clicks into place completely.
3. Connect the hose: Firmly insert one end of the hose into the suction opening of the device and push until it is securely locked in place.
4. Attach the accessories: Depending on your cleaning needs, attach the hard floor brush, carpet brush, or crevice tool to the end of the hose. Ensure that the accessory is securely attached before use.
5. Store the accessories: Unused accessories can be stored in their dedicated compartment on the body of the vacuum cleaner.
6. Check the assembly: Ensure that all parts are securely attached, that the container is properly locked, and that the hose is free of defects. The vacuum cleaner should be stable before use.
7. Plug into electricity: Connect the power cord (6 meters long) to an electrical outlet. Your SEVERIN S'powers nonstopXL MY 7115 is now ready to use.

Usage tip: Once assembled, before your first use, check that the washable HEPA filter is in place and dry. If you need detailed visual guidance, refer to the Illustrated User Guide provided with your vacuum cleaner, which contains step-by-step assembly diagrams.

Question 9

How to clean and maintain the SEVERIN S'powers nonstopXL MY 7115 vacuum cleaner?

Accepted Answer

To ensure optimal operation of your SEVERIN S'powers nonstopXL MY 7115 vacuum cleaner, regular cleaning and proper maintenance are essential. Here are the steps to follow:

1. Safety first

Before any cleaning operation, make sure the vacuum cleaner is turned off and unplugged from the electrical outlet.

2. Empty the dust container

Remove the dust container from the device.
Empty it into a trash can to dispose of the accumulated dirt.
If the container is washable, clean it with warm soapy water, rinse it thoroughly, and let it dry completely before putting it back in place.

3. Clean or replace the filters

Check the filters of your vacuum cleaner (HEPA filter or others).
If the filters are washable, rinse them under cold or warm water without using detergents, then let them dry completely in the air.
If the filters are not washable, replace them according to the manufacturer's recommendations or as soon as they are too dirty.

4. Clean the hose and accessories

Inspect the hose and accessories for any blockages or dirt.
Use a thin, flexible object to dislodge debris if necessary.
Wipe the outer surfaces of the accessories with a damp cloth.

5. Clean the exterior of the vacuum cleaner

Use a damp cloth to wipe the vacuum cleaner's casing and remove dust or marks.

6. Reassembly and storage

Once all parts are dry and clean, reassemble the vacuum cleaner ensuring that each component is securely attached. Store it in a dry place away from dust.

Regular maintenance extends the lifespan of your vacuum cleaner and maintains its suction performance.

User manual SEVERIN Vacuum Cleaner : user manuals and guides in PDF

Models SEVERIN Vacuum Cleaner most viewed

Other categories SEVERIN

Recent questions about Vacuum Cleaner SEVERIN