User manual BEURER Light therapy : 17 free PDF user manuals

Q: Can the light tubes of the BEURER TL90 light therapy lamp be replaced?

Yes, you can replace the fluorescent tube of your BEURER TL90 light therapy lamp . Unlike some devices, the TL90 is designed to allow the replacement of its fluorescent tube, which enables you to extend the lifespan of your device. The only authorized tube for replacement is the fluorescent tube with reference number 163.242 , which must be ordered from the official BEURER customer service. This tube is the specifically adapted spare part to ensure the proper functioning and optimal light performance of your device. The fluorescent tube of the TL90 has an average lifespan of about 10,000 hours of use . When the tube approaches the end of its useful life or if it proves to be defective, the device's indicator will alert you. This is the ideal time to proceed with the replacement. Important: The fluorescent tube contains a small amount of mercury. In case of breakage of the tube at home, some of the mercury may evaporate as vapor. If this happens, immediately open the windows and ventilate the room well to ensure minimal contact with the released mercury vapors. For your information, please note that fluorescent tubes and the starter are not covered by the product warranty. To order the replacement tube or get technical advice, please contact BEURER customer service directly using the contact details provided in your user documentation.

Q: Why does my BEURER TL90 light therapy lamp turn on briefly and then turn off immediately?

If your BEURER TL90 light therapy lamp turns on briefly and then turns off immediately, the problem usually lies with the fluorescent tube or the power supply. Here are the checks to perform in this order: Check the installation of the fluorescent tube - Unplug the lamp from the power outlet. Ensure that the MP 45 3U (45 W) fluorescent tube is properly seated and correctly installed in the sockets at both ends. Make sure the tube is not cracked or damaged, as a defective or misaligned tube can cause immediate shutdown. Plug it back in and test the ignition. Check the power supply - Ensure that the 220-240 V power cable is fully inserted into the power outlet. Test with another electrical outlet to rule out an unstable power issue. Inspect the power cable for any damage, cuts, or excessive bends, as a damaged cable can cause unexpected shutdowns. Check the wear of the fluorescent tube - The fluorescent tubes of the TL90 (reference 163.242) have a limited lifespan. If the lamp has been used for a long time, the tube may have reached the end of its lifespan. Replace the tube by obtaining a tube with reference 163.242 from BEURER customer service. Check normal behavior - The tubes of the TL90 take a few minutes to reach their maximum brightness after being turned on: this is normal and should not be confused with a shutdown. Make sure you are holding the On/Off button down during ignition. If after these checks the lamp continues to turn off immediately, there is probably an internal defect (electrical issue, contactor failure, or ballast failure). Contact BEURER customer service or an authorized dealer for professional diagnosis and repair.

Models BEURER Light therapy most viewed

User manual BEURER Light therapy : user manuals and guides in PDF

Models BEURER Light therapy most viewed

Other categories BEURER

Recent questions about Light therapy BEURER