Question 1

The SET button does not respond during profile setup - how to save selection P1 to P8?

Accepted Answer

According to the manual of the TERRAILLON XLine Fit scale, configuring the profile requires pressing and holding the SET button. If the SET button does not work when saving your profile (P1-P8), here are some solutions to try:

Check your pressing technique

The manual specifies that you need to “press and hold” the SET button, not just press it. Try holding the button down for 2 to 3 seconds to access configuration mode, then hold it again to confirm your profile selection (P1 to P8) before moving on to the gender (standard or athlete mode).

Check the battery status

A weak battery may prevent the buttons from functioning properly. Replace the scale's batteries and restart the profile setup.

Clean the SET button

Moisture or dirt can block the electrical contact. Carefully clean the SET button and its surroundings with a dry cloth, then try again.

Reset the scale

Remove the batteries for 30 seconds, then reinsert them. Restart the profile entry by pressing firmly and holding the SET button as described above.

If the SET button remains non-functional after these steps, there may be an internal contact defect. Contact TERRAILLON customer service for an exchange or repair.

Question 2

How to use the TERRAILLON Power Fit scale to measure weight and body parameters?

Accepted Answer

The TERRAILLON Power Fit scale is a multifunctional device designed to measure not only weight but also several important body parameters. Here’s how to use it correctly:

1. Initial preparation

Insert 3 AAA batteries into the compartment located under the scale, respecting the indicated polarities.
Place the scale on a flat, stable, and hard surface (avoid carpets or uneven floors).

2. User profile setup (to be done during the first use)

Press the SET button to enter setup mode.
Select a user profile from the 12 available.
Enter the requested information: gender, height, age, using the UP and DOWN buttons.
If you are an athlete (over 18 years old), activate athlete mode for more accurate measurements.

3. Daily use

Step onto the scale barefoot, in a stable position.
Wait a few seconds for the scale to perform the measurement.
The results will automatically display and include:

Body weight
Body fat mass
Water mass
Muscle mass
Bone mass
Body mass index (BMI)
Basal metabolic rate

Usage tips

Always use the scale at the same time of day for consistent measurements.
Weigh yourself barefoot to ensure the necessary conductivity for impedance measurements.
Avoid weighing yourself after intense exercise or after eating, for more reliable results.

User manual TERRAILLON Scale : user manuals and guides in PDF

Models TERRAILLON Scale most viewed

Other categories TERRAILLON

Recent questions about Scale TERRAILLON