Question 1

How to fix the lack of sound on my Ground Zero GZUA 1.1000DX?

Accepted Answer

Main Checks

If your Ground Zero GZUA 1.1000DX amplifier produces no sound, check in the following order:

PWR Indicator: Make sure the PWR indicator lights up. If the PROTECTION indicator lights up instead, this indicates a short circuit or an impedance problem. Check that your speakers have an impedance of 1Ω or higher.
Trigger Cable: The remote trigger cable (REMOTE) must be connected to your car radio to activate the amplifier. A disconnected or faulty cable completely prevents startup.
Power +12V and Ground: Check that the +12V power cable is properly connected to the vehicle's battery and that the ground cable is securely attached to a bare and clean ground point on the chassis (maximum length 1 m).

Input Level Adjustment

If the PWR indicator lights up but there is still no sound:

Set the INPUT LEVEL control to zero (minimum position).
Set the volume of your audio source (car radio, phone) to about 2/3 of the maximum.
Gradually increase the INPUT LEVEL control until you hear clear sound without distortion.

Checking Audio Connections

Ensure that the input RCA cables are properly plugged into the amplifier and your car radio. A poorly connected or damaged RCA cable can prevent the audio signal from reaching the amplifier, even if the device is powered on.

Question 2

What is the recommended thickness of the power cable for the Ground Zero GZHA 2350 X car radio?

Accepted Answer

For the installation of the Ground Zero GZHA 2350 X car radio, it is important to use a power cable of an appropriate thickness to ensure reliable and safe power supply.

Recommended thickness of the power cable

It is generally advised to use a power cable with a cross-section of at least 1.5 mm².
This thickness allows for the necessary current to be carried without the risk of overheating or voltage drop, ensuring optimal operation of the car radio.

Additional tips

If the installation requires a longer cable or if the car radio is used with energy-hungry accessories, it may be useful to opt for a slightly larger cross-section (for example, 2.5 mm²) for added safety.
Make sure to use quality cables suitable for automotive use, and properly protect the connections with appropriate fuses.

By following these recommendations, you will ensure a safe installation and the best possible performance of your Ground Zero GZHA 2350 X car radio.

Question 3

What type of fuse to use for the Ground Zero GZHA 2350 X car radio?

Accepted Answer

For the Ground Zero GZHA 2350 X car radio, two levels of protection must be distinguished:

External fuse (on the battery cable): A fuse of 100 to 120 amps must be installed on the positive power cable, as close as possible to the vehicle's battery. This fuse protects the external 16 mm² cable against overloads and short circuits. The 100-120A rating is necessary because this amplifier can draw up to 138A in bridged mode.

Internal fuses: The amplifier contains its own internal fuses (4 x 40A) that protect the internal circuits of the device.

Correct installation of the external fuse:

Install the fuse holder on the positive power cable between the battery and the amplifier, as close to the battery as possible.
Use a quality fuse holder suitable for the 100-120A rating to ensure good contact and avoid risks.
Disconnect the vehicle's battery before any intervention.
Immediately replace a blown fuse with a fuse of the same rating to avoid damaging the amplifier and maintain the safety of the installation.

User manual Ground Zero Car radio : user manuals and guides in PDF

Models Ground Zero Car radio most viewed

Other categories Ground Zero

Recent questions about Car radio Ground Zero