Q: Does the THOMSON TLINK 11 support 4G?

No, the THOMSON TLINK 11 does not support 4G. This phone operates exclusively on 2G (GSM) on frequency bands 850 MHz, 900 MHz, 1,800 MHz, and 1,900 MHz. The TLINK 11 is designed for voice calls and SMS only. It does not have the necessary capabilities to operate on 3G, 4G/LTE, or newer generation networks. This device does not support mobile internet browsing or mobile data. However, you can connect to the internet via Bluetooth by pairing it with another device, or by using a wired connection through the Micro-USB port.

Q: Why is the remote control for the THOMSON THC385 home cinema not working?

Before considering a replacement, first test these points: Essential Checks Worn Batteries - Open the back compartment of the remote and replace the batteries (usually 2 AA batteries) making sure to observe the polarity (+ and - must match the markings on the remote) Cleaning the Contacts - Remove the batteries and clean the gold contacts in the compartment with a dry cloth Infrared Diode Test - Point the remote at your phone's camera lens and press any button. You should see a small infrared light blinking (invisible to the naked eye). If nothing appears, the remote may be defective Distance and Orientation - Ensure you are pointing directly at the infrared sensor of the THC385 (located on the front panel) from a distance of less than 8-10 meters Device Sensor - If the diode works but nothing happens, the sensor of the THC385 may be faulty. Test the physical buttons on the device (Play, Stop, Power) on the front panel to check if the device responds Manual Control in Case of Failure The THC385 has direct control buttons on the front panel (Standby/On, Open/Close, Play, Stop) that work independently of the remote. You can continue to use the device with these physical controls. If the remote is permanently out of service, a compatible replacement remote for the THOMSON THC385 can be ordered from an authorized spare parts dealer.

Q: How to download the PDF manual for the THOMSON ROC 36 remote control?

To download the PDF manual for the THOMSON ROC 36 remote control , click on the "⬇ Download" button located at the top of this page, next to the viewing options and questions. The PDF file will then appear for direct download, completely free of charge. This manual covers the 18 buttons of the remote control, the five programming methods (A to E), the volume control setup in satellite mode, as well as troubleshooting procedures. Note: If you prefer to view the manual directly on the site, you can use the integrated reader with zoom, rotation, and full-screen display options.

Q: Where is the water sensor located on the THOMSON THRAF580E air conditioner?

The water sensor is located in the removable water tank , at the back of the unit. It is component number 5 in the device description. The tank has a water level indicator with reference lines indicating the minimum and maximum points . You must keep the water between these two marks for optimal operation. Operation of the sensor: When the water level drops below the minimum level indicated on the tank, the device emits a continuous beep for a few seconds to alert you. After this alert, the cooling mode automatically stops. A safety cut-off (component number 7) also disables the device if the tank is removed or insufficiently filled. The tank has a capacity of 8 liters , allowing for prolonged use before refilling.

Q: What are the dimensions of the door and decorative panel of the THOMSON THBIDW45DFULLSLID dishwasher?

The built-in THOMSON THBIDW45DFULLSLID dishwasher is a full slide model that installs completely behind a custom decorative panel. Dimensions of the dishwasher: Height: 82 cm Width: 45 cm Depth: 55 cm Decorative panel: The panel must be measured according to the dimensions illustrated in the manual (corresponding to the height and depth of the product). The maximum weight of the panel must not exceed 8 kg . Important space: Allow a minimum of 50 mm of free space between the edge of the dishwasher door and the walls to ensure comfortable opening. For complete installation, refer to the integration diagrams provided in the technical section of your manual.

Question 1

How do I change the source or input on my THOMSON 32FS3246C TV?

Accepted Answer

To change the input source on your THOMSON 32FS3246C TV:

Press the Source button on your remote control (it may also be labeled 'Input' or display an icon).
A menu of available inputs will appear on the screen.
Use the up/down arrow buttons to select the desired input.
Press OK or Enter to confirm your selection.

Your THOMSON 32FS3246C TV has the following inputs:

HDMI - for Blu-ray players, set-top boxes, game consoles
AV/Composite - yellow/white/red RCA input
VGA - for computer connection
USB - for playing USB files

You can also access the source selection via the TV's home menu (Menu button).

Question 2

How to order a replacement stylus for the THOMSON TT200 turntable?

Accepted Answer

For the THOMSON TT200 turntable, the compatible stylus is the ST05D (sapphire stylus). This is the exact reference you need to look for to order a replacement stylus.

You can obtain this spare part through the following channels:

Contact Bigben Interactive (the official importer) directly by email: support@thomsonaudiovideo.eu
Call the non-premium rate number: 09 69 32 59 62

The TT200 uses a standard MM (Moving Magnet) cartridge with universal mounting, making stylus replacement simple for most users. Once the stylus is received, just gently lift the old stylus from the cartridge and click the new one in place.

Question 3

Does the THOMSON TLINK 11 support 4G?

Accepted Answer

No, the THOMSON TLINK 11 does not support 4G. This phone operates exclusively on 2G (GSM) on frequency bands 850 MHz, 900 MHz, 1,800 MHz, and 1,900 MHz.

The TLINK 11 is designed for voice calls and SMS only. It does not have the necessary capabilities to operate on 3G, 4G/LTE, or newer generation networks. This device does not support mobile internet browsing or mobile data.

However, you can connect to the internet via Bluetooth by pairing it with another device, or by using a wired connection through the Micro-USB port.

Question 4

Why is the remote control for the THOMSON THC385 home cinema not working?

Accepted Answer

Before considering a replacement, first test these points:

Essential Checks

Worn Batteries - Open the back compartment of the remote and replace the batteries (usually 2 AA batteries) making sure to observe the polarity (+ and - must match the markings on the remote)
Cleaning the Contacts - Remove the batteries and clean the gold contacts in the compartment with a dry cloth
Infrared Diode Test - Point the remote at your phone's camera lens and press any button. You should see a small infrared light blinking (invisible to the naked eye). If nothing appears, the remote may be defective
Distance and Orientation - Ensure you are pointing directly at the infrared sensor of the THC385 (located on the front panel) from a distance of less than 8-10 meters
Device Sensor - If the diode works but nothing happens, the sensor of the THC385 may be faulty. Test the physical buttons on the device (Play, Stop, Power) on the front panel to check if the device responds

Manual Control in Case of Failure

The THC385 has direct control buttons on the front panel (Standby/On, Open/Close, Play, Stop) that work independently of the remote. You can continue to use the device with these physical controls.

If the remote is permanently out of service, a compatible replacement remote for the THOMSON THC385 can be ordered from an authorized spare parts dealer.

Question 5

How to download the PDF manual for the THOMSON ROC 36 remote control?

Accepted Answer

To download the PDF manual for the THOMSON ROC 36 remote control, click on the "⬇ Download" button located at the top of this page, next to the viewing options and questions.

The PDF file will then appear for direct download, completely free of charge. This manual covers the 18 buttons of the remote control, the five programming methods (A to E), the volume control setup in satellite mode, as well as troubleshooting procedures.

Note: If you prefer to view the manual directly on the site, you can use the integrated reader with zoom, rotation, and full-screen display options.

Question 6

Where is the water sensor located on the THOMSON THRAF580E air conditioner?

Accepted Answer

The water sensor is located in the removable water tank, at the back of the unit. It is component number 5 in the device description.

The tank has a water level indicator with reference lines indicating the minimum and maximum points. You must keep the water between these two marks for optimal operation.

Operation of the sensor:

When the water level drops below the minimum level indicated on the tank, the device emits a continuous beep for a few seconds to alert you.
After this alert, the cooling mode automatically stops.
A safety cut-off (component number 7) also disables the device if the tank is removed or insufficiently filled.

The tank has a capacity of 8 liters, allowing for prolonged use before refilling.

Question 7

Why does the refresh button turn off after a few seconds on the THOMSON THRAF580E?

Accepted Answer

The RAFR (refresh) button automatically stops generally because the water level in the tank has fallen below the minimum.

According to the THOMSON THRAF580E manual, when you press the RAFR button, the water pump starts working to humidify the evaporator filter. However, this device has an important safety feature: when the water level drops below the minimum, the device emits a continuous beep for a few seconds and the refresh mode stops automatically.

Although you have tested that the pump is working, this does not necessarily mean that the water level is correct. Check the following points:

Fill the tank to the brim - The removable tank has a capacity of 8 liters and has marker lines indicating the minimum and maximum levels. The water sensor located in the tank automatically detects when you are below the minimum.
Wait 2 minutes after stopping - Before removing the tank, wait 2 minutes to allow the water in the circuit to settle down.
Use cold or demineralized water - Fill with cold tap water or demineralized water, without exceeding the maximum.
Check that the tank is properly in place - If the tank is removed or improperly inserted, a safety cut-off disables the device.

If the tank is full to the maximum, properly in place, and the button still stops after a few seconds, the problem may come from the water sensor (faulty) rather than the operation of the pump itself.

Question 8

Do I need to insert a CD or DVD to start the Thomson THC385?

Accepted Answer

No, you do not need a CD or DVD to start the Thomson THC385. The device can start and operate without inserting a disc.

How to start your home theater:

Plug the device into a 220V outlet
Press the STANDBY/ON button located on the front of the player
The home theater logo will appear on your television
You can access the SETUP menu to configure the device

CDs, DVDs, or VCDs are only necessary if you want to play content. Once the device is started, you can:

Press OPEN/CLOSE to open the disc tray
Insert your disc (DVD, VCD, audio CD, or MP3/MP4/JPEG files)
Press ENTER/PLAY to start playback

Your Thomson THC385 natively supports several audio and video formats and has a 5.1 channel setup with a power of 100W.

Question 9

What are the dimensions of the door and decorative panel of the THOMSON THBIDW45DFULLSLID dishwasher?

Accepted Answer

The built-in THOMSON THBIDW45DFULLSLID dishwasher is a full slide model that installs completely behind a custom decorative panel.

Dimensions of the dishwasher:

Height: 82 cm
Width: 45 cm
Depth: 55 cm

Decorative panel:

The panel must be measured according to the dimensions illustrated in the manual (corresponding to the height and depth of the product). The maximum weight of the panel must not exceed 8 kg.

Important space: Allow a minimum of 50 mm of free space between the edge of the dishwasher door and the walls to ensure comfortable opening.

For complete installation, refer to the integration diagrams provided in the technical section of your manual.

Question 10

How to set the time on the THOMSON CP280?

Accepted Answer

Here’s how to set the time on your THOMSON CP280 clock radio:

Step 1: Make sure the radio is turned off
Step 2: Press the MEMORY button (button 4) until the display shows 0:00 blinking
Step 3: Press the HOUR button (button 3) to adjust the hours
Step 4: Press the MINUTE button (button 5) to adjust the minutes
Step 5: Press MEMORY again to confirm and save the setting

Once confirmed, your time settings will be memorized and retained thanks to the built-in backup battery (CR2025).

User manual THOMSON : user manuals and guides in PDF

Models THOMSON most viewed

Browse manuals THOMSON by appliance type

Recent questions about devices THOMSON