How to replace the spool head on the AL-KO GT 2025 brush cutter?

Question

Accepted Answer

Replacing the spool head on the AL-KO GT 2025 brush cutter is a simple operation that helps maintain the efficiency of your tool. Here are the steps to follow:

1. Preparation

Make sure the brush cutter is turned off and unplugged from any power source to avoid any risk of accident.

2. Removing the old spool head

Locate the locking system of the spool head, usually located under the head.
Press the button or unlocking mechanism and turn the head counterclockwise to unscrew it.
Carefully remove the worn head.

3. Preparing the new head

Ensure that the new head is compatible with the GT 2025 model.
If necessary, thread the spool of line into the new head according to the manufacturer's specific instructions.

4. Installing the new head

Position the new head on the shaft.
Turn it clockwise until it is securely fastened.
Make sure the head is firmly locked in place.

5. Final check

Before turning the device back on, check that the head is correctly installed and that the line is properly positioned and free to move.

By following these steps, you ensure a safe and effective replacement of the spool head on your AL-KO GT 2025 brush cutter.

User manual AL-KO String Trimmer : user manuals and guides in PDF

Models AL-KO String Trimmer most viewed

Other categories AL-KO

Recent questions about String Trimmer AL-KO