How to change the blade of the AEG ST 400 jigsaw?

Q: How to change the blade of the AEG ST 400 jigsaw?

Before you begin , always unplug the AEG ST 400 jigsaw from the power outlet. This step is essential for your safety. Blade changing procedure: Push the transparent cover down to more easily access the locking screw Loosen the locking screw by about 2 turns using the hex key provided with your machine (it is attached at the base) Place the saw blade in the slot of the support roller, then push the blade firmly into the slide until it reaches the stop (the end of the slide) Check that the two shoulders of the blade (the small protrusions on the sides) are in contact with the collar of the slide - this is essential for proper fixation Tighten the locking screw completely Check the positioning of the blade by pulling slightly on it (wear protective gloves) to ensure that it does not move at all Important recommendations: Only use standard jigsaw blades compatible with the ST 400 model. Check that the blade is not cracked or warped before installing it. Your ST 400 has a power of 400 W and can cut up to 60 mm of softwood - make sure your saw blade is suitable for the thickness of the material you will be cutting.

Question

Accepted Answer

Before you begin, always unplug the AEG ST 400 jigsaw from the power outlet. This step is essential for your safety.

Blade changing procedure:

Push the transparent cover down to more easily access the locking screw
Loosen the locking screw by about 2 turns using the hex key provided with your machine (it is attached at the base)
Place the saw blade in the slot of the support roller, then push the blade firmly into the slide until it reaches the stop (the end of the slide)
Check that the two shoulders of the blade (the small protrusions on the sides) are in contact with the collar of the slide - this is essential for proper fixation
Tighten the locking screw completely
Check the positioning of the blade by pulling slightly on it (wear protective gloves) to ensure that it does not move at all

Important recommendations: Only use standard jigsaw blades compatible with the ST 400 model. Check that the blade is not cracked or warped before installing it. Your ST 400 has a power of 400 W and can cut up to 60 mm of softwood - make sure your saw blade is suitable for the thickness of the material you will be cutting.

User manual AEG Jigsaw : user manuals and guides in PDF

Models AEG Jigsaw most viewed

Other categories AEG

Recent questions about Jigsaw AEG