MFR-12 - Deep fryer MPM - Free user manual and instructions

USER MANUAL MFR-12 MPM

EN We wish you satisfaction from using the product and invite you to check a wide range of other MPM appliances

Black MDM air fryer with control knob and side door (no visible text or symbols)

cz NAVOD K OBSLUZE 3

Timer - time adjustment from 1 to 60 minutes Basket and tray covered with non-stick coating Removable basket capacity 2 L Operation and signal

BEZPEČNOSTNÍ POKYNY PŘI POUŽÍVÁNÍ

Read the instructions carefully before use.

Take special care when children are near the device.

Do not leave the device unattended during operation!

Do not use the device for purposes other than those for which it was intended.

Do not immerse the device, cable or charger in water or other liquids.

Always remove the plug from the mains socket when the device is not in use or before cleaning.

Use of accessories not recommended by the manufacturer may cause damage to the device or personal injury.

If the device starts producing abnormal sounds or odour, or if smoke comes out of it, switch it off immediately and contact an authorized service to have it repaired.

Do not use the device outdoors.

Do not hang the mains cable on sharp edges or allow it to come into contact with hot surfaces.

Make sure the mains cable is not extending over the edge of the device's support surface. This will prevent the device from being accidentally pulled down.

Do not touch any hot surfaces. Use holders when moving this product.

- Store the device in cool, dark and dry place.

Avoid deformation of plastic parts, do not wash the device and accessories with hot water or in a washing machine.

Do not put hands or any items inside the € container during operation.

Before cleaning, disconnect the unit from the power supply first.

Clean the device, in particular parts being in direct contact with food, before first use, immediately after finishing work and if the device has not been used for a long time. The procedure is described in details in the “CLEANING AND MAINTENANCE” section.

Do not place the device near other electric cookers, burners, ovens, etc.

Always ensure that all parts of the device are correctly fitted before starting work.

Wait for the device to cool down completely after frying before attaching or removing its elements, as well as cleaning the device.

During hot air frying, hot steam escapes through the air vents.

Keep your hands and face away from the escaping steam or air outlets. Pay attention to the steam and air when removing the bowl with the basket from the device.

Do not cover the air inlets and outlets when the device is operating.

Do not place the device near flammable materials such as curtains, tablecloths etc., because this may lead to a fire.

Food intended for frying should always be placed into the basket.

Do not fill the bowl with oil as this may cause a fire.

Device is suitable for home use solely. To-prevent deformation of the housing and lid, never use the device continuously for a long period of time.

Damaged plug or power cord must be replaced by the manufacturer, its service centre or another suitably qualified person in order to avoid any risk.

The surface temperature may increase during use.

The device should be connected to a mains socket outlet with a grounding pin! Before switching the device on, make sure the mains parameters match the values on the device's identification plate.

It is recommended to use protective gloves intended for handling this type of equipment.

This equipment may be used by children of at least 8 years of age and by persons of diminished physical, mental capacity and lack of experience and knowledge of the equipment if supervision or instruction is provided regarding the safe use

of the equipment so that the hazards involved are understood. Cleaning and maintenance must not be performed by children, unless they are over 8 years old and supervised by an adult. Unsupervised children can not perform cleaning and maintenance of the product.

Children should be supervised to ensure that they do not play with the equipment/device.

The device has not been designed to operate with an external timer switch or a separate remote control system.

Keep the device and its cord out of reach of children under 8 years of age.

Do not connect the plug to the power socket with wet hands.

Do not pull the plug out of the power socket by pulling the cord.

Use the device on a smooth and stable surface.

Do not place the device directly against a wall or other devices. Leave at least 10 cm of free space at the back and upper parts of the device, as well as on its both sides. Do not place any objects on the device.

For the safety of children, please do not leave freely accessible parts of the packaging (plastic bags, cardboard boxes, polystyrene, etc.).

WARNING! Do not allow children to play with the film. Danger of suffocation!

WARNING! Overheated fat may ignite. Be especially careful!

CAUTION! Hot surface! The symbol placed on the appliance indicates that its components may become hot during operation.

DESCRIPTION OF THE APPLIANCE

1. Holder 4. Time dial (0-60 min.)
2. Baking container - 2.0l
3. Vent
4. Grate grill
5. Mains cable

A multifunctional appliance for oil-less frying, grilling, stewing and baking thanks to its unique design. Fitfryer can prepare dishes using hot air circulation, thanks to which the dishes are crispy on the outside and delicate on the inside. No need to add oil to most ingredients.

BEFORE FIRST USE

1. Unpack the appliance from the packaging. Remove any bags, shipping locks, fillers and labels.
2. Make sure the appliance has not been damaged during its transportation. In case of suspected damage, do not start the appliance and consult the seller
3. Make sure the electrical mains parameters match the data on the appliance's name plate.
4. Wash the appliance following the instructions in the "CLEANING AND MAINTENANCE" section
5. Place the appliance on a hard, dry, stable, flat and horizontal surface.

USING THE APPLIANCE

CAUTION! A small amount of smoke may come out of the appliance during the first use. This is normal.

CAUTION! The appliance is protected against improper use; the appliance will not turn on without a properly installed baking container (2).

1. Check that the grill grate (3) is inserted into the fryer container (2). If not - slide the grill grate into place so that it is positioned horizontally at the bottom of the cooking container (2).
2. Connect the appliance to the grounded mains.
3. Slide out the baking container (2) by pulling the handle (1).
4. Put products into the container (2).

CAUTION! Do not fill the baking container (2) above the "MAX" mark or exceed the maximum amount of ingredients given in the table (see: "COOKING - TIPS" section).

1. Slide the baking container (2) back into the Fitfryer by holding the handle (1).

CAUTION! Do not touch the baking container (2) during the operation of the appliance and shortly after it has been completed, as the container heats up to a very high temperature.

1. To start the fryer, set the cooking time with the time dial (4).
2. The appliance will turn off automatically when the set time comes to an end. The end of the operation will be signalled by the chime of the clock. The operation of the appliance can be terminated at any time by turning the time dial (4) to the "O" position.
3. Slide out the baking container (2) by pulling the handle (1) and check if the ingredients are ready. If the ingredients are not ready yet, slide the container back into the Fitfryer, holding it by the handle, and then set an additional time.
4. After the operation is finished, the appliance should be disconnected from the power source.

COOKING - TIPS

The range of dishes one can prepare with the appliance is vast; for choosing the correct weight of food and the optimal baking time, please refer to the table below.

However, due to differences in shape, size, structure of food products, the data provided in the table should be treated as indicative information that will facilitate starting work with the appliance. Over time, the user will probably work out their preferable time settings for the dishes of their choice. Some dishes require shaking (mixing) halfway through the baking time. The baking container (2) must then be pulled out, this will stop the operation of the appliance but the running time will continue to count down. The baking program will resume when the baking container (2) is inserted again.

CAUTION! Risk of burns from fumes, hot fat and hot parts of the appliance. Be especially careful when removing the basket (2) from the working appliance.

Exceeding the optimal amount of food products may prevent proper air circulation in the appliance and significantly affect the final result – the top layer will be too baked, while the centre will remain raw.

Groceries	Icon	Weight (g)	Temperature (°C)	Time (min.)
Chicken legs 100-300 200 15-
Steak		100-300 200 10-15
Fish		100-300 200 15-20
Fries		100-400 200 15-20
Cake		400	200	20-30
Prawns		100-300 200 15-20

If the appliance is not preheated, 3 minutes should be added to the baking time given in the table.

For best results, use pre-cooked (e.g. frozen) French fries. To fry homemade fries, follow the steps below.

1. Peel the potatoes and cut them into sticks.
2. Soak the fries in a bowl with water for at least 30 minutes, remove and dry on a paper towel.
3. Pour 1/2 tablespoon of olive oil into a bowl, then put the fries in it and mix until they are coated with it.
4. Remove the fries with your fingers or a suitable kitchen utensil so that the excess oil remains in the bowl. Put them into the container.

CAUTION! Do not pour all the fries from the bowl into the container at once, so that the oil does not flow to the bottom of the vessel.

1. Fry according to the instructions.

CLEANING AND MAINTENANCE

1. Before cleaning, remove the plug from the power socket and wait until the appliance cools down completely.
2. Slide out the baking container so that the appliance cools down more quickly.

CAUTION! The baking container, the grate grille and the inside of the appliance are coated with a non-stick coating. Do not clean them with metal kitchen utensils or abra - sive cleaners as this may damage the coating.

1. Wipe the housing of the appliance with a damp cloth. The housing should never neither be immersed in water or any other liquid nor washed in the dishwasher.
2. Wash the baking container and the grate grill with warm water with addition of mild detergent. Rinse and dry thoroughly. Do not use wire cloths or abrasive cleaners to clean the case.
3. Clean the inside of the appliance with hot water and a delicate, non-abrasive sponge.
4. Clean the heating element with a cleaning brush to remove any dirt.
5. After cleaning and drying, the appliance should be folded and stored in a safe place.

CAUTION! If dirt has stuck to the bottom of the container and grill grate, fill the container with hot water and a small amount of washing up liquid. Insert the grate grille into the container and leave them soaked for about 10 minutes.

PROBLEM SOLVING

The table below describes the most common problems that may be encountered when using the appliance.

Problem Possible cause Solution
The ingredients fry unevenly in the Fitfryer.	Some ingredients should be shaken halfway through the preparation time.	Ingredients placed on top of each other or across each other (e.g. French fries) should be shaken halfway through the preparation time.
Fried snacks are not fragile when removed from Fitfryer.	Snacks intended for preparation in a traditional deep fat frying appliance were used.	Use snacks to be prepared in Fitfryer or cover snacks with a thin layer of oil to ensure their tenderness.
The container cannot be inserted into the appliance correctly.	There are too many ingredients in the container.	Do not fill the container above the MAX level.
	The baking container is not positioned correctly in the appliance.	Insert the container into the appliance until a “click” is heard.
White smoke comes out of the appliance.	The ingredients being prepared are fatty.	Large amount of fat leaks into the container during frying fatty ingredients in Fitfryer. This fat emits white smoke and the container may heat up more than usual. This neither affect the appliance nor the final cooking result.
	The bowl contains fat from previous cooking.	Large amount of fat leaks into the container during frying fatty ingredients in Fitfryer. This fat emits white smoke and the bowl may heat up more than usual. This neither affect the appliance nor the final cooking result.
Fresh fries fry unevenly in Fitfryer.	The potato pieces were not properly soaked before frying.	Soak them in a bowl with water for at least 30 minutes, remove and dry on a paper towel.
	Wrong type of potatoes used.	Use fresh potatoes and check that they do not “fall apart” during frying.
Fresh fries are not crispy after being prepared in Fitfryer.	The tenderness of the fries depends on the amount of oil and water in them.	Dry the prepared potato pieces thoroughly before adding the oil.
		Prepare smaller pieces of potatoes to make them crispier.
		Add a little more olive oil to make the fries crispier.

TECHNICAL DATA

Model MFR-12
Power supply 220-240V ~ 50/60HZ
Power 800W
Availability of the shutdown and standby mode available
Power consumption in standby mode 0,38 W
Power consumption in the shutdown mode -
Power consumption in network standby mode	0,71 W
Automatically goes into standby mode after -
Automatically goes into the shutdown mode after 15 min
Network standby mode, if the device has a connection function with the appli cation	-
Length of mains cable 0.8 m

CE

CAUTION! MPM agd S.A. reserves the right to technical changes!

Proper disposal of the product (waste electrical and electronic equipment)

Marking on the product indicates that after the service-life of the product expires, it should not be disposed with other type of municipal waste. Used equipment may have a negative impact on the environment and health of people due to potentially containing hazardous substances, mixtures and components. Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may cause a release of substances that are hazardous to the environment and health.

Used equipment should be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the electric waste collection points, the user should contact the municipal point of electric waste collection or used equipment processing department.

BESCHRIJVING VAN HET APPARAAT