BV5724 - Blender SOLAC - Free user manual and instructions

USER MANUAL BV5724 SOLAC

MOD. BV5724 Solac is a registered Trade Mark

• Read these instructions care- fully before switching on the appliance and keep them for future reference. Failure to fol- low and observe these instruc- tions could lead to an accident.

• Clean all the parts of the prod- uct that will be in contact with food, as indicated in the clean- ing section, before use.

• This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.

• This appliance can be used by people with reduced physical, sensory or mental capabili- ties or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appli- ance in a safe way and under- stand the hazards involved.

• This appliance is not a toy. Children should be supervised to ensure that they do not play with the appliance.

• Be careful if hot liquid is poured into the food processor or blender as it can be ejected out of the appliance due to a sud- den steaming.

• Blades are sharp and could cause harm, be careful and avoid direct contact with the blades’ cutting edges.

• Pay special attention when handling the blades, during as- sembly and disassembly oper- ations, emptying the bowl and during cleaning.

• Always switch off the appliance and disconnect from supply if it is left unattended and be- fore changing accessories or approaching parts that move in use, assembling, disassem- bling and cleaning.

• If the connection to the mains has been damaged, it must be replaced, take the appliance to an authorised technical sup- port service. Do not attempt to disassemble or repair the ap- pliance by yourself in order to avoid a hazard.

• This appliance is for household use only, not professional, in- dustrial use.EN

• Ensure that the voltage indicated on the rating label matches the mains voltage before plug- ging in the appliance.

• Connect the appliance to a socket that can supply a minimum of 10 amperes.

• The appliance’s plug must t into the mains socket properly. Do not alter the plug. Do not use plug adaptors.

• The appliance must be used and placed on a at, stable surface.

• Do not use the appliance if the cable or plug is damaged.

• If any of the appliance casings breaks, immedi- ately disconnect the appliance from the mains to prevent the possibility of an electric shock.

• Do not use the appliance if it has fallen on the oor, if there are visible signs of damage or if it has a leak.

• Do not force the power cord. Never use the power cord to lift up, carry or unplug the ap- pliance.

• Do not clip or crease the power cord.

• Check the state of the power cord. Damaged or tangled cables increase the risk of electric shock.

• Do not leave the appliance out in the rain or exposed to moisture. If water gets into the ap- pliance, this will increase the risk of electric shock.

• Do not touch the plug with wet hands.

• Take the necessary measures to avoid starting the appliance involuntarily.

• Before using the appliance ensure that the blade is properly xed in place.

• Do not touch any of the appliance’s moving parts while it is operating.

• Exercise precaution after employing the stop operation on the appliance as the blade/s will continue moving from the effect of its own me- chanical inertia. USE AND CARE:

• Fully unroll the appliance’s power cable before each use.

• Do not use the appliance if its accessories are not properly tted.

• Do not use the appliance if the accessories attached to it are defective. Replace them im- mediately.

• Do not use the appliance while the jug is empty.

• Do not use the appliance if the on/off switch does not work.

• Do not move the appliance while in use.

• Do not use the appliance if it is tipped up and do not turn it over.

• Do not turn the appliance over while it is in use or connected to the mains.

• Do not force the appliance’s work capacity.

• Respect the MAX level indicator.

• When using hot liquids do not ll the jug more than half way. At all times, when mixing hot liq- uids in the jug, select the slowest speed on the speed selector.

• Store this appliance out of reach of children and/or persons with physical, sensory or re- duced mental or lack of experience and knowl- edge.

• NEVER pour hot or boiling food into the jug, it may cause burns during the process. Abrupt temperature contrasts could also break the jar.

• Use the appliance and its accessories and tools in accordance with these instructions, taking into account the working conditions and the work to be performed. Use the appliance for operations different from those intended could result in a hazardous situation.

• Never use liquids that are boiling or ingredients whose temperature exceeds 80ºC.

• Check that the lid is closed properly before starting the appliance.

• Never leave the appliance unattended while in use.

• Never leave the appliance connected and un- attended if is not in use. This saves energy and prolongs the life of the appliance.

• Do not use the appliance for more than 2 min- utes at a time. In case of operate in cycles; al- low the appliance a resting period of at least 30 seconds between each cycle. Under no cir- cumstances should the appliance be operated for more time than necessary.

• To crush ice, do not introduce more than 10 cubes at a time. To add more ice, remove the measuring cup and insert the cubes one by one.

• Do not use the appliance with frozen goods or those containing bones.

• CAUTION: Do not use the appliance if the glass is cracked or broken.SERVICE:

• Any misuse or failure to follow the instructions for use renders the guarantee and the manu- facturer’s liability null and void. DESCRIPTION A Measuring cup B Jar Lid C Jar D Motor body E Blades set F Speed selector G Juice Filter H Cable winder If the model of your appliance does not have the accessories described above, they can also be bought separately from the Technical Assistance Service.

• Make sure that all products’ packaging has been removed.

• Before using the product for the rst time, clean the parts that will come into contact with food in the manner described in the cleaning section. ASSEMBLING THE JUG AND THE FILTER:

• Fit the jug onto the main body. To do so, po- sition the jar (C) over the body (B) so that the protrusions from the jug align with the grooves of the body.

• Turn the jug clockwise until it ts snugly (Fig.1).

• Be sure to t the jug onto the body correctly otherwise it will not switch on.

• If you would like to use the blender as a juicer, place the lter (G) around the blade (E) (Fig. 2) USE:

• Unroll the cable completely before plugging it in.

• Ensure the blade xing ring is xed properly to the jar (by turning counter clockwise) before putting on the motor body. (Fig.3).

• Place the jar onto to the motor unit; turn clock- wise until the lock clicks into place. (Fig.1).

• Put the ingredients, after having rst chopped them into small piece, into the jar with liquid (do not exceed the maximum marker).

• Put the lid on the jar; make sure it is properly xed in place.

• Put the measuring cup in the lid (Fig. 1)

• Connect the appliance to the mains.

• Choose desired speed and start blending.

• Speed P (position for turbo) Hold it in this po- sition for as long as you want the appliance to continue operating (maximum of 2 minute of continuous operation).

• During operation hold the lid on rmly using both hands

• If you wish to add more ingredients pull out the measuring cup.

• Add the ingredients and replace the measuring cup.

• Never remove the lid while the appliance is operating.

• To stop the appliance set the speed back to “0”.

• To avoid a erce, start up of the fan, it is advis- able to start off from the lowest speed position and, once the fan has been switched on, pro- gressively increase the speed to the desired position. ELECTRONIC SPEED CONTROL:

• The speed of the appliance can be regulated by using the speed regulator control (F). This function is very useful, as it makes it possible to adapt the speed of the appliance to the type of work that needs to be done.

• Stop the appliance, selecting position 0 on the selector control.

• Unplug the appliance from the mains.

• Turn the mixing jar anticlockwise and remove it from the motor body.

• Clean the appliance. “TURBO” FUNCTION

• The appliance works in highest speed to achieve optimal performance.

• Select the speed P and hold this position for as long as need. No more than 2 minutes at a time. FILTER OPERATION PRECAUTIONS:

• Never use the lter to process ingredients thaåt are hotter than 80ºC.

• Never overload the lter. ENGLISH EN• Before switching on the appliance, always make sure that the lid is correctly tted/closed and that the measuring beaker is in well insert- ed into the lid.

• Cut fruit into small pieces before putting it into the lter.

• Soak dry ingredients, such as legumes or soy beans, before putting them into the lter. USE:

• The lter prevents fruit skin and pips from mix- ing with the drink.

• Once the jar (C) is tted correctly onto the mo- tor body (A) (Fig. 1).

• Place the filter (G) around the blade (D) (Fig. 2).

• Make sure that the slots on the lter t perfectly into the spigots on the blender jug.

• Place the lid on the jug.

• PLEASE NOTE: Be sure to put the lid on the jug so that the drink is served through the lter in the lid.

• Cut fruit into small pieces or soak dry ingredi- ents before putting them into the lter.

• Place the ingredients in the lter and pour wa- ter or other liquid into the jug through the hole in the lid.

• Insert the measuring beaker into the lid (Fig. 1).

• Connect the appliance to the mains.

• Choose the desired speed and start blending.

• NOTE: When processing large quantities, it is advisable not to put all of the ingredients into the lter at the same time. Start with a small amount and let the appliance run for a few seconds. Then switch off the appliance and add another small amount, without lling be- yond the top of the sieve mesh. Repeat this procedure until all the ingredients have been processed. Always leave the blender jug lid on while it is operating. ONCE YOU HAVE FINISHED USING THE FILTER:

• Switch the appliance off and remove the jug from the motor body.

• Serve the drink through the spout on the jug, without removing the lid, measuring beaker or lter. Be sure to put the lid on the jug so that the drink is served through the lter in the lid.

• Clean lter immediately after using it. CLEANING

• Disconnect the appliance from the mains and allow it to cool before undertaking any clean- ing task.

• Clean the equipment with a damp cloth with a few drops of washing-up liquid and then dry.

• Do not use solvents, or products with an acid or base pH such as bleach, or abrasive prod- ucts, for cleaning the appliance.

• Do not let water or any other liquid get into the air vents to avoid damage to the inner parts of the appliance.

• Never submerge the appliance in water or any other liquid or place it under running water.

• During the cleaning process, take special care with the blades, as they are very sharp.

• It is advisable to clean the appliance regularly and remove any food remains.

• The following pieces may be washed in a dishwasher (using a soft cleaning program): - Jug (without its blades). - Removable lter. - Lid. - Measuring cup.

• The draining/drying position of the articles washable in the dishwasher or in the sink must allow the water to drain away easily.

• Then dry all parts before its assembly and storage. SELF-CLEANING FUNCTION:

• Put water and a small amount of washing up liquid in the jar.

• Loosen the blade xing ring by turning it in clockwise direction. (Fig.3).

• Remove the blade xing ring, blade set, seal- ing ring and clean them.

• After cleaning, replace the blade set and turn blade xing ring in opposite direction.

ANOMALIES AND REPAIR

• Take the appliance to an authorised technical support service if product is damaged or other problems arise. Do not attempt to disassemble or repair the appliance yourself as this may be dangerous. ENFOR EU PRODUCT VERSIONS AND/OR IN CASE THAT IT IS REQUESTED IN YOUR COUNTRY:

• The materials of which the packaging of this appliance consists are included in a collection, classication and recycling system. Should you wish to dispose of them, use the appropriate public recycling bins for each type of material.

.(Fig. 1) ⋅.(Fig. 2) (DG

ASSISTANCE This product enjoys the recognition and protec- tion of the legal guarantee in accordance with current legislation. To enforce your rights or inte- rests you must go to any of our ofcial technical assistance services. You can nd the closest one by accessing the following web link: http://solac.com You can also request related information by con- tacting us by phone. You can download this instruction manual and its updates at http://solac.com