ManualGo.com 
ZJX74 - Toaster KENWOOD - Free user manual and instructions
Find the device manual for free ZJX74 KENWOOD in PDF.
Download the instructions for your Toaster in PDF format for free! Find your manual ZJX74 - KENWOOD and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ZJX74 by KENWOOD.
USER MANUAL ZJX74 KENWOOD
Read these instructions carefully and retain for future reference.
Remove all packaging and any labels.
If the cord is damaged it must, for safety reasons, be replaced by KENWOOD or an authorised KENWOOD repairer.
Never use a damaged appliance. Get it checked or repaired: see ‘service and customer care’.
Always use the filter and never overfill - boiling water may splash out.
Avoid contact with steam coming out of the spout area when pouring and out of the lid or spout area when refilling.
Beware: the body of the kettle will get hot during operation.
Never let the cord hang down where a child could grab it.
Always unplug your kettle when not in use.
Never put the kettle, powerbase, cord or plug in liquid.
Caution: Do not operate the kettle on an inclined surface.
Only use the powerbase supplied and keep it clean and dry.
Make sure the lid is secure before switching the kettle on.
Take care when opening the lid - droplets of hot water may be ejected. English
2 3l Make sure the kettle is switched off before lifting or pouring.
Remove the kettle from the base before filling or pouring.
Never put the kettle near or on cooker hot plates or gas burners.
This kettle is for boiling water only.
Misuse of your appliance can result in injury.
Children from 8 years and above can use, clean and perform user maintenance on this appliance in accordance with the User Instructions provided they are supervised by a person responsible for their safety and have been given instruction concerning the use of the appliance and are aware of the hazards.
Persons with reduced physical, sensory or mental capabilities or lack of knowledge using this appliance must have been given supervision or instruction on its safe use and are aware of the hazards.
Children must not play with the appliance and both appliance and cord must be out of reach of children less than 8 years.
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
Make sure your electricity supply is the same as the one shown on the underside of your kettle.
WARNING: THIS APPLIANCE
This appliance conforms to EC Regulation 1935/2004 on materials and articles intended to come into contact with food. before using for the first time 1 Wrap any excess cord around the bracket h on the underside of the powerbase. 2 Fill to ‘MAX’, boil, then pour the water away. Repeat 3 times.key a spout b finger pad c flip top lid d lid release button e on/off switch f water level guage g 360° powerbase h cord wrap i filter to use your kettle 1 Press the lid release button d to open the lid, then fill the kettle. The water level must be between ‘MAX’ and 1 cup (250mls).
If you live in a hard water area we recommend that you use filtered water in order to maintain the appearance and efficiency of your kettle.
Be economical: do not boil more water than you need.
To improve the quality of your drinks always use fresh water.
Empty the kettle after each use.
Rinse out with fresh water if the kettle has not been used for more than 2 days. 2 Close the lid by pushing down on the finger pad area 1. 3 Plug in and switch on. 4 Your kettle will boil and switch off automatically. To re-boil, wait a few seconds - the on/off switch needs time to reset. Note - To interrupt the boiling ensure that the switch is in the off position before removing from the powerbase.
If you experience problems with your kettle switching on and off during use or switching off before boiling, check that the flat element is free from scale - see “descaling”.
Your kettle is fitted with a filter to hold back limescale particles.
If you find drops of water under your kettle, don’t worry - it is just condensation. boil-dry protection
If you switch on with too little water, your kettle will cut out automatically. Switch off, remove from the powerbase and let it cool down before re-filling. When it has cooled down, the switch will reset itself. care and cleaning
Before cleaning, unplug your kettle and let it cool down. the outside and powerbase
Wipe with a damp cloth, then dry. Do not use abrasives - they will scratch the metal and plastic surfaces. the inside
Wipe with bicarbonate of soda on a damp cloth. Rinse thoroughly.
Even though your kettle comes with a filter, you still need to clean the inside (and the filter) regularly. the filter 1 Open the lid. 2 Lift the filter out away from the spout area 2. 3 either rinse under the tap or use a soft brush. or when descaling your kettle, drop the filter in too. Rinse thoroughly. 4 Place the filter back in the spout area and push down to secure 3. descaling
Regular descaling of the flat element will improve the performance of your kettle. If the kettle is not descaled regularly the build up of limescale may result in the following:
problems may be experienced with the kettle switching on and off during use or switching off before boiling.
the kettle may take longer to boil.
the flat element may be damaged. Please note: Failure to descale your kettle may invalidate your guarantee.
When limescale starts to build up on the heating element, buy a suitable descaler and descale your kettle. After descaling, boil with fresh water several times and discard. Clean any descaler off the kettle - it can damage the parts.
Some regions of the country have chalky water. This makes boiled water look cloudy and leaves a deposit on the side of the kettle. This is normal but can be removed with regular cleaning.
Alternatively, to reduce limescale build up, use filtered water to fill your kettle. service and customer care
If you experience any problems with the operation of your appliance, before requesting assistance refer to the “troubleshooting guide” section in the manual or visit www.kenwoodworld.com.
Please note that your product is covered by a warranty, which complies with all legal provisions concerning any existing warranty and consumer rights in the country where the product was purchased.
f your Kenwood product malfunctions or you find any defects, please send it or bring it to an authorised KENWOOD Service Centre. To find up to date details of your nearest authorised KENWOOD Service centre visit www.kenwoodworld.com or the website specific to your Country.
Designed and engineered by Kenwood in the UK.
EQUIPMENT (WEEE) At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.
Problem Cause Solution Kettle not operating. No Power. Check kettle is plugged in. Kettle unplugged. Check kettle is correctly located to the powerbase. Kettle not switching off Kettle overfilled. Check water level is not automatically after above the Max level. boiling/Long switch off time. Lid not closed. Check lid is closed correctly. Water splashing out of Filter not fitted in Always use the filter and do spout area. spout area. not overfill above the Max level. Kettle switching on and Limescale/mineral Check that the element is free off during use or build up on element from scale. switching off before affecting operation. Refer to “descaling” section water boiled. under care and cleaning. Kettle stopped working Boil dry protection Switch off and remove from during operation. operated due to the powerbase. insufficient water in Allow to cool down before the kettle. refilling. When the kettle has cooled down the switch will reset itself. Check the water level is above the minimum level. If none of the above solve the problem see “Service & Customer Care”. troubleshooting guideveiligheid
