Question 1

How to place and install the filtration materials of the EDEN FES 300?

Accepted Answer

The EDEN FES 300 filter uses a multilayer filtration system. Here’s how to properly arrange the materials:

Supplied materials and their placement

Filter foams: The filter contains a 10 ppi foam and a 20 ppi foam. Install them in their respective compartments of the filter, following the indicated order.
Ceramic substrate: You have 3 bags of ceramic substrate, each weighing 420 g. Remove them from their plastic packaging, rinse them in hot water to eliminate impurities, and then pour them loosely into the designated compartment.
Activated carbon: Keep the carbon in its filter bag and place it in the designated location of the filter.

Important recommendation

Before the first use, rinse all filtration materials in hot water. During regular maintenance, clean or replace the foams in a staggered manner to preserve the beneficial filtering bacteria that gradually colonize the filter.

Question 2

How to install the feet of the EDEN FES 300 water filter?

Accepted Answer

The EDEN FES 300 water filter comes with 4 rubber feet that must be installed before any connection.

Installation procedure:

Take the 4 rubber feet out of the bag provided in the packaging (reference: item no. 10 in the overview of the manual)
Position them under the filter container, one foot at each corner or support point
Ensure that the device is stable and well-balanced

This step must precede the plumbing connections and electrical connection. The rubber feet isolate the device from the ground and ensure good stability, which is important for a device weighing 4.4 kg with dimensions of 290 x 180 x 420 mm.

User manual EDEN : user manuals and guides in PDF

Models EDEN most viewed

Browse manuals EDEN by appliance type

Recent questions about devices EDEN