How to install the sealing ring on the WILFA XPLODE BBLSP1800T blender?

Question

Accepted Answer

The sealing ring of your WILFA XPLODE BBLSP1800T blender (capacity 2 liters, 1800 W) is a crucial element to ensure proper sealing during use. Before installing the ring, make sure that all contact surfaces are clean and dry. The ring should be positioned between the blade assembly interface and the bottom of the glass container, or on the lid depending on its location in your model.

To correctly install the ring, carefully inspect it to ensure that it shows no damage, deformation, or wear. A damaged or worn ring will not provide proper sealing and may cause leaks during the preparation of your smoothies or soups. If the ring shows signs of wear, it is recommended to replace it.

Gently place the ring in its designated slot. Ensure that the ring fits perfectly against the surface without forming folds, misalignments, or overhangs. The ring should fit evenly all around the contact area. If you are using the blade assembly interface (part no. 5 according to the product diagram), make sure that the ring is properly positioned before attaching it to the bottom of the Tritan glass container.

After installing the ring, test the sealing by placing the lid and closing it tightly. The ring should not protrude and the assembly should form a sealed barrier without air leaks. When cleaning, remove the ring and wash it with warm water and dish soap, then reposition it correctly before the next use.

To ensure a long lifespan of the ring, always clean removable parts immediately after use, according to the manufacturer's instructions. Do not expose the ring to temperatures above 90 °C, as the glass container can only withstand this limit. If you experience persistent sealing issues, consult Wilfa's support page at wilfa.com for replacement parts or technical support.

User manual WILFA Blender : user manuals and guides in PDF

Models WILFA Blender most viewed

Other categories WILFA

Recent questions about Blender WILFA