How to assemble and install the CLATRONIC BQ 2977 N grill?

Q: How to assemble and install the CLATRONIC BQ 2977 N grill?

Unpacking and checking Start by removing all items from the packaging: protective films, filling materials, tie wraps, and cardboard. Check that you have received all components: the drip tray, the cooking grill, the heating element with the control unit, the housing, and the indicator lamp. If any parts are missing or damaged, do not operate the device and return it to the seller. Step 1: Installing the drip tray Position the drip tray for the grill directly in the housing. Then pour 1.8 liters of cold water into this tray up to the "MAX" mark located at the bottom. This is crucial: never exceed this mark to avoid damaging the heating element. Always grill with water in the tray to prevent overheating. Step 2: Installing the heating element Install the heating element with its control unit in the housing. Press lightly and gradually until it fits properly; you will hear a small click confirming the correct positioning. The control unit is equipped with a safety switch that prevents operation outside the housing, so ensure that the fitting is correct. Step 3: Electrical connection Before plugging in, check that the voltage indicated on the device (230 V, 50 Hz) matches that of your installation. The device consumes 2000 W: plug it into a properly installed outlet protected by a dedicated 16 amp switch. If you use an extension cord, it must have a minimum cross-section of 1.5 mm²; never use a power strip as the device is too powerful. Step 4: Break-in before first use Before cooking your first foods, let the device run empty for about 15 minutes with the tray filled with water. Turn on the device using the switch. A slight formation of smoke is normal during this phase as the protective layer of the heating element dissipates. Ensure adequate ventilation. After this period, your grill is ready for use.

Question

Accepted Answer

Unpacking and checking
Start by removing all items from the packaging: protective films, filling materials, tie wraps, and cardboard. Check that you have received all components: the drip tray, the cooking grill, the heating element with the control unit, the housing, and the indicator lamp. If any parts are missing or damaged, do not operate the device and return it to the seller.

Step 1: Installing the drip tray
Position the drip tray for the grill directly in the housing. Then pour 1.8 liters of cold water into this tray up to the "MAX" mark located at the bottom. This is crucial: never exceed this mark to avoid damaging the heating element. Always grill with water in the tray to prevent overheating.

Step 2: Installing the heating element
Install the heating element with its control unit in the housing. Press lightly and gradually until it fits properly; you will hear a small click confirming the correct positioning. The control unit is equipped with a safety switch that prevents operation outside the housing, so ensure that the fitting is correct.

Step 3: Electrical connection
Before plugging in, check that the voltage indicated on the device (230 V, 50 Hz) matches that of your installation. The device consumes 2000 W: plug it into a properly installed outlet protected by a dedicated 16 amp switch. If you use an extension cord, it must have a minimum cross-section of 1.5 mm²; never use a power strip as the device is too powerful.

Step 4: Break-in before first use
Before cooking your first foods, let the device run empty for about 15 minutes with the tray filled with water. Turn on the device using the switch. A slight formation of smoke is normal during this phase as the protective layer of the heating element dissipates. Ensure adequate ventilation. After this period, your grill is ready for use.

User manual CLATRONIC Electric grill : user manuals and guides in PDF

Models CLATRONIC Electric grill most viewed

Other categories CLATRONIC

Recent questions about Electric grill CLATRONIC