Question 1

How to resolve the issue when the KRUPS ESSENTIAL YY8135FD coffee machine is stuck in steam mode?

Accepted Answer

If your KRUPS ESSENTIAL YY8135FD coffee machine is stuck in steam mode, here are several steps to follow to try to resolve this issue:

1. Check the mode selector

Make sure that the mode selector is properly set to the coffee function and not to steam. Sometimes, a slight adjustment is necessary to change modes.

2. Restart the machine

Turn off the machine, wait about 30 seconds, then turn it back on. This may reset some temporary settings.

3. Check the water tank

Ensure that the water tank is filled and properly installed. An insufficient water level or incorrect positioning can prevent switching to coffee mode.

4. Clean the steam nozzle

A clogged steam nozzle can cause malfunctions. Clean it thoroughly to remove any residue or deposits that may block its operation.

5. Perform a reset

If the problem persists, try resetting the machine by following the procedure specific to this model (often by holding down a specific button while powering on). This operation restores factory settings.

If none of these solutions work, it is advisable to contact KRUPS customer service or a specialized technician for a thorough diagnosis.

Question 2

How to set the coffee preparation time on the KRUPS AROMACONTROL AUTO OFF machine?

Accepted Answer

To set the coffee preparation time on your KRUPS AROMACONTROL AUTO OFF machine, follow these simple steps:

Steps to set the coffee time

Turn on the machine: Make sure the machine is plugged in and turned on.
Access programming mode: Press the Program or Prog button to enter programming mode.
Set the hour: Use the + and - buttons or the arrows to select the hour you want the machine to start preparing.
Set the minutes: After setting the hour, adjust the minutes in the same way.
Confirm the programming: Press the Program button again to validate the programmed time.
Check the display: An indicator or icon should appear to confirm that the programming is active.

Once these steps are completed, your machine will automatically prepare coffee at the programmed time, allowing you to enjoy ready coffee as soon as you wake up or at any other chosen time.

Question 3

Why does the 'place a container' icon appear every time I start my KRUPS ESSENTIAL EA8160 coffee machine and how do I manage the water that flows from the steam nozzle?

Accepted Answer

The 'place a container' icon that appears every time you start your KRUPS ESSENTIAL EA8160 coffee machine indicates that the machine detects a water flow, usually from the steam nozzle. Here are the possible reasons and how to address them:

1. Automatic rinsing at startup

The machine performs an automatic rinse every time it is turned on to clean the internal circuit. This process can cause a slight water flow from the steam nozzle. Therefore, it is normal for the machine to ask you to place a container to collect this water.

2. Positioning the container

To avoid splashes or overflow, always place a container under the steam nozzle before starting the machine. This allows you to collect the water that flows naturally during rinsing.

3. Checking the steam nozzle

Ensure that the steam nozzle is not blocked by residues or limescale.
Regularly clean the nozzle with a damp cloth and perform periodic descaling according to the manufacturer's recommendations.

4. Checking seals and components

A worn or improperly positioned seal can cause water leaks. Check that all elements around the steam nozzle are properly in place and in good condition.

5. If the problem persists

If despite these checks, you still have to empty a bowl of water with each first coffee, this may indicate a technical malfunction. In this case, it is advisable to contact KRUPS customer service for further assistance.

User manual KRUPS Coffee machine : user manuals and guides in PDF

Models KRUPS Coffee machine most viewed

Other categories KRUPS

Recent questions about Coffee machine KRUPS