How to adjust the sensitivity of the Vevor TS181A metal detector?

Q: How to adjust the sensitivity of the Vevor TS181A metal detector?

On the Vevor TS181A , the sensitivity is adjusted using the SENSITIVITY/MODE SELECTION button located on the control panel. Adjustment Procedure Hold the detector in search position and lift the coil about 50 cm off the ground , parallel to it. Press the "+" side of the button to increase sensitivity, or "-" to decrease it. Observe the sensitivity indicator bars on the screen (up to 8 bars): the more there are, the higher the sensitivity. Adjust until you hear a slight beep , indicating that the setting is suitable for the ground conditions. Important: depending on the active mode In All Metal mode : the button properly adjusts the sensitivity. In Discrimination mode (Jewelry, Coins, Trash, Ornaments, Custom): this same button toggles between the discrimination sub-modes and does not change the sensitivity. Tip: If the detector emits erratic signals or interference (especially indoors or in highly mineralized areas), reduce the sensitivity. A lower but stable setting is more effective than a high unstable setting.

Question

Accepted Answer

On the Vevor TS181A, the sensitivity is adjusted using the SENSITIVITY/MODE SELECTION button located on the control panel.

Adjustment Procedure

Hold the detector in search position and lift the coil about 50 cm off the ground, parallel to it.
Press the "+" side of the button to increase sensitivity, or "-" to decrease it.
Observe the sensitivity indicator bars on the screen (up to 8 bars): the more there are, the higher the sensitivity.
Adjust until you hear a slight beep, indicating that the setting is suitable for the ground conditions.

Important: depending on the active mode

In All Metal mode: the button properly adjusts the sensitivity.
In Discrimination mode (Jewelry, Coins, Trash, Ornaments, Custom): this same button toggles between the discrimination sub-modes and does not change the sensitivity.

Tip: If the detector emits erratic signals or interference (especially indoors or in highly mineralized areas), reduce the sensitivity. A lower but stable setting is more effective than a high unstable setting.

User manual Vevor Detector : user manuals and guides in PDF

Models Vevor Detector most viewed

Other categories Vevor

Recent questions about Detector Vevor