What are the buttons on the Vevor AL-K07 bill counter for?

Question

Accepted Answer

The Vevor AL-K07 bill counter has several buttons to control the different counting and detection functions. Here are the details of each command:

Counting Buttons

START - Starts counting once the bills are inserted into the hopper
AUTO - Activates automatic counting: the device counts as soon as the bills are inserted, without additional pressing
BATCH - Allows you to set predefined batches (100, 50, or 20 bills)
ADD - Activates the addition function to accumulate multiple counts into a single total
VALUE - Switches to value calculation mode based on the denomination of the bills

Counterfeit Detection Buttons

CF - Activates/deactivates the UV (ultraviolet), MG (magnetic), and IR (infrared) detectors to verify the authenticity of the bills
DD - Activates the detection of width differences (damaged bills, half-bills, or chained bills)

Adjustment Buttons

SET - Allows you to adjust the sensitivity of the sensors according to the type of bills
+/− - Increases or decreases the values during setup

The 4-digit LCD screen displays the current count. It changes to red to signal the detection of a counterfeit or abnormal bill. The maximum counting speed is 1,000 bills per minute.

User manual Vevor Coin and bill counter : user manuals and guides in PDF

Models Vevor Coin and bill counter most viewed

Other categories Vevor

Recent questions about Coin and bill counter Vevor