How to adjust the nail penetration depth on the MAKITA AN902 stapler?

Question

Accepted Answer

To adjust the nail penetration depth on your MAKITA AN902 stapler, start by disconnecting the air hose from the device. This safety measure is essential before any adjustments to the setting device.

The nail depth is adjusted by turning the adjustment device located on the tool. Turn it in the A direction to achieve the maximum nail penetration depth. Conversely, turn it gradually in the B direction to reduce the penetration depth. The more you turn towards direction B, the less the nails will penetrate deeply into the material.

If after adjusting the device you encounter depth issues, it is often related to air pressure. If the nails cannot be driven in deep enough even when the device is fully turned in direction A, increase the air pressure of your compressor. Conversely, if the nails are driven in too deeply even with the device set to direction B, reduce the air pressure for less driving force.

For better longevity of your MAKITA AN902 stapler, prefer using it with lower air pressure and an adjustment device set to a low nail depth. Before starting your work, always perform tests on a piece of wood similar to your project to ensure that the setting matches your needs precisely.

User manual MAKITA Electric stapler : user manuals and guides in PDF

Models MAKITA Electric stapler most viewed

Other categories MAKITA

Recent questions about Electric stapler MAKITA