What are the essential tips and steps for using the MAKITA DUN500W hedge trimmer correctly for the first time?

Question

Accepted Answer

Before first use, ensure that the compatible battery (BL1815N to BL1860B series) is fully charged. Inspect the work area to remove obstacles: barbed wire, stones, cables, electrical wires. Check the hedges and bushes for any foreign objects that could damage the blades.

Initial tool preparation:

Check that the cutting blades (50 cm long, tooth spacing of 18 mm) are not damaged and apply a thin layer of low-viscosity machine oil
Ensure that all guards, the front handle, and the rear handle are securely attached
Insert the battery until you hear a click of confirmation and check that the red indicator is not visible
For the DUN500W, adjust the head to the desired angle in 6 possible positions (45° upwards to 70° downwards)

Mandatory personal protective equipment:

Robust leather work gloves
Safety glasses or eye protection
Protective helmet (mandatory if working overhead)
Hearing protection (the tool produces 81 dB(A) at the source)
Sturdy work shoes with non-slip soles
Use the provided shoulder strap to reduce fatigue (adjust it to your size)

Essential instructions before starting:

Maintain a minimum distance of 15 meters from people nearby
Do not use the tool in the rain or in wet conditions
Avoid using the hedge trimmer in bad weather or during a storm
Never use the tool near power lines
Check that the main switch and trigger are functioning correctly before starting

Basic operation: Press the main power button to turn the tool on (the power indicator lights up). You can adjust the cutting speed by pressing this button: Low (2,000 min⁻¹), Medium (3,600 min⁻¹) or High (4,400 min⁻¹). To start cutting, press the safety lever and pull the trigger. Release to stop.

Effective cutting technique: Always hold the tool with both hands. Tilt the cutting blades in the direction of the cut and move the tool calmly and slowly at a speed of 3 to 4 seconds per meter. For an even finish, always start from the bottom of the hedge and work your way up. Do not attempt to cut branches with a diameter greater than 10 mm; pre-cut them to 10 cm below the cutting height using a lopper. Avoid any accidental contact with metal fences or hard objects, as the blades could break and cause serious injuries.

Maintenance and care after each use: Remove the battery immediately after use. Clean the work area to remove debris. Remove dust from both sides of the blades with a wire brush, wipe with a cloth, and then apply low-viscosity oil to the blades. Every 25 hours of operation, apply specific grease at the lubrication point. Attach the blade cover and store the tool in a dry place, away from children and moisture. Never store the tool with the battery inserted for an extended period.

User manual MAKITA Brush cutter : user manuals and guides in PDF

Models MAKITA Brush cutter most viewed

Other categories MAKITA

Recent questions about Brush cutter MAKITA