How to unlock the Makita LH1040 miter saw for use?

Question

Accepted Answer

The Makita LH1040 has two locking systems that must be released to use the saw. Before each use, follow these steps:

Release the stopper pin: If the saw is in a locked position (transported or stored), you will find a stopper pin that locks the handle in the lowered or raised position. Pull this stopper pin to fully release it. The handle will then be able to move freely.
Release the shaft lock: Before starting the saw, you must release the shaft lock that immobilizes the blade shaft. This will allow you to rotate the blade freely when starting.
Lower the handle with the lever: To use the saw, lower the handle by pushing the lever located immediately next to it to the left. This lever also controls the blade guards, which will automatically lift when the handle is lowered.

Important points: Always check that the shaft lock is released before pressing the switch. If you need to store the saw, keep all moving parts locked in the transport position by fully pressing the stopper pin.

Safety: Always wear personal protective equipment (safety glasses, gloves, hearing protection) and ensure that the blade guards close properly before each use.

User manual MAKITA Miter saw : user manuals and guides in PDF

Models MAKITA Miter saw most viewed

Other categories MAKITA

Recent questions about Miter saw MAKITA