User manual Ferplast Aquarium : 36 free PDF user manuals

Q: Where is the pump located in the Blumodular 2 filter?

The pump of the Blumodular 2 is integrated into the upper module of the filtration system. It is located at the top of the unit, after the water passes through the filtration modules. Components of the pump Pump body (M.1) Rotor (M.2) Turbine (M.3) Pump cover (M.4) Operation of the water circuit Water enters through the bottom inlet grids of the filter, passes through the filtration modules, and then reaches the pump at the top. It then exits through an adjustable nozzle (settable from 0 to 180 degrees). Important: For optimal and safe operation, ensure that the pump remains at least partially submerged during the operation of the filter.

Q: Should the Blumodular 2 filter be completely submerged in water?

No, you should not fully submerge the entire Blumodular 2 unit. Only the pump should remain at least partially submerged in water. According to the Ferplast Blumodular 2 manual, you should "operate the BLUMODULAR filter in such a way that its pump is always at least partially submerged" . Optimal Installation Position the filter inside or on the side of the tank using the provided suction cup mounts The pump, located in the upper module, must remain in contact with the water The rest of the unit can remain above the surface, which facilitates access to accessories (diffuser, flow regulator) Never operate the filter dry Important: Ensure that the power cable is positioned with its lowest point below the filter outlet to prevent water droplets from entering the wall socket.

Models Ferplast Aquarium most viewed

User manual Ferplast Aquarium : user manuals and guides in PDF

Models Ferplast Aquarium most viewed

Other categories Ferplast

Recent questions about Aquarium Ferplast