Question 1

What to check if 2 burners out of 4 are not working on my CAMPINGAZ 4 Series Classic WLD?

Accepted Answer

Several elements can prevent your burners from functioning. Here’s what you should check first:

1. Position and obstruction of the Venturi tubes

The Venturi tubes (tubes that cover the injectors) are often the main cause. Check that:

The Venturi tubes are correctly positioned and properly cover the injectors
They are not obstructed by debris, cobwebs, or other deposits that would reduce performance
If obstructed, clean them gently

2. Burner orifices

The orifices (OH) of the burners must remain clear and dry. Inspect them and clean if necessary to ensure proper gas flow.

3. Gas connection and piping

Check that:

Your gas bottle contains gas and is properly connected
The supply hose is not twisted or damaged
All connections are tight

4. Ignition of the burners

Ensure that the ignition works correctly:

Always open the lid before igniting
If you are using piezo ignition, press the ignition button and repeat 3-4 times if necessary
If you have electronic ignition, hold the switch for a few seconds and wait 5 minutes before trying again in case of failure
As a last resort, you can use a match from the back of the barbecue

5. Preventive maintenance

The manual recommends a quarterly cleaning: completely remove the burners and check that the Venturi orifices are not obstructed. Regular maintenance prevents these issues.

If after these checks the 2 burners still do not work, there may be a more significant technical problem (persistent poor gas flow, injector issue): contact Campingaz customer service.

Question 2

What should I do before the first use of my CAMPINGAZ 4 Series Classic WLD barbecue?

Accepted Answer

Before starting your CAMPINGAZ 4 Series Classic WLD barbecue for the first time, you must perform a complete safety check and follow the initial setup procedure.

Pre-checks

Check the following points:

No gas leaks
The Venturi tubes are not blocked (check for cobwebs or debris)
The supply hose does not touch hot parts
The ventilation openings of the compartment are not blocked
The grease collection tray is properly positioned
The 6 removable parts of the bowl are put back in place

First startup

Critical point: Always light the barbecue with the lid open. Never use it with the lid closed when lighting.

After the checks, heat the barbecue with its burners on full power, lid closed, for about 30 minutes. This step eliminates paint odors from new parts.

For subsequent uses, preheat for a few minutes to bring the grates to the proper cooking temperature before placing your food.

Question 3

How do I assemble my CAMPINGAZ 4 Series Classic WLD barbecue?

Accepted Answer

The complete assembly guide for the Campingaz 4 Series Classic WLD barbecue is not in the PDF displayed on this page (which is a user manual). You can find the detailed guide with diagrams on ManualsLib.com by searching for your model, or check the campingaz.fr website under the Downloads section. An assembly booklet is normally included in the box of your barbecue.

Main assembly steps (duration: about 1h30 with two people):

Prepare a flat and well-ventilated space, clearing around the barbecue
Assemble the main frame and base, aligning the internal red tabs (critical tolerance of 5 mm)
Attach the InstaClean® side panels, shelves, and storage
Install the cooking grids and the grease collection tray, positioning it firmly against the stop
Reattach the 6 removable parts of the bowl if you had removed them
Connect the regulator to the gas bottle, then the flexible hose (max 1.50 m) to the regulator and the appliance using 2 wrenches
Conduct a leak test with a leak detection solution (never with a flame) before first use

Necessary tools: simple manual screwdriver (not electric), flat or adjustable wrenches, protective gloves. Wear gloves throughout the operation as it is advisable to do so.

Essential safety points: the gas bottle must remain in an upright position and placed always outside the barbecue, never underneath. Keep the hose away from any heat source. The barbecue should only be used outdoors, with at least 60 cm of distance around any combustible material. The leak test is mandatory before first use.

If the provided booklet is missing or incomplete, contact Campingaz France directly at +33 (0)4 78 86 88 94 (9:30 AM - 5 PM, Monday to Friday, April-September) or visit campingaz.fr. You can also send an email to infofrance@newellco.com with a photo of the barbecue to receive a detailed guide.

Question 4

Can the gas bottle be placed under the griddle of the Campingaz 3 Series Classic WLD 2en1 barbecue?

Accepted Answer

For the Campingaz 3 Series Classic WLD 2en1 barbecue equipped with a griddle, it is important to follow the safety instructions regarding the placement of the gas bottle:

Do not place the gas bottle directly under the griddle. The griddle generates significant heat that can warm the bottle, which is dangerous.
The bottle must be installed in a designated compartment, well-ventilated and away from direct heat sources. On this model, the bottle compartment is generally located under the cart, but not under the griddle itself.
Ensure that the bottle is stable and that the connections are properly made to avoid any gas leaks.

Following these recommendations ensures safe and compliant use of your barbecue. If in doubt, check the specific instructions provided with your device or contact Campingaz customer service.

User manual CAMPINGAZ Barbecue : user manuals and guides in PDF

Models CAMPINGAZ Barbecue most viewed

Other categories CAMPINGAZ

Recent questions about Barbecue CAMPINGAZ