Q: What connections need to be made inside the AquaRite NEO LS housing?

Inside the AquaRite NEO LS housing , you connect the following components directly to the electronic board: Temperature probe - terminals A-S-C with red/black/black wires Mechanical flow detector - terminals E-F (non-polarized dry contact): safety element that stops the system in case of no flow pH dosing pump (optional) - terminals H-I, output 230V max 5A Optional modules - slots for pH, Rx or WiFi/Ethernet chips Operation with your filtration system: The AquaRite NEO LS does not connect directly to the filtration pump. The electrolysis cell is installed in a by-pass of your water circuit, downstream of your filtration pump. The control box should be positioned at least 3.5 meters away from the pool and only controls the cell. The integrated flow detector ensures that water is flowing properly through the cell. Recommended electrical configuration: Timed circuit breaker 16 A with RCD 30 mA.

Question 1

What connections need to be made inside the AquaRite NEO LS housing?

Accepted Answer

Inside the AquaRite NEO LS housing, you connect the following components directly to the electronic board:

Temperature probe - terminals A-S-C with red/black/black wires
Mechanical flow detector - terminals E-F (non-polarized dry contact): safety element that stops the system in case of no flow
pH dosing pump (optional) - terminals H-I, output 230V max 5A
Optional modules - slots for pH, Rx or WiFi/Ethernet chips

Operation with your filtration system:

The AquaRite NEO LS does not connect directly to the filtration pump. The electrolysis cell is installed in a by-pass of your water circuit, downstream of your filtration pump. The control box should be positioned at least 3.5 meters away from the pool and only controls the cell. The integrated flow detector ensures that water is flowing properly through the cell.

Recommended electrical configuration: Timed circuit breaker 16 A with RCD 30 mA.

Question 2

How to check and maintain the sand level in the HAYWARD S360SLETL water pump filter?

Accepted Answer

The sand level in the HAYWARD S360SLETL water pump filter is essential for ensuring effective filtration and the proper functioning of the device. Here’s how to check and maintain this level:

1. Checking the sand level

Open the filter: Carefully remove the filter cover to access the sand bed.
Observation: The sand should be evenly distributed and completely cover the filtering surface.
Measurement: The recommended level is generally about 15-20 cm below the top edge of the filter, allowing for good water circulation.

2. Maintaining and adjusting the sand level

Add sand: If the level is too low, it is necessary to top up with specific filter sand, following the manufacturer's recommendations.
Replacement: It is advisable to replace all the sand every 3 to 5 years depending on usage and water quality.
Regular checks: Perform periodic checks to detect any abnormal drop in level or signs of wear.

3. Additional tips

Avoid using unsuitable sand, which could damage the system.
In case of doubt or persistent issues, it is important to consult a qualified professional.

By following these steps, you will ensure optimal filtration and extend the lifespan of your HAYWARD S360SLETL pump.

User manual HAYWARD Water pump : user manuals and guides in PDF

Models HAYWARD Water pump most viewed

Other categories HAYWARD

Recent questions about Water pump HAYWARD