Q: Is the support number for the Genie 580 XCD free?

No, the number +49 (0)180 5 007514 is not free . In Germany, numbers starting with "0180" are special rate numbers and are charged according to your telephone provider , usually between 20 cents and several euros per minute. Before contacting support, you can try: Consulting your device manual for troubleshooting tips (especially for REV mode in case of a jam) Checking that the shredder is properly positioned on its waste bin (a necessary condition for the overload protection to function) Checking your 2-year warranty if the device is recent If you need assistance at no cost, you can also contact the manufacturer by mail: GO Europe GmbH, Zum Kraftwerk 1, D-45527 Hattingen, Germany .

Question 1

Is the support number for the Genie 580 XCD free?

Accepted Answer

No, the number +49 (0)180 5 007514 is not free. In Germany, numbers starting with "0180" are special rate numbers and are charged according to your telephone provider, usually between 20 cents and several euros per minute.

Before contacting support, you can try:

Consulting your device manual for troubleshooting tips (especially for REV mode in case of a jam)
Checking that the shredder is properly positioned on its waste bin (a necessary condition for the overload protection to function)
Checking your 2-year warranty if the device is recent

If you need assistance at no cost, you can also contact the manufacturer by mail: GO Europe GmbH, Zum Kraftwerk 1, D-45527 Hattingen, Germany.

Question 2

Why don't the blades of the shredder move?

Accepted Answer

If the blades of your Genie 580 XCD shredder do not rotate, here are the points to check in order:

1. Check the position switch

The three-position switch must be set to AUTO (automatic shredding mode). If the switch is set to OFF, the blades cannot operate. Also, check that the paper bin is properly installed - the device has a safety system that prevents operation if the bin is incorrectly positioned.

2. Check for overload and cooling

The device has an automatic overload protection: after 2 minutes of continuous operation at maximum capacity, the motor automatically stops. If you have used the device for a long time, let it rest for a few minutes at room temperature before restarting.

3. Check for a possible blockage

If paper or a sheet is stuck, the blades may not move. Set the switch to REV (reverse) to reverse the direction of the blades and clear the blockage. Then wait a few seconds before repositioning to AUTO.

4. Check the power supply

Make sure the cable is properly connected to a 230-240V power outlet and that the device is receiving electricity (look for any indicator light or power signal).

If after these checks the blades still do not move, contact Genie customer service at +49 (0)180 5 007514.

User manual Genie Shredder : user manuals and guides in PDF

Models Genie Shredder most viewed

Other categories Genie

Recent questions about Shredder Genie