Where can I find a clamping nut for the MSW TAS287 saw?

Q: Where can I find a clamping nut for the MSW TAS287 saw?

The MSW TAS287 saw uses a clamping nut (mutter) with a diameter of 16 mm for securing the cutting blade. This nut is a wear part that may need to be replaced during regular maintenance of the tool. To obtain a replacement clamping nut: Contact the MSW/Expondo customer service directly, specifying that you are using the TAS287 model and need a clamping nut ø16 mm Reach out to an authorized MSW dealer indicating the exact model TAS287 You can also approach a professional hardware store that can offer you a standard M16 nut made of equivalent quality steel When ordering the replacement part, specify the TAS287 model and the diameter ø16 mm to ensure compatibility. The nut must be in good condition to ensure optimal and secure tightening of the blade. To install the nut, use a 16 mm open-end wrench and tighten it firmly clockwise after properly positioning the blade in the clamping ring.

Question

Accepted Answer

The MSW TAS287 saw uses a clamping nut (mutter) with a diameter of 16 mm for securing the cutting blade. This nut is a wear part that may need to be replaced during regular maintenance of the tool.

To obtain a replacement clamping nut:

Contact the MSW/Expondo customer service directly, specifying that you are using the TAS287 model and need a clamping nut ø16 mm
Reach out to an authorized MSW dealer indicating the exact model TAS287
You can also approach a professional hardware store that can offer you a standard M16 nut made of equivalent quality steel

When ordering the replacement part, specify the TAS287 model and the diameter ø16 mm to ensure compatibility. The nut must be in good condition to ensure optimal and secure tightening of the blade.

To install the nut, use a 16 mm open-end wrench and tighten it firmly clockwise after properly positioning the blade in the clamping ring.

User manual MSW Saw : user manuals and guides in PDF

Models MSW Saw most viewed

Other categories MSW

Recent questions about Saw MSW