Owl by Nuna - Uncategorized Bugaboo - Free user manual and instructions

USER MANUAL Owl by Nuna Bugaboo

Bugaboo child restraint in collaboration with Nuna Meet your Bugaboo Owl by NunaIMPORTANT! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE: READ CAREFULLY ISet-up

Bugaboo Owl by Nuna is based on the Nuna TODL next model Designed for discovery. II III1

EN ENThis product is suitable for use with children who meet the following requirements: Product information Model Number: Manufactured in (date): Product registration Please fill in the above information. The model number and the manufactured in date are located on the boom of the Bugaboo Owl by Nuna. To register your product please visit: www.bugaboo.com/productregistration Nuna has purposely developed and manufactured this product to meet the high quality standards of Nuna and Bugaboo. Please have the proof of purchase, model number and manufactured in dated available when you contact about service. Bugaboo will take your call about the Bugaboo Owl by Nuna. For warranty information on this Bugaboo Owl by Nuna, please visit: www.bugaboo.com/warranty Customer service If you have a question you might be able to find the answer on our website www.bugaboo.com. If you need to contact our international service team, we are always happy to hear from you! We are available to answer any questions, concerns, or comments you may have regarding our products and services. Don’t hesitate to contact us. Your feedback helps us to further improve our products and services. Contact form via bugaboo.com, www.bugaboo.com/support Child usage requirements Child's Size Installation Mode Figure for Installation Reference Age Seat PositionInfant InsertInstructions40cm-105cm/ ≤18kgRearward Facing Mode <4 yearsPosition 1-5 We recommend using the full infant insert while the baby is under 60cm and ≤13kg. It can be used until they outgrow the insert. The infant insert increases side impact protection.76cm-105cm/ ≤18kgForward Facing Mode 15 months to 4 yearsPosition 1 -5 Remove the infant insert when forward facing mode.

1. This is an "i-Size" Enhanced Child Restraint System. It is

approved according to UN Regulation No.129, for use in, i-Size compatible vehicle seating positions as indicated by vehicle manufacturers in the vehicle users’ manual.

2. If in doubt, consult either the Enhanced Child Restraint System

manufacturer or the retailer.

EN ENConsider the danger of making any alterations or additions to the device without approval of the adequate authority, and the danger of not following closely to the installation instructions provided by the enhanced child restraint manufacturer. Please keep this enhanced child restraint away from direct sunlight, otherwise it may become too hot for child’s skin. Always test the temperature by touching the enhanced child restraint before placing child in it. Children should not be le unaended in their enhanced child restraint system. Any luggage or other objects liable to cause injuries in the event of a collision shall be properly secured. The enhanced child restraint may not fit in all approved vehicles when used in one of these positions. The enhanced child restraint system shall NOT BE USED without the so goods. The so goods should not be replaced with any other than the one recommended by the manufacturer, because the so goods constitutes an integral part of the restraint performance. The instructions should be retained on the enhanced child restraint for its life period. Please also pay aention to the instructions and warnings in the vehicle manufacturer's handbook. Failure to follow these warnings and instructions could result in serious injury or death. DO BE cautious that the rigid items and plastic parts of an enhanced child restraint system shall be located and installed so that they are not liable to become trapped by a moveable seat or in a door of the vehicle. DO NOT use the rearward facing enhanced child restraint system in seating positions where there is an active frontal airbag installed. To use this enhanced child restraint according to the UN Regulation No.129, your child must meet the following requirements. Rearward Facing: Child height 40cm-105cm/ Child weight ≤18kg; Forward Facing: Child height 76cm-105cm/ Child weight ≤18kg; IMPORTANT - DO NOT USE FORWARD FACING BEFORE THE CHILD’S AGE EXCEEDS 15 MONTHS (Refer to instructions) Any support-leg should be in contact with the vehicle floor and any straps restraining the child should be adjusted to the child’s body. The straps should not be twisted. Ensure that any lap strap is worn low down, so that the pelvis is firmly engaged, shall be stressed. This enhanced child restraint should be replaced when it has been subject to violent stresses in an accident. An accident can cause damage to it that you cannot see. WARNING

Parts list 1 Head Support 2 Seat Pad 3 Buckle 4 Webbing Adjustment Buon 5 Adjustment Webbing 6 Recline Adjustment Buon 7 Rotating Buon 8 Shoulder Harness Covers 9 Infant Insert 10 Head Support Adjustment Lever 11 ISOFIX Adjustment Buon 12 Child Restraint Release Buon 13 Load Leg 14 Load Leg Adjustment Buon 15 ISOFIX Guides 16 Side Impact Protection Pod 17 ISOFIX Connector 18 Instruction Manual Storage Compartment 19 Infant Carrier Rotation Buon Make sure all parts are available before assembly. If any part is missing, please contact local retailer. No tools are required for assembly.

EN ENProduct Set up Installation concerns This enhanced child restraint system is only suitable for vehicle seats equipped with ISOFIX anchorage bars. (1) DO NOT use the rearward facing enhanced child restraint system in seating positions where there is an active frontal airbag installed. (2) Death or serious injury may occur. Please reference vehicle owner’s manual for more information. DO NOT install this enhanced child restraint system on vehicle seats that face sideways or rearward with respect to the moving direction of the vehicle. Please refer to your vehicle owner’s manual for recommended or suggested installation positions. (3) It is recommended to install this enhanced child restraint on the rear vehicle seat. (4) DO NOT install this enhanced child restraint system on movable vehicle seats. Product Use Base Installation

1. Aach the ISOFIX guides to the vehicle's ISOFIX anchor bars

(see vehicle owner's manual). (5) The ISOFIX guides can protect the surface of the vehicle seat from being torn. They can also guide the ISOFIX connectors.

2. Unfold the load leg from storage compartment. (6)

3. Extend the ISOFIX connectors by pressing the ISOFIX

adjustment buon while pulling on the connector. (7)

4. Press the ISOFIX adjustment buon to adjust the ISOFIX

connectors. Line up the ISOFIX connectors with the ISOFIX guides, and then click both ISOFIX connectors into the ISOFIX anchor bars. (8) Make sure that both ISOFIX connectors are securely aached to the vehicle's ISOFIX anchor bars. There should be two audible clicks and the colors of the indicators on both ISOFIX connectors should be completely green. (8)-1 Check to make sure the base is securely installed by pulling on both ISOFIX connectors.

5. After placing the base on the vehicle seat, extend the load leg

to floor (9). When the load leg is installed correctly, the load leg indicator will show green. Red will be shown when installed incorrectly. (9)-2 The load leg has multiple positions. When the load leg indicator shows red this means the load leg is in the wrong position. Make sure the load leg is in full contact with the vehicle floor pan. Squeeze the load leg adjustment buon, then shorten the load leg upwards. (9)-1 The completely assembled base is shown as (10). The ISOFIX connectors must be aached and locked onto the ISOFIX anchor bars. (10)-1 The load leg must be installed correctly with green indicator. (10)-2

6. To remove the base, press the secondary lock buon (11)-1 first

followed by the buon (11)-2 on the ISOFIX connectors before removing the base from the vehicle seat. (11)

7. For transporting, press ISOFIX Adjustment buon and move the

ISOFIX connectors back into the storage position. (12)

1. The enhanced child restraint is delivered with removable side

impact protection pod. This side impact protection pod MUST be used on the door side of the vehicle. Installation shown in (13).

2. Press the release buon to remove side impact protection pod.

(14) Height Adjustment for Head Support and Shoulder Harnesses Please adjust the head support and check if the shoulder harnesses are at the correct height according to (15)(16)(17)(18). When used in rearward facing mode, the shoulder harness height must be even with or just below the top of child’s shoulders. (15) When used in forward facing mode, the shoulder harness height must be even with the top of child’s shoulders. (16) Pull the head support adjustment lever (17), meanwhile pull up or down the head support until it snaps into one of the 6 positions. The head support positions are shown as (18). Recline Adjustment

1. Squeeze the recline adjustment buon to adjust the enhanced

child restraint to the proper position. (19)

2. Both rear facing mode and forward facing mode have 5 recline

positions, the recline angles are shown as. (20) Rearward Facing Mode (Child height 40cm-105cm/ Child weight ≤18kg) Please install the enhanced child restraint on the rear vehicle seat, and then place the child in the enhanced child restraint.

1. Push the enhanced child restraint down onto the base (21).

If the enhanced child restraint is secure, the enhanced child restraint indicator will show green. (22)

2. To release the enhanced child restraint, first take the child out

of the child restraint. Squeeze the child restraint release buon (23)-1, then li the child restraint up (23)-2. The enhanced child restraint can ONLY be installed and released when in rearward facing mode.

3. Press and hold the ISOFIX adjustment buon and push the

enhanced child restraint system back until it comes in contact with the vehicle seatback. (24)

4. Press and hold the rotation buon to rotate for easier side

loading/unloading of the child, then rotate the seat to the rear facing position. (25) Press the rotation buon on either side to rotate the enhanced child restraint.

5. Press the harness adjustment buon while pulling the shoulder

harnesses to the desired length (Pull from below the fixed shoulder pads to lengthen). (26)

6. Unlock the buckle of the harnesses by pressing the red buon.

7. Place the buckle tongues against the magnetic area on the

outer side of the enhanced child restraint so that the tongues are held in place. (28)

8. Place the child into the enhanced child restraint and pass both

arms through the harnesses.

9. Engage the buckle. Please refer to (29).

10. Rotate the enhanced child restraint to rearward facing. The

enhanced child restraint indicator will show green. (30) 11 Pull down the adjustment webbing and adjust it to the proper length to make sure your child is properly secured. (31) Always keep child secured in harness and properly tightened by removing any slack. We recommend using the full infant insert while the baby is under 60cm and ≤13kg. It can be used until they outgrow the insert. The infant insert increases side impact protection.Remove the head support portion of the infant insert when the child’s head no longer fits comfortably.Remove the body portion of the infant insert when the infant’s shoulders no longer fit comfortably.

Remove the infant insert cushion by detaching the snaps to allow more space when the infant does not fit comfortably. The cushion can be used separately without being aached to the insert to bolster the infant's back for more comfort. Forward Facing Mode (Child height 76cm-105cm/ Child weight ≤18kg) (Child's Age ≥15 Month) Please install the enhanced child restraint on the rear vehicle seat, and then place the child in the enhanced child restraint.

1. Press the rotation buon to rotate for easier side loading/

unloading of the child, then rotate the seat to the forward facing position. (32) Press the rotation buon on either side to rotate the enhanced child restraint.

2. Press the harness adjustment buon while pulling the shoulder

harnesses to the desired length (Pull from below the fixed shoulder pads to lengthen). (33)

3. Unlock the buckle of the harnesses by pressing the red buon.

(34) Remove the infant insert when in forward facing mode.

4. Place the buckle tongues against the magnetic area on the

outer side of the enhanced child restraint so that the tongues are held in place. (35)

5. Rotate the enhanced child restraint seat to forward facing, the

enhanced child restraint indicator will show green. (36)

6. Pull down the adjustment webbing and adjust it to the proper

length to make sure your child is properly secured. (37) Always keep child secured in harness and properly tightened by removing any slack. DO NOT use forward facing unless your child is at least 76cm AND 15 months old

EN ENDetach & Assemble So Goods Press the red buon to disengage the buckle. (38) Follow steps (39) - (44) to detach so goods. To re-aach the so goods please repeat the above steps in reverse. Cleaning and Maintenance Please store the infant insert somewhere out of the child's reach. Please wash the so goods with cold water under 30°C. DO NOT iron the so goods. DO NOT bleach or dry clean the so goods. DO NOT use undiluted neutral detergent, gasoline or other organic solvent to wash the enhanced child restraint. It may cause damage to the enhanced child restraint. Please do not use harsh cleaning detergents (including chlorine) as this may alter the color of the fabric. DO NOT twist the so goods to dry with great force. It may leave the so goods with wrinkles. Please hang dry the so goods in the shade. Please remove the enhanced child restraint from the vehicle seat if it will not be in use for a long period of time. The information contained herein is subject to change without notice. Bugaboo International BV shall not be liable for technical errors or omissions contained herein. The purchased product may dier from the product as described in this user guide. Our most recent user guides can be requested at our service departments or at www.bugaboo.com. © 2021 Bugaboo International BV. BUGABOO, BUGABOO CAMELEON, BUGABOO BEE, BUGABOO DONKEY, BUGABOO FOX, BUGABOO TURTLE, BUGABOO ANT, BUGABOO LYNX, BUGABOO STARDUST, BUGABOO BUTTERFLY, BUGABOO OWL and the Bugaboo logos are registered trademarks. The Bugaboo® strollers are patented and design protected. © NUNA International B.V. Nuna and all associated logos are trademarks.