LARY - Humidifier Air&Me - Free user manual and instructions

USER MANUAL LARY Air&Me

• Make sure the unit is in the upright position for at least 24 hours before turning it on.

• Make sure that the product is placed on a dry flat surface.

• Leave at least 50cm behind, around and in front of the appliance and make sure that the air inlet and outlet are not obstructed.

• Make sure the removable filter and the tank are properly positioned and pushed in.

• Do not remove the float from the tank because it will prevent the appliance from starting.

• If you want, you can add rubber shock absorbing pads under the dehumidifier to reduce vibrations, noise and marks on a wooden floor.

CAUTION, RISK OF FIRE

4REFRIGERANT GAS NOTE FOR THE APPLIANCE: R290 – 60 G Extremely flammable gas. Contains gas under pressure; may explode if heated. Precautionary statements: Keep away from heat, sparks, open flames, hot surfaces, in a non- smoking environment. In case of fire gas leak: Do not extinguish unless the leak can be stopped safely. Eliminate all sources of ignition if it is safe. Store in a well-ventilated area.

• Do not exceed an impedance of more than 0.236 Ω.

• Only persons who have an accredited body and certify their competence in handling copyright in accordance with the sector's legislation, must work on the refrigerant circuit.

• Allly are add to a guidelines to available.

• The maintenance and treatment of the general gas flammables.

• Do not puncture the components of the refrigerant circuit.

Voltage Dimensions (H x W x D) Net weight Number of speed Maximal power consumption Suitable for rooms up to Water tank volume Ambient temperature range Dehumidication capacity 220-240 V ~ 50 Hz 500 x 280 x 200 mm 12 kg

5°C - 35°C 12 L/day (30°C, 80 % RH) TECHNICAL DATA The safety of this product conforms to the relevant norms and regulations in force in the Euro- pean Union. For any further information, please visit our website: www.airandme.fr Our customer service department is available at the following email address: info@airandme.fr To prevent from any danger or electrical shock, always unplug the product when you are not using it, moving it or cleaning it. In case of repairs, approach the qualied persons.

141. Please read all the instructions care-

fully before using Lary.

2. Any use that is not recommended by

the reseller can lead to re, power surge or can hurt people.

3. Remove the packaging and make

sure that Lary is not damaged. If in doubt, do not use the appliance and contact your reseller.

4. Do not let children play with the diffe-

rent pieces of the packaging.

5. Before using Lary, make sure that the

voltage indicated on the product is in accordance with your electrical installation.

6. Pay special attention when using the

appliance near a child.

7. Using an extension electric cable

can create overheating and re.

8. Do not pull on the power cord to

unplug the appliance. Always unplug Lary by holding and pulling on the socket.

9. Do not insert object inside the fan. It

can cause electrical shock or da- mage the appliance. Do not cover or put objects that can obstruct the air ow.

10. Always unplug Lary when you are

12. During operation, leave at least

20cm behind, around and in front of the appliance.

13. Make sure the product is on a dry

at and horizontal surface.

14. Do not use Lary outdoors.

15. Always unplug Lary when moving it.

16. Keep the product clean and in

parts (non ofcial parts could be dangerous and invalidate the war- ranty).

18. Store Lary in a dry and safe place,

19. If the power cord is damaged, it can

be changed by the reseller. Only qualied persons can make this re- pair.

20. This product cannot be used by

children less than 8 years old. Please read carefully this user ma- nual and use Lary with caution.

Fan operating indicator light

“Full tank” alert Make sure that the product is placed on a dry at surface. Leave at least 20cm behind, around and in front of the appliance. Make sure that the pre-lter and the tank are correctly placed.

1. Plug the appliance.

2. Press the ON/OFF button:

• The digital display will icker during the stabilisation time and then, it will display the humidity rate of the room air.

• Lary automatically starts in HYGROSMART

3. Press ON/OFF twice to select “CLOTHES DRYER” MODE.

4. Press ON/OFF a third time to select NIGHT MODE.

5. Press ON/OFF for a long time to turn the appliance off. The fan will stop after 30 seconds.

• Make sure the product is placed on a dry, level surface.

• Leave at least 50 cm space behind, on the sides and in front of the unit.

• Make sure that the removable lter and the tank are correctly positioned and depressed.

• Do not remove the oat from the tank, as this will prevent the unit from starting.

Display of the humidity rate of room air:

• Between 40 and 60%, the display is green to indicate an ideal humidity rate.

• Below 40%, the display is blue to indicate a too dry air.

• Above 60%, the display is red to indicate a too humid air.

Continuous drainage outlet

Multidirectional casters

Continuous drainage hose 16MAIN FUNCTIONS

FUNCTION: This mode allows you, at maximum speed, to maintain an ideal humidity level in the air (between 47% and 53%). When the humidity level is below 47%, the unit goes into standby mode: the compressor stops immediately and the fan stops after 30 seconds. If the humidity level is above 53%, the appliance automatically switches on again: the compressor starts up again 3 seconds after the fan.

“CLOTHES DRYER” MODE: In “clothes dryer” mode, the appliance works at maximum speed. It is the perfect mode for laundry drying which needs significant air dehumidification.

function, this mode allows you to maintain a humidity level between 47 and 53%. However, the appliance works more quietly, at low speed, and it does not produce sound signal once the tank is full.

“FULL TANK” ALERT: The appliance produces a sound signal once the tank is full. The appliance turns off and the indicator becomes red. To empty the tank:

Turn off the appliance and pull out the tank using the handle provided.

Reposition the tank.

Press the ON/OFF button and choose the desired operating mode. The dehumidifier is equipped with a tank positioning sensor. As a matter of security, the product turns off if the tank is missing or not properly placed. ADDITIONAL FUNCTIONS (SEE PAGE 3) TANK DRAIN (SEE PAGE 3) CONTINUOUS DRAINAGE: Thanks to the continuous drainage hose, the appliance will work independently without having to empty the tank. Make sure the hose is not bent and that it is placed on a downward slope so that water can easily drain away. Do not modify or extend the drainage hose.

Connect the drainage hose.

Pass the hose through the opening provided for this purpose before repositioning the tank. NEGATIVE IONISATION: For your well-being, when it is in operation, the appliance diffuses negative ions into the room. These are created by the corona effect, i.e. an electric current rich in negative ions is applied to very fine carbon fibres. This means that your air dehumidifier DOESN’T produce ozone. AUTOMATIC ANTIFREEZE FUNCTION (DEFROST): The appliance automatically enters in defrost function if the ambient temperature is between 5°C and 15°C. Every now and then, the compressor stops but the fan continues to work. 17CLEANING THE PRE-FILTER: The pre-lter captures dust and extends the appliance efciency. It is recommended to clean it every month. Unclip the pre-lter and clean it with warm water and a soft brush. CLEANING THE APPLIANCE:

1. Unplug the appliance before doing any manipulation.

2. Do not immerse the appliance into water or any other liquid.

3. Do not use corrosive, abrasive or ammable products to clean the appliance.

4. Use a soft cloth to remove dust at the air inlets and outlets.

5. To avoid calc deposit, clean the tank at least once a month with an appropriate product or

with white vinegar. STOCKAGE: To avoid any bacteria or virus proliferation, never store the appliance with water inside the tank and be sure that the appliance is perfectly dry.

1. Empty and clean the tank.

2. Clean the pre-lter.

3. Store the product in a place that is protected against dust and that is clean and dry.

MAINTENANCE In order to empty the tank in a high level drain, you can easily add the Pump It Up by air&me lift pump in Lary’s tank. Small and easy to handle, it is easy to install and enables the dehumidier to work independently. ACCESSORY (NOT INCLUDED)

appliance near a child.