User manual OK Dishwasher : 19 free PDF user manuals

Q: The dishwasher beeps but does not start the program - what to do?

If your ODW 6031 BI dishwasher beeps without starting the program, check these points in order: 1. The door This is the most common cause. Make sure the door is completely closed with a clear click. A utensil or dish may be blocking the closure - check the inside. 2. Water supply Check that the water inlet tap is fully open and that the water pressure is between 0.4 and 10 bar (as indicated in the technical manual). Ensure that the inlet hose is not kinked or crushed . 3. Power on Press the Power (on/off) button to turn on the device, then select a program with the P (Program) button. The beeping may indicate that the device did not recognize the selection. 4. Error codes According to the manual, the beeps may correspond to: E1 - Water supply problem: check the tap and the hose connection E2 - Overflow detected: the main filter may be clogged If the problem persists after these checks, it is likely that an electronic component is faulty. Consult customer service with your warranty number (visible in the manual).

Q: Why won't the program start on my OK ODW 6031 BI?

If the program does not start on your OK ODW 6031 BI, first ensure that the water supply tap is fully open, that the power outlet is powered, and that the door is properly closed. The door must be securely locked for the appliance to operate. Then follow the exact starting procedure: first press the On/Off button (A11) to turn on the appliance, then press the Program Selection button (A10) to choose your program from Intensive, Universal, Eco, Glass, 90 min, or Quick, and finally press the Start/Pause button (A7) to begin the cycle. Also check that the essential conditions for starting are met. Before your first use, the salt container must be filled : first pour in 1.5 liters of water, then 1.5 kg of dishwasher salt into the designated container. You must also add detergent to the appropriate compartment before each start. If the red rinse aid indicator (A1) is lit, fill the corresponding tank before starting. Observe the indicators to understand the status of your appliance. If the program indicator is on and steady , it means the appliance is in standby or pause. If the indicator is flashing , the washing cycle is in progress. After filling the salt, you must run a quick cycle (for example, the Quick program) to prevent damage to the filter, pump, or other important components from salty water, which would void the warranty. If after these checks the program still does not start, check that the door is properly closed and that no object is obstructing it. You can also try turning the appliance off for 30 seconds and then restarting it. If the problem persists, refer to the troubleshooting section of your complete manual or contact customer service using the details on your warranty card.

Models OK Dishwasher most viewed

User manual OK Dishwasher : user manuals and guides in PDF

Models OK Dishwasher most viewed

Other categories OK

Recent questions about Dishwasher OK