How to adjust the travel of the LiftMaster LM60 garage door?

Q: How to adjust the travel of the LiftMaster LM60 garage door?

Location of the programming buttons: On your LiftMaster LM60 garage door, the programming buttons are located under a removable cover at the back of the motor. You will find the Adjustment button as well as the UP and DOWN buttons. Steps to adjust the travel: Start by pressing and holding the Adjustment button until the UP button starts to blink. Then press and hold the UP button to raise the door to the desired open position, using the UP and DOWN buttons for fine adjustments. Once the position is reached, press and release the Adjustment button to confirm. The motor will flash and the DOWN button will start to blink. For the closed position, proceed in the same way: press and hold the DOWN button to lower the door to the desired closed position. Be careful not to bend the rail during this operation. Then press and release the Adjustment button to confirm this position. The motor will flash and the UP button will start to blink. Final test: Press and release the UP button: the door should move to the programmed open position, then the DOWN button will start to blink. Press and release the DOWN button for the door to descend to its closed position. If the door does not move correctly, restart the programming from the beginning by pressing the Adjustment button. System features: Your LM60 has a two-speed system automatically managed by the software. Doors less than 190 cm will automatically roll at slow speed for optimal safety. The system also includes a reverse safety feature: if an obstacle interferes with the descent, the door will automatically reverse. Important: At no time should you turn screws or use tools to adjust the travel. Adjustments for the LM60 are made entirely through electronic programming via the buttons. If the adjustment fails, simply restart the procedure from step 1.

Question

Accepted Answer

Location of the programming buttons: On your LiftMaster LM60 garage door, the programming buttons are located under a removable cover at the back of the motor. You will find the Adjustment button as well as the UP and DOWN buttons.

Steps to adjust the travel: Start by pressing and holding the Adjustment button until the UP button starts to blink. Then press and hold the UP button to raise the door to the desired open position, using the UP and DOWN buttons for fine adjustments. Once the position is reached, press and release the Adjustment button to confirm. The motor will flash and the DOWN button will start to blink.

For the closed position, proceed in the same way: press and hold the DOWN button to lower the door to the desired closed position. Be careful not to bend the rail during this operation. Then press and release the Adjustment button to confirm this position. The motor will flash and the UP button will start to blink.

Final test: Press and release the UP button: the door should move to the programmed open position, then the DOWN button will start to blink. Press and release the DOWN button for the door to descend to its closed position. If the door does not move correctly, restart the programming from the beginning by pressing the Adjustment button.

System features: Your LM60 has a two-speed system automatically managed by the software. Doors less than 190 cm will automatically roll at slow speed for optimal safety. The system also includes a reverse safety feature: if an obstacle interferes with the descent, the door will automatically reverse.

Important: At no time should you turn screws or use tools to adjust the travel. Adjustments for the LM60 are made entirely through electronic programming via the buttons. If the adjustment fails, simply restart the procedure from step 1.

User manual LIFT-MASTER Garage door : user manuals and guides in PDF

Models LIFT-MASTER Garage door most viewed

Other categories LIFT-MASTER

Recent questions about Garage door LIFT-MASTER