What is the power source for the laser component on the WORX WX426 saw?

Question

Accepted Answer

The laser component located on top of the WORX WX426 saw is powered by batteries. Specifically, it requires two AAA batteries to operate correctly. These batteries allow the laser to project a visible guide line, making your cuts more precise.

To replace the batteries, open the compartment located on the laser module, insert two new AAA batteries while respecting the indicated polarity, and then close the compartment. Make sure the laser works before each use to ensure accurate cutting.

User manual WORX Saw : user manuals and guides in PDF

Models WORX Saw most viewed

Other categories WORX

Recent questions about Saw WORX