How to make an angled cut with the Alpha Tools AST 350 E saw?

Question

Accepted Answer

To make an angled cut with the Alpha Tools AST 350 E saw, follow these steps:

1. Setting the cutting angle

The AST 350 E saw is equipped with a mechanism to adjust the blade angle. Locate the knob or angle adjustment lever, usually found at the base of the saw or near the blade.

Loosen the locking mechanism.
Tilt the blade to the desired angle, typically between 0° and 45° depending on the model.
Securely lock the adjustment to ensure stability during cutting.

2. Preparing the material

Place the workpiece on the saw table, holding it firmly against the stop and the table to prevent any movement.

Use clamping or holding devices if available.
Ensure the piece is properly positioned according to the chosen angle.

3. Making the cut

Turn on the saw and allow the blade to reach its maximum speed.
Slowly lower the blade following the cutting line.
Always keep your hands away from the blade and follow safety instructions.

4. Checking and finishing

After the cut, check the accuracy of the angle and the quality of the cut.

If necessary, sand the edges for a clean finish.

By following these steps, you will be able to make precise and safe angled cuts with your Alpha Tools AST 350 E saw.

User manual Alpha Tools Saw : user manuals and guides in PDF

Models Alpha Tools Saw most viewed

Other categories Alpha Tools

Recent questions about Saw Alpha Tools