CE4480 - SOLAC - Free user manual and instructions

USER MANUAL CE4480 SOLAC

Solac is a registered Trade Mark

A C L M B J N K O E Q H G I F Fig. 1

D P ESPAÑOL ES Read these instructions carefully before using the appliance. This manual is an integral part of the product. Keep it in a safe place for future reference.

than the one indicated could be dangerous.

- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. - Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children aged less than 8 years. - If the power cord is damaged, it should be replaced by the manufacturer or by your after sales service shop or similar qualified personnel to prevent possible hazards.

DESCRIPTION A B C D E F G H I J K L M N O P Q Water Tank Lid

Water tank Hot plate for warming cups Connection pilot light Heating pilot light Start/Stop Switch Coffee outlet/Water outlet Switch Steam heating Switch Steamer pipe Filter holder Measuring spoon Filter for single measure Ground coffee filter (2 cups) Supply cable Drip tray Tray grill Steam knob

- This appliance is intended to be used in household applications such as: staff kitchen areas in shops; offices and other working environments; farm houses; by clients in hotels, motels and other residential type environments; bed and breakfast type environments. Using it for any purpose other

Never immerse the main body in water or any other liquid, or put it in the dishwasher. The appliance should not come into contact with water during cleaning.

EN pump to draw out the maximum flavour and aroma from the coffee. It is therefore normal for the electric pump to make a little noise and vibrate when it comes into operation.

- Clean the tank, steam nozzle and filter holder regularly. To keep your coffee machine in a perfect condition, we recommend the use of a special descaler product for coffee machines to descale the appliance approximately once every 12 months (depending on the hardness of the water and the frequency with which the appliance is used).

- Do not modify or repair the appliance. In the event of any anomaly in the appliance, do not use it and take it to an authorised assistance service. - Do not use any parts or accessories not supplied or recommended by SOLAC. - Before plugging the appliance into the mains, check that the indicated voltage is the same as in your home. - Always unplug the appliance after use and before assembling or removing parts, and performing any maintenance or cleaning operations. Also unplug it in the case of a power cut. The appliance must be switched off before plugging or unplugging it into the mains - Never pull the cord or use it to hang up the appliance. Always unplug the appliance by pulling the connection pin, and not the cord. - Make sure the cord does not come into contact with sharp edges or hot surfaces. Do not leave the cord hanging over the edge of a table or worktop, to prevent children from pulling it and causing the appliance to fall. - Remove all elements from the inside or outside of the appliance used for protection during transport or for sales promotions, such as paper or plastic bags, plastic sheets, cardboard and stickers. - Make sure that there is water in the tank, before connecting the coffee maker. • Do not touch the appliance with wet hands when in operation. - Do not use the appliance on wet surfaces or outdoors. - The appliance must be connected to a power socket with a suitable ground connection. - Do not release the filter holder while coffee is coming out. - Steam and water may sometimes emerge from the coffee outlet. This is not a sign of a fault or malfunction. - This espresso coffee maker is a high pressure model (up to 19 bar) and has a built-in electric

- Before using the coffee machine for the first time, we recommend allowing the equivalent of 8-10 cups of water to run through the filter holder (with no coffee in the filter). This completely cleans the entire system. - Getting the right espresso for every user’s taste is a result of the type of coffee, the dose and the pressing: - We recommend you choose your preferred coffee blend, one with a fine grind especially for espresso. - The result will vary considerably according to the quantity of coffee used. If you want a strong coffee, you can exceed the dispenser spoon amount and fill the filter holder to the top. - Finally, we recommend that you press the coffee to extract all the coffee essences and improve the cream. - Coffee should always come out of the filter holder in a regular stream, without dripping. If not, both the quantity of coffee and the pressing should be reduced or the coffee grind adjusted. - We recommend that you make the coffee as soon as the indicator light turns blue to ensure a higher temperature.

- Any misuse or failure to follow the instructions for use renders the guarantee and the manufacturer’s liability null and void.

INSTRUCTIONS FOR USE BEFORE USE:

- Make sure that all the product’s packaging has been removed. - Before connecting the machine, check that the buttons (F, G) are not pressed, and steam control (Q) is closed - Before using this product for the first time, it is advisable to test it only with water.

- Before using the product for the first time, clean the parts that will come into contact with food in the manner described in the cleaning section. Priming the circuit: This simple operation ensures optimum dispensing and must be carried out: - When first starting: - When the machine has been out of use for a long time (1 or 2 weeks) - After making steam - When the tank has run out of water. - Fill the receptacle taking care to observe the MAX level - Connect the appliance to the mains. - Press the on/off switch (F) to ON position. The (D) pilot light will come on - You do not have to wait for the machine to heat up for this operation - Without fitting the filter holder (or with the filter holder fitted, but without coffee), place a recipient under the steam pipe (I) - Open the steam knob (Q) by turning counterclockwise. - Press the coffee switch / water (G) to on position - Water will exit through the steam pipe. Wait until approximately one cupful has exited - To finish serving, back coffee / water switch to OFF position and close the steam knob (Q) by turning clockwise This will complete the priming operation.

- The deposit must be filled with water before turning the appliance on. - Remove the water tank. - Open the cover. - Fill the deposit taking care to observe the MAX level (Fig. 1) - Close the lid. - Replace the tank in its housing, ensuring that it is well fitted.

- We recommend using natural toast coffee, as using roasted coffee may affect the operation of the machine.

- Fill the removable filter with ground coffee (6-7 g per cup to be prepared). - If you wish to make 1 coffee, fill the ladle (1 spoonful) and take the capacity of the measuring spoon measure for one coffee until half its capacity. - For 2 coffees, put in 2 spoonfuls. - Next lightly press down the ground coffee with the back of the spoon. - Before fitting the filter holder in the coffeemaker assembly, turn the ladle-holder backwards. - Fit the filter holder in the appliance once more. - Position the filter holder in the coffee assembly by inserting the assembly downwards and turning it from left to right until it locks. - Insert the filter holder with coffee into the appliance - Turn it anticlockwise until it is in the locked position. - Turn the appliance on using the on/off switch (F) - The (D) pilot light comes on. - Wait until the pilot light (E) is lighting - Place one or two pre-heated cups at the filter holder outlet. - Press the coffee switch (G) to the ON position The coffee infusion will begin to exit. When you have obtained the desired quantity of espresso coffee (short or long), come back switch to OFF position - Once serving has finished, wait a few seconds and remove the cups with the coffee. - Remove the filter holder and empty the grounds from it. - Wash the filter holder with running water and dry it well. - Check that the removable filter is perfectly fitted into the filter holder. - Fit the filter holder in the appliance once more.

- Before connecting the machine, check that the buttons (F, G) are not pressed, and steam control (Q) is closed - Connect the appliance to the mains. - Remove the filter holder. - Position the ground coffee filter (M) filter holder

- Put The device in ON situation, pressing the knob ON/ OFF (F) - The Heating indicator light (D) will illuminate indicating that the water is heating up.

- Wait Until the pilot light coffee outlet (E) is also highlighted. This situation indicates that the water has reached the right temperature. - Place A container under the nozzle. - Open The steam control (Q), turning him to the left, counterclockwise - Press The button coffee /water outlet (G) - The Hot water began to come out of the vaporizer. ‘Once obtained the desired amount of hot water, press the coffee outlet button, which stops the pump - Close The turning knob (Q) to the right, clockwise Obtaining steam: - The steam is used to foam milk for cappuccino, and also to heat other liquids. - Turn the appliance on using the on/off switch - Wait until the pilot light has gone out which will indicate that the appliance has reached an adequate temperature. - Press the heating button and continue heating until the steam temperature has been reached. the Warning light (E) will illuminate indicating that the water has reached the necessary temperature for generating steam. - Place a recipient under the steam tube. - Open Steam knob (Q) anticlockwise - Steam only will begin to exit. - When you have enough, close the control (Q) and remove the recipient.

- To that end, after 25 minutes, the unit switches to energy saving mode. - To return to normal operation you should just march off-connect button (F). - If Coffee stop half done, simply return to normal operation, switching off and ON-OFF switch (F). Once you have finished using the appliance: - Turn the appliance off, using the on/off switch to OFF. - Unplug the appliance to the mains. - Remove the water from the water tank. - Clean the appliance.

- Do not use solvents, or products with an acid or base pH such as bleach, or abrasive products, for cleaning the appliance.

- It is advisable to clean the appliance regularly and remove any food remains. - If the appliance is not in good condition of cleanliness, its surface may degrade and inexorably affect the duration of the appliance’s useful life and could become unsafe to use. - After washing, dry all the parts before fitting them together and storing. HOW TO DEAL WITH LIME SCALE INCRUSTATIONS: - For the appliance to work correctly it should be kept free of lime scale or magnesium incrustations caused by the use of hard water. - To prevent this kind of problem, we recommend the use of water with low lime or magnesium mineralisation. - However, if it is not possible to use the kind of water recommended above, you should periodically remove the lime scale from the appliance: - Every 6 weeks if the water is “very hard”. - Every 12 weeks if the water is “hard”. - To do so, we recommend the use of the specific product Taurus Decal, which can be found in specialised shops and authorised technical services. - Homemade solutions are not recommended in the descaling of this appliance, such as the use of vinegar.

ANOMALIES AND REPAIR

- Take the appliance to an authorised technical support service if problems arise. Do not try to dismantle or repair without assistance, as this may be dangerous. - If the connection to the mains has been damaged, it must be replaced and you should proceed as you would in the case of damage. - If you detect any anomalies, refer to the following table:

- Disconnect the appliance from the mains and let it cool before undertaking any cleaning task. - Clean the equipment with a damp cloth with a few drops of washing-up liquid and then dry.

Water flows out of the side of the holder

-The holder is not installed correctly.

- The Edge of the ladle is covered coffee. -'The brewing group is dirty.

-see Section "getting coffee"

-Clean The ladle around the edge and clean the brewing of coffee. -Clean With a damp cloth.

The machine is turned off while supplies coffee

"Energy Saving" mode

-connect and Disconnect the

-The water tank is not properly placed. -the filter basket holes are clogged, the coffee is ground too fine or has been pressed too much

The coffee comes out slowly or drop by drop

The coffee comes without cream

The coffee comes out too fast

No steam escapes from the evaporator tube

The ground coffee is too much or too pressing

-The used Coffee is out of date -The Coffee has not been pressed enough. -the Ground coffee is too coarse. -The ground coffee is very thick. -There is not enough coffee in the filter basket. -The Coffee has not been pressed enough

- fill the water tank

- Make sure the tank is properly seated, pressing on the top -Empty The filter basket and cleaned with water. The brewing clean with a damp cloth. Reload filter basket again and press the coffee slightly Make sure Size ground is suitable and it’s not excessively pressed. -Use Fresh coffee and once opened store in an airtight container. -Press Firmly coffee. -Grind finer The coffee - Grind finer The coffee -Ensure That it’s the right amount of coffee in the filter basket. - Press Firmly the coffee Clean the steam tube with a damp cloth to remove any traces of milk have dried and unblock holes using a needle. Press the corresponding switch and remove steam until it goes out continuously

EN For EU product versions and/or in the case that it is requested in your country:

ECOLOGY AND RECYCLABILITY OF THE PRODUCT

- The materials of which the packaging of this appliance consists are included in a collection, classification and recycling system. Should you wish to dispose of them, use the appropriate public recycling bins for each type of material. - The product does not contain concentrations of substances that could be considered harmful to the environment

This symbol means that in case you wish to dispose of the product once its working life has ended, take it to an authorised waste agent for the selective collection of waste electrical and electronic equipment (WEEE)

This appliance complies with Directive 2014/35/EU on Low Voltage, Directive 2014/30/EU on Electromagnetic Compatibility, Directive 2011/65/EC on the restrictions of the use of certain hazardous substances in electrical and electronic equipment and Directive 2009/125/EC on the ecodesign requirements for energy-related products.

FRANÇAIS FR POPIS A B C D E F G H I J K L M N O P Q CS ES NESPRÁVNÉ

A OPIS A B C D E F G H J K L M N O P Q Model: CE4480

Rated Power: 220-240V~ 50Hz 850W