Question 1

How to change the temperature display of the DELTACALOR TELICA EVO radiator from Fahrenheit to Celsius?

Accepted Answer

To change the temperature display of your DELTACALOR TELICA EVO radiator from Fahrenheit (°F) to Celsius (°C), follow these steps:

Turn off the radiator and ensure it is completely powered down.
Press and hold the temperature adjustment button or the "Mode" button for about 5 to 10 seconds. This button is usually the one used to adjust the temperature or change operating modes.
Release the button when the display starts to blink or change, indicating that the temperature mode is being modified.
Use the adjustment buttons to toggle between Fahrenheit (°F) and Celsius (°C).
Confirm your choice by pressing the adjustment button again or by leaving the device inactive for a few seconds, which will automatically save the selection.

If this method does not work, your model may have a different procedure or the unit change may not be available via the control panel. In this case, contact DELTACALOR customer service for assistance specific to your model.

Question 2

How to increase the temperature on a DELTACALOR CUBO EVO electric radiator?

Accepted Answer

To increase the temperature of your DELTACALOR CUBO EVO electric radiator, follow these simple steps:

Turn on the radiator: Make sure the device is powered and turned on. The power indicator should be lit.
Locate the control panel: On the radiator, find the control panel which may have physical buttons or a touchscreen.
Adjust the temperature:
- If your model has buttons, press the button marked "+" or "Increase" to raise the temperature.
- If the radiator is equipped with a touchscreen, touch the area displaying the current temperature, then use the on-screen controls to increase the desired temperature.
Check the display: Ensure that the new temperature is displayed on the control panel.
Wait: The radiator will take a few minutes to reach the set temperature.

These steps will allow you to easily adjust the temperature of your DELTACALOR CUBO EVO for optimal comfort.

Question 3

How to set the time on a DELTACALOR CUBO EVO electric radiator?

Accepted Answer

To set the time on your DELTACALOR CUBO EVO electric radiator, follow the steps below:

Turn on the radiator: Make sure the device is powered on.
Access the settings menu: On the control panel, press the Menu or Settings button to open the configuration options.
Select the time setting option: Use the navigation arrows to select the Time Setting option or a similar option.
Set the hour: Press OK or Select to change the hour. Adjust the hours using the arrows, then confirm.
Set the minutes: Proceed in the same way to set the minutes.
Confirm the settings: Validate the changes by pressing OK or Confirm.
Exit the menu: Press Menu or Back to exit the settings mode.

If the control panel of your radiator has differences, please specify to receive appropriate assistance.

User manual DELTACALOR Electric heater : user manuals and guides in PDF

Models DELTACALOR Electric heater most viewed

Other categories DELTACALOR

Recent questions about Electric heater DELTACALOR