SteamClean Multi 12 - Steam cleaner Di4 - Free user manual and instructions

USER MANUAL SteamClean Multi 12 Di4

Labeled diagram of a cleaning or cleaning device with numbered parts for identification

INFORMACIÓN GENERAL

COMPRUEBE QUE EL APARATO ESTÁ COMPLETO Y NO PRESENTA NINGÚN DAÑO. EN CASO DE DUDA CONTACTE CON EL ESTABLECIMIENTO DONDE ADQUIRIÓ EL PRODUCTO.

DESCRIPCIÓN

WE WOULD LIKE TO THANK YOUR FOR CHOOSING DI4. WE WISH THE PRODUCT PERFORMS TO YOUR SATISFACTION AND PLEASURE.

GENERAL INFORMATION

FIRST CHECK THAT THE APPLIANCE IS COMPLETE AND UNDAMAGED. CONTACT THE STORE WHERE YOU PURCHASED THE PRODUCT IN THE EVENT OF ANY DOUBT.

DESCRIPTION

1. Handle
2. Upper cord hook
3. Tube connection
4. Lower cord hook
5. Power switch
6. Water tank cover 350ml
7. Triangle detergent head
8. Funnel
9. Steamer cloth
10. Steamer shelf
11. Squeegee attachment
12. Angled nozzle
13. Scrape tool
14. Brush tool
15. Big nylon brush tool
16. Small metal brush tool
17. Steamer jet
18. Carpet glider
19. Microfiber cloth
20. Detergent button
21. Detergent tank 300ml
22. Detergent spray mouth
23. Hose

SAFETY INSTRUCTIONS

This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe

way and understand the hazards involved. Children shall not play with the appliance. If the supply cord is damaged it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazard. The appliance shall not be left unattended while it is connected to the supply mains. The appliance is not to be used if it has been dropped, if there are visible signs of damage or if it is leaking.

Keep the appliance out of reach of children when it is energized or cooling down.

Steam must not be directed towards equipment containing electrical components, such as the interior of ovens. Appliance has to be unplugged after use and before carrying out user maintenance on the appliance.

Plug must be removed from socket-outlet before cleaning or maintaining the appliance.

WARNING: This symbol mean Danger of scalding.

This appliance is intended to use at a maximum altitude of 2000m above sea level.

IMPORTANT WARNINGS

Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the product label. The mains connection cable must not be tangled or wrapped around the product during use. Do not pull on the connection cord in order to unplug it. Do not use, connect, or disconnect the device to the mains with your hands or feet wet. Proceed according to the conservation and cle-

aning section of this manual for cleaning. Unplug the product immediately from the mains in the event of any breakdown or damage and contact an authorized technical support service. In order to prevent any risk of danger, do not open the device. Only qualified technical personnel from the brand's Official Technical support service may carry out repairs or procedures on the device.

Any incorrect use or improper handling of the product shall render the warranty null and void. Only an authorized technical support service center may carry out repairs on this product.

This appliance is designed exclusively for domestic use, in no case should be a commercial or industrial use. In case of misuse or tampering with the product, it will be out of warranty.

B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals, or objects, for the nonobservance of these warnings.

INSTRUCTIONS FOR USE

Assembly

Attaching the handle

Slide the handle into the extension tube until it locks into the position.

Slide the extension tube with the handle installed into the steam mop body until it locks into place.

The handle can be removed from the steam mop body for easy storage by pressing the handle tube button.

Attaching the Steam Head

Slide the button end of the steam mop body onto the triangle mop head until the triangle mop head spindle locks into place. Hold both parts of the unit and gently push the clip into the handle. This will lock the two parts into position.

Warning: Never force the steam mop body onto the triangle mop head, as this could potentially damage the steam mop. Always attach the triangle mop head using both hands, ensuring it locks into place correctly.

The triangle steam head can be removed from the main body by pressing the button on the triangle steam head spindle.

Attaching a Microfiber Cloth

Position the microfiber cloth onto the triangle steam head and secure it with the Velcro.

Attaching the Carpet Glider

Position the microfiber cloth into the triangle steam head and place the carpet glider over and around the microfiber cloth. To remove, simply push the carpet glider by foot.

Operation Instruction

1. Fill water

Please kindly fill water before use. Use the measuring cup and funnel to fill water into the water tank.

Please make sure that there is no residual water in the water tank before adding

water. Pour out the rest water after the operation is complete and clean the boiler.

There will be calcification inside, which may clog the steam after some time.

To clean the water tank, first add small amount of water in the boiler, shake the water by rocking the machine with both hands, and then pour out the water completely. You can repeat above action if the water contains a lot of impurity. Please close water tank cover when filled with water.

Do not add any liquid except clean water. Never place de-scaling, aromatic, alcoholic or detergent products in the steam mop tank, this will cause damage to the appliance and void your warranty.

2. Power on

Please ensure that water tank is filled with water and the water tank cover is in a tight status before powering on. Put the plug into socket and turn on the power switch. If the power is on, the green light will be on.

Note that there could be some water coming out at first time due to the condensate in the pipe. It will be dry after a few seconds.

Do not use wet hand to touch the power

Do not use any power cord & socket in broken status.

3. Operation

Using the Steam Mop

Plug the appliance into the mains power supply and switch on. After about 10 seconds the product is ready for steam cleaning. Steam will run continuously until the unit turns off or runs out of water.

A full tank will supply approximately 12 minutes of steam. If the water tank is empty, there will be a little pumping noise and vibration. Switch off the unit immediately and refill the water tank following the instructions above.

Using as a Hand-held Steamer

Press the handle tube button to remove the handle from the steam mop body.

Install the accessory adaptor at the top of the steam mop body until it locks into position.

Choose the required accessories and install by aligning the arrow indicators and turning clockwise.

4. Storage & Cleaning

After use, please turn the power off.

If there is residual water in the water tank, please open the cover and then pour out the water.

If there is dirt on the surface of body, please use dry dish cloth with some water to wipe gently.

Do not spray water onto the machine.

Do not place it under water as this may cause short circuit.

Microfiber clothes are machine washable on a warm setting. Always use a mild detergent. For best results lay flat to dry. Never use bleach or fabric softener when cleaning microfiber cloths.

After cleaning the appliance and accessories please keep it in a dark and dry place.

The power cord can be stored winding it using the upper and lower cord hooks.

Usage Instruction for Accessories

1. Telescopic tube

Assemble the extension tube if the steam cleaner is to be used to clean floor or high windows or difficult to reach areas. You can adjust the length of the tube if required. Press the release button and pull the tube apart to remove the extension tube from main unit.

2. Precision accessory

This nozzle makes it possible to clean hard to reach places such as corners, joints, and toilets with ease. Simply push the bent nozzle firmly into the main body directly.

3. Round brushes

The metal and nylon round brushes are attached firmly into the precision accessory. Even the most stubborn dirt can be removed. e.g. on blinds, central heating radiators etc. Please use small metal brush. The nylon brush is suitable for heavy staining on less sensitive materials such as stainless steel.

4. Angled nozzle

To reach difficult areas and corners, you can attach the angled nozzle to the precision accessory.

5.Joint brush

Attach this brush to the precision accessory when cleaning joints for a better cleaning result.

6. Scrap tool

Attach this accessory to the precision accessory for scraping baked food, grime, and grease. It is also suitable for removing residues or other different substances from surfaces such as hobs and ovens.

7. Extension hose

The extension hose is useful for hard-to-reach places.

Align the locking hole with the release lever of the hand-held unit. Push in the extension hose until it locks in place. Align the locking hole of the STEAM JET with the release lever of the hand-held unit extension hose. Also you could add some attachments onto it.

8. Detergent release

Fill detergent (diluted in water) by funnel and cup.

Press the detergent spray button by foot.

Remark: If the spray nozzle becomes clogged, you can clean it by removing it from the mop head. To remove it, place a flat screwdriver on the nozzle and lift up. The nozzle will pop off. Pass the spray nozzle under warm water to clean it out. Reinsert the spray nozzle into nozzle hole and push it into place.

9. Steamer cloth and shelf (Ironing brush)

To iron the cloth, sofa etc., put the white ironing towel on the ironing brush and connect with main body.

10. Window accessory

To clean windows, mirrors, or tiles with smooth surface objects, please use the window brush which contains a rubber blade combined with brush sprayer for cleaning.

If temperature is lower than 0^ C, please do not use this product to clean glass. Do not keep in the same position for more than 2 seconds.

TROUBLESHOOTING

ISSUE PLEASE CHECK AS BELOW SOLUTION
No steam spray	Plug not inserted to the power socket tightly	Insert again or change the socket
	Switch indicator light off Turn on the switch
	No water Fill water
	Other issues	Ask professional service
Water is flowing from nozzle	There may be some water in the steam during first usage. It will stop after a while	Normal phenomenon. It will disappear quickly
	Influence on the normal use	Ask professional service
Others	Steam comes out from the nozzle	Ask professional service
	Plastic deformation and softening phenomenon

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic devices, known as WEEE (Waste Electrical and Electronic Equipment), establishing the legal framework applicable in the European Union for the disposal and reuse of waste electronic and electrical devices. Do not dispose of this product in the bin, instead take it to the electrical and electronic waste collection center closest to your home.

FRANÇAIS

NOUS VOUS REMERCIONS D'AVOIR CHOISI DI4. NOUS ESPÉRONS QUE CE PRODUIT RÉPOND À VOS BESOINS ET À VOS GOÛTS.

INFORMATIONS GÉNÉRALES

VÉRIFIEZ AVANT TOUT QUE L'APPAREIL EST ENTIER ET NE PRÉSENTE AUCUN DOMMAGE. EN CAS DE DOUTE, CONTACTEZ LE MAGASIN OÙ VOUS AVEZ ACHE-TÉ LE PRODUIT.

DESCRIPTION

B&B TRENDS, SL. guarantees compliance of this product, for the use for which it is, during the period established by the legislation in force in the country of sale. In the case of breakdown during the term of this warranty, users are entitled to repair or else the replacement of the product at no charge if the former is unavailable, unless one of these options proves impossible to fulfil or is disproportionate. In this case, you can then opt for a reduction in price or cancellation of the sale, which must be dealt with directly with the sales vendor. This also covers replacement of spare parts provided that the product has been used according to the recommendations specified in this manual for both cases, and has not been tampered with by any third party that is not authorised by B & B TRENDS, SL. The warranty will not cover any parts subject to wear and tear. This warranty does not affect your rights as a consumer in accordance with the provisions in Directive 1999/44/EC for member states of the European Union.

USE OF WARRANTY

Customers must contact a B&B TRENDS, SL., authorised Technical Service for repair of the product. Since any tampering of the same by anyone not authorised by B&B TRENDS, SL., or the careless or improper use of the same shall render this warranty null and void. You must keep the purchase invoice, receipt or delivery docket in order to exercise your warranty rights. For technical service and after-sales care outside the Spanish territory, please submit your query to the point of sale where you purchased the item.

BON DE GARANTIE