LR-T-2130 - Loading ramp MSW - Free user manual and instructions

USER MANUAL LR-T-2130 MSW

This User Manual has been translated for your convenience using machine translation. Reasonable efforts have been made to provide an accurate translation; however, no automated translation is perfect nor is it intended to replace human translators. The official User Manual is the English version. Any discrepancies or differences created in the translation are not binding and have no legal effect for compliance or enforcement purposes. If any questions arise related to the accuracy of the information contained in the User Manual, please refer to the English version of those contents which is the official version.

Technical data

Parameter description Parameter value
Product name	Loading ramp
Model	MSW-LR-T-2130	MSW-LR-S-2FT
Weight [kg]	8.7	4.9
Dimensions [width x depth x height; mm]	Folded: 1210 x 189 x 60Unfolded: 2130 x 189 x 60	610 x 740 x 55
Maximum load [kg]	136 x 2 (272 both)	272

Please read and save these instructions.

Read through this owner's manual carefully before using the product. Protect yourself and others by observing all safety information, warnings, and cautions. Failure to comply with instructions could result in personal injury and/or damage to product or property. Please retain instructions for future reference.

- Maximum load 272 / 600 lbs kg distributed weight one product.

- Never exceed the rated capacity of the ramp(s) — keep all body parts clear of ramp edges

Inspection

Check the ramp/ramps for any damage before use. Make sure all rivets, anti-slip surfaces and lock buttons on ramp are in good order.

Safety

Only use on clean, stable and level ground. Only use with a secure, flat landing surface. Never exert sideways forces when using the ramp. Do not use the ramp after taking medicine or alcohol. Do not let children use the ramp without appropriate adult supervision. Only use ramp with lock button in place.

WARNING: The ramp is a conductor. Never Use the ramp on or near high voltage equipment.

CAUTION!

- It is ESSENTIAL that a risk assessment is carried out by a competent person as to the safety and suitability of the particular ramp for a specific user.

EN

• Only use these ramps with a qualified helper, never exceed the recommended weight limit during use.
  • Always back the wheelchair/scooter down the ramps and use a lap strap for safety.
• Always check the wheelchairs/scooters owner's manual regarding the safe incline for any particular chair.
  • This equipment must be installed by a competent person.

USING YOUR RAMP

• Always fully extend the ramps before use to minimize the risk of injury, and also make any ascent or descent using the ramps easier.
• Select a place to use where the ramp/ramps have the minimum gradient possible. Ensure the gradient of the ramp/ramps is not beyond the ability of the wheelchair or occupant.
• Place the narrow end of the ramp on the ground or low point, and place the wide end of the ramp on the vehicle or high ground.
• Ensure the ramp/ramps is/are safe before use.

TO EXTEND (chosen model only)

- Slowly pull out the narrowest section of the ramp whilst holding the widest section, until it is locked in position.

WARNING! To prevent possible injury, please ensure when retracting or extending the ramp that both sections are held firmly or that the lower edge of the ramp is resting on the floor. DO NOT hold the ramp in a raised position over feet or toes. The narrow section of ramp will slide quickly down when the locking button is depressed.

• To extend the ramp to its full length, continue to pull the narrowest section of the ramp whilst pressing the button situated on the outside of the ramp. Do this until the section is locked in position.
• Repeat this for the other ramp.

TO RETRACT (chosen model only)

• Position the narrowest section into the main body of the ramp. Do this by pressing the button whilst pushing the narrowest section into the body of the ramp.
• To complete the retraction operation, continue to push the narrowest section into the body of the ramp whilst pressing the button. Do this until the ramp is locked into position.
• Repeat this for the other ramp.

• Regularly check ramps for worn, loose or damaged parts – If found any damage do not use it anymore and contact the service department.
  • Always use both ramps (if multi pieces), and ensure they are level and parallel to each other.
• Ensure ramps are fully extended and locked in position (if retractable).
• Do not attempt to use ramps at a steep gradient. Please also check the gradient if for example a wheelchair or scooter is capable of.
• Do not exceed the weight capacity of the ramps.
• Only allow one person/ mobility vehicle to use the ramps at once.
• The surface of the ramps may become slippery in icy or wet conditions. Take caution in these conditions.
• Keep your ramps clean of any dirt or debris as this could interfere with its sliding motion.
• Always use both ramps in line with the wheelchairs/scooter manufacturer's guidelines; NEVER use it at a steeper gradient than recommended.
• Do not modify or add anything as it could void warranty claims.
• Do not use the ramp for anything other than its original intended purpose.
• Only clean your ramps with mild detergent.
• Use caution when adjusting the length of your ramps and avoid any pinch points.

CLEANING

Clean your Ramps using a mild detergent with a slightly damp, soft cloth only. Only use a mild detergent or disinfectant; never use an abrasive cleaner.
After cleaning, leave the ramp/ramps in some warm and dry place or wipe over with a dry, soft cloth. Do not leave in a direct contact with a heat source.
Use common sense and do not take any unnecessary risks when using this product; the user must accept liability for safety when using the product.

VEDLIKEHOLD OG SIKKERHET

Preberite in shranite ta navodila.

UPORABA VAŠE KLANČINE

For the disposal of the device please consider and act according to the national and local rules and regulations.

CONTACT

expondo Polska sp. z o.o. sp. k.