XSW 1ME3 - Microphone SENNHEISER - Free user manual and instructions

USER MANUAL XSW 1ME3 SENNHEISER

COMPLIANCE Specifications Modulation wideband FM Frequency ranges A: 548 to 572 MHz GB: 606 to 630 MHz B: 614 to 638 MHz BC: 670 to 694 MHz C: 766 to 790 MHz D: 794 to 806 MHz E: 821 to 832 MHz and 863 to 865 MHz K: 925 to 937.5 MHz Switching bandwidth up to 24 MHz Frequencies 8 frequency banks, each with up to 10 factory-preset channels Signal-to-noise ratio ≥ 103 dBA THD ≤ 0.9% Temperature range operation: 0°C to +40°C storage: –20°C to +70°C Transmitter synchronization 2.4 GHz, RF Power <3 mW, Low Power OQPSK (only active during synchronization) System

EM-XSW1 EM-XSW1 DUAL

Receiver principle double superheterodyne Diversity principle antenna switching diversity via internal antennas Sensitivity (at peak deviation) < 3 μV at 52 dB(A) rms S/N AF frequency response 50 to 16,000 Hz ( –3 dB) Max. AF output voltage (at peak deviation, 1 kHz AF) 1/4" (6.3 mm) jack socket (unbalanced): +6 dBu XLR socket (balanced): +12 dBu Audio adjustment range 45 dB, adjustable in 5-dB steps Power supply 12 V⎓ nom. / 300 mA 12 V⎓ nom. / 500 mA Squelch adjustable from 3 dBμV to 28 dBμV (combined with pilot tone) Line/Mic level 20 dB, switchable Housing material rugged ABS housing Dimensions (W x H x D) approx. 200 x 42 x 127 mm approx. 320 x 42 x 127 mm Weight approx. 340 g approx. 610 g Receiver2 | XS WIRELESS 1 Transmitters SK-XSW SKM-XSW e 825 e 835 RF output power 10 mW AF frequency response 50 to 16,000 Hz (Line) 80 to 16,000 Hz (Mic) 80 to 14,000 Hz 80 to 16,000 Hz Audio input 3.5 mm jack socket – Max. input voltage (Mic/Line) at 3% THD typ. 1.5 V RMS Mic/ typ. 2.6 V RMS Line @ –30 dB Gain

Power supply 2 AA size batteries, 1.5 V 2 AA size batteries, 1.5 V Operating time approx. 10 hours Microphone type – dynamic Input sensitivity (capsule) – 1.5 mV/Pa Pick-up pattern – cardioid Adjustment range of transmitter sensitivity 0 to –30 dB, adjustable in 10-dB steps Housing material rugged ABS housing Dimensions approx. 71 x 96 x 28 mm (W x H x D) approx. 260 x 50 mm (L x ∅) Weight approx. 95 g approx. 245 g ME 2-2 ME 3-II e 908T Transducer principle condenser, pre-polarized condenser, pre-polarized condenser, pre-polarized Sensitivity 20 mV/Pa 1.6 mV/Pa 0.6 mV/Pa Pick-up pattern omni-directional cardioid Cardioid Max. SPL 130 dB 150 dB 147 dB MicrophonesXS WIRELESS 1 | 3 ENFRITPTNLPLSEDKFI

Connector assignment NT 12-5CW power supply unit Nominal input voltage 100 to 240 V~ Power frequency 50 or 60 Hz Input current ≤ max. 200 mA Nominal output voltage 12 V⎓ Output current ≤ 500 mA Standby power consumption ≤ 0.075 W @230 V AC ≤ 0.1 W @115 V AC Energy efficiency level DoE Level VI Temperature range 0°C to +40°C Storage temperature –20°C to +60°C Relative air humidity max. 95% Weight (without adapter) approx. 65 g Cable lenght approx. 1.83 m4 | XS WIRELESS 1 Manufacturer Declarations Warranty Sennheiser electronic GmbH & Co. KG gives a warranty of 24 months on this product. For the current warranty conditions, please visit our website at www.sennheiser.com or contact your Sennheiser partner. For Australia only Sennheiser goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. This warranty is in addition to other rights or remedies under law. Nothing in this warranty ex- cludes, limits or modifies any liability of Sennheiser which is imposed by law, or limits or modifies any remedy available to the consumer which is granted by law. To make a claim under this warranty, contact Sennheiser Technical Services and Spare Parts Sales c/o Linfox, Gate 3, 1 Fox Lane, Erskine Park, 2759, NSW Australia Phone: (02) 9910 6700 email: au-service@sennheiser.com All expenses of claiming the warranty will be borne by the person making the claim. The Sennheiser International Warranty is provided by Sennheiser Australia Pty Ltd (ABN 68 165 388 312), Unit 3, 31 Gibbes Street Chatswood NSW 2067 Australia. In compliance with the following requirements

• WEEE Directive (2012/19/EU)

• Battery Directive (2013/56/EU & 2006/66/EU) Notes on disposal The symbol of the crossed-out wheeled bin on the product, the battery/rechargeable battery and/or the packaging indicates that these products must not be disposed of with normal household waste, but must be disposed of separately at the end of their operational lifetime. Further information on the recycling of theses products can be obtained from your municipal admi- nistration, from the municipal collection points, or from your Sennheiser partner. The separate collection of waste electrical and electronic equipment, batteries/rechargeable bat- teries and packagings is used to promote the reuse and recycling and to prevent negative effects caused by e.g. potentially hazardous substances contained in these products. Herewith you make an important contribution to the protection of the environment and public health.XS WIRELESS 1 | 5 ENFRITPTNLPLSEDKFI

COMPLIANCE CE Declaration of Conformity

• RoHS Directive (2011/65/EU) Hereby, Sennheiser electronic GmbH & Co. KG declares that the radio equipment type XS WIRELESS 1 consisting of SKM-XSW, SK-XSW, EM-XSW1 and EM-XSW1 DUAL is in compliance with Directive 2014/53/EU The full text of this declaration is available at www.sennheiser.com/download. Information about approvals and certifications can be found in the “Compliance” section. Conditions and restrictions for using frequencies There may be special conditions and restrictions for using frequencies in your country. Before putting the product into operation, find the information for your country at the following address: www.sennheiser.com/frequency-information6 | XS WIRELESS 1 Statements regarding the FCC and Industry Canada rules This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con- ditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that in- terference will not occur in a particular installation. If this equipment does cause harmful interferen- ce to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/ TV technician for help. CAN ICES-3 (B)/NMB-3(B): This Class B digital apparatus complies with the Canadian ICES-003. Changes or modifications not expressly approved by Sennheiser electronic Corp. could void the user’s authority to operate the equipment.XS WIRELESS 1 | 1 ENFRITPTNLPLSEDKFI RUZH ES

RMS Line型 @ –30 dB Gain

20 mV/Pa 1.6 mV/Pa 0.6 mV/Pa

(Mic/Line), 왜곡율 3% 타입 1.5 V RMS Mic/ 타입 2.6 V RMS Line @ –30 dB Gain

20 mV/Pa 1.6 mV/Pa 0.6 mV/Pa

COMPLIANCE In compliance with Canada EM EM DUAL

SK-XSW SKM-XSW2 | XS WIRELESS 1

Certified by Range A: 548 - 572 MHz Europe EM EM DUAL

Certified by Range BC: 670 - 694 MHz Europe EMEM DUALSK, SKM Australia/New Zealand

COMPLIANCE Certified by Range E: 821 - 832 and 863 - 865 MHz Europe EMEM DUAL

NT 12-5CW6 | XS WIRELESS 1

Japan China South Korea