XF 80mm F2.8 R LM OIS WR Macro - Lens FUJIFILM - Free user manual and instructions

USER MANUAL XF 80mm F2.8 R LM OIS WR Macro FUJIFILM

XF80mmF2.8 R LM OIS WR Macro

XF80mmF2.8 R LM OIS WR Macro

• Make sure that you use the lens correctly. Read these safety notes and the camera Owner’s Manual carefully before use.

• After reading these safety notes, store them in a safe place. About the Icons The icons shown below are used in this document to indicate the severity of the injury or damage that can result if the infor- mation indicated by the icon is ignored and the product is used incorrectly as a result. WARNINGThis icon indicates that death or serious injury can result if the information is ignored.CAUTIONThis icon indicates that per-sonal injury or material dam-age can result if the informa-tion is ignored. The icons shown below are used to indicate the nature of the instructions which are to be observed. Triangular icons tell you that this infor-mation requires attention (“Important”).Circular icons with a diagonal bar tell you that the action indicated is prohibited (“Prohibited”).Filled circles with an exclamation mark indicate an action that must be per-formed (“Required”). WARNING WARNINGDo not use in the bathroom or showerDo not immerse in or expose to water. Failure to observe this precaution can cause a fi re or electric shock. WARNING WARNINGDo not disassembleDo not disassemble (do not open the case). Failure to observe this precaution can cause fi re, electric shock, or injury due to product malfunction.Do not touch internal partsShould the case break open as the result of a fall or other accident, do not touch the exposed parts. Failure to observe this precaution could result in electric shock or in in-jury from touching the damaged parts. Remove the camera bat-tery immediately, taking care to avoid injury or electric shock, and take the product to the point of purchase for consultation.Do not place on unstable surfaces. The product may fall, causing injury.Do not view the sun through the lens or camera view nders. Failure to observe this precaution can cause permanent visual impairment.EN-2 ENGLISH CAUTION CAUTION Do not use or store in locations that are exposed to steam, or smoke or are very humid or extremely dusty. Failure to observe this precaution can cause fi re or electric shock. Do not leave in direct sunlight or in locations subject to very high tem- peratures, such as in a closed vehicle on a sunny day. Failure to observe this precaution can cause fi re. Keep out of the reach of small chil- dren. This product could cause injury in the hands of a child. Do not handle with wet hands. Fail- ure to observe this precaution can cause electric shock. Keep the sun out of the frame when shooting backlit subjects. Sunlight focused into the camera when the sun is in or close to the frame can cause fi re or burns. When the product is not in use, replace the lens caps and store out of direct sunlight. Sunlight fo- cused by the lens can cause fi re or burns. CAUTION CAUTION Do not carry the camera or lens while they are attached to a tripod. The product can fall or strike other objects, causing injury. For Customers in the U. S. A. For Customers in the U. S. A. Tested To Comply With FCC Standards

FOR HOME OR OFFICE USE

FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the follow- ing two conditions: (1) This device may not cause harmful interference, and (2) this device must ac- cept any interference received, including interfer- ence that may cause undesired operation. CAUTION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec- tion against harmful interference in a residential in- stallation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica- tions. However, there is no guarantee that inter- ference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be de- termined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.EN-3 ENGLISH

• Connect the equipment into an outlet on a cir- cuit diff erent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• You are cautioned that any changes or modifi - cations not expressly approved in this manual could void the user’s authority to operate the equipment. Notes on the Grant: To comply with Part 15 of the FCC Rules, this product must be used with a Fujifi lm-specifi ed ferrite-core A/V cable, USB cable, and DC supply cord. For Customers in Canada For Customers in Canada CAN ICES-3 (B)/NMB-3(B) CAUTION: This Class B digital apparatus complies with Canadian ICES-003.

IMPORTANT SAFETY INSTRUCTIONS

• Read these instructions.

• Keep these instructions.

• Follow all instructions.

• Do not use this apparatus near water (excluding waterproof products).

• Clean only with a dry cloth.

• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

• Do not install near any heat sources such as ra- diators, heat registers, stoves, or other apparatus (including amplifi ers) that produce heat.

• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

• Only use attachments/accessories specifi ed by the manufacturer.

• Unplug this apparatus during lightning storms or when unused for long periods of time.

• Refer all servicing to qualifi ed service personal. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the ap- paratus has been exposed to rain or moisture, does not operate normally, or has been dropped. Disposal of Electrical and Electronic Equipment in Disposal of Electrical and Electronic Equipment in Private Households Private Households In the European Union, Norway, Iceland and Liechtenstein: This symbol on the product, or in the manual and in the warranty, and/or on its packaging in- dicates that this product shall not be treated as household waste. Instead it should be taken to an applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative conse- quences to the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve nat- ural resources. For more detailed information about recycling this product, please contact your local city offi ce, your household waste disposal service or the shop where you purchased the product. In Countries Outside the European Union, Norway, Iceland and Liechtenstein: If you wish to discard this product, including the batteries or accumulators, please contact your local authorities and ask for the correct way of disposal. Australian RCMEN-4 ENGLISH Before Using This Product Some lens features are not available with older versions of the camera rmware. Be sure to up- date the camera rmware to the latest version. Instructions on viewing the camera rmware version and updating camera rmware are available from the following website: http://www.fujifilm.com/support/digital_cameras/ software/#firmware If you do not have access to a computer, sup- port is available from the local distributor listed in the “FUJIFILM Worldwide Network” material provided with your camera. Product Care

• When using a lens hood, do not pick up or hold the camera using only the hood.

• Keep the lens signal contacts clean.

• Use a blower to remove dust and lint from the glass surfaces of the lens or lter. To re- move smudges and ngerprints, apply a small amount of lens cleaner to a soft, clean cotton cloth or lens-cleaning tissue and clean from the center outwards using a circular motion, taking care not to leave smears or touch the glass with your ngers.

• Never use organic solvents such as paint thin- ner or benzene to clean the lens.

• Attach the front and rear caps when the lens is not in use.

• Store the lens and lter in cool, dry locations to prevent mold and rust. Do not store in direct sunlight or with naphtha or camphor moth balls.

• Keep the lens dry. Rusting can cause irrepara- ble damage. Wipe o rain and water droplets.

• Leaving the lens in extremely hot locations could cause damage or warping.EN-5 ENGLISH Parts of the Lens XF80mmF2.8 R LM OIS WR Macro

Mounting marks (focal length)

Focus range selector

Lens signal contacts

Rear lens cap Q The lens mount includes a rubber ring to ensure that the lens remains dust- and splash-proof. The ring can be replaced for a fee at any FUJIFILM service center.EN-6 ENGLISH Supplied Accessories

• Cloth wrapping Attaching the Lens See the camera manual for information on attaching and removing lenses.EN-7ENGLISH Removing the Caps Remove the caps as shown. Attaching the Hood When attached, lens hoods reduce glare and protect the front lens element.EN-8 ENGLISH The Focus Range Selector Choose the focus range for autofocus: FULL (0.25 m–∞) or, for faster focus, 0.5 m–∞ or 0.25–0.5 m. Q At the minimum focus distance of 25cm, the work- ing distance (the distance between the subject and the front lens element) is 11cm. Optical Image Stabilization (O. I. S.) To use optical image stabiliza- tion, slide the O. I. S. switch to ON. Q The high reproduction ratios used in macro photography amplify the ef- fects of camera shake. Although the lens compensates for panning (verti- cal and side-to-side) motion and consequently does aid in reducing blur during macro photography, caution is required as image stabilization will be less eff ective than at longer focal lengths. Q The shallow fi eld depths associated with macro photography increase the risk of out-of-focus shots should the distance to the subject change as the result of camera shake. When shooting at short working distances, we rec- ommend that you focus using AF-C and hold the camera steady.EN-9ENGLISH The Aperture Ring Rotate the lens aperture ring to choose the aperture (f-number).

111622A Aperture ring Manual Exposure The aperture indicated on the camera and lens is for a subject at in nity. While at non-macro ranges this has no e ect on exposure, in macro photography the ef- fective aperture slows as the distance to the subject drops. When setting exposure manually, add the following exposure fac- tor to the value given by the exposure meter. Reproduction ratio Reproduction ratio

Focus distance (m) Focus distance (m) 0.54 0.38 0.31 0.28 0.25 E ective f-number E ective f-number 3.1 3.2 3.4 3.6 4.0 Exposure factor (EV) Exposure factor (EV) +⁄ +⁄ +1EN-10 ENGLISH Speci cations Type XF80mmF2.8 R LM OIS WR Macro Lens construction 16 elements in 12 groups (including 1 aspherical, 3 extra-low-dispersion, and 1 super extra-low-dispersion elements) Focal length (35mm format equivalent) f=80 mm (122 mm) Angle of view 20.1° Max. aperture f/2.8 Min. aperture f/22 Aperture control Number of blades 9 (rounded diaphragm opening) Stop size ⁄ EV (19 stops) Focus range (measured from focal plane) 25 cm–infi nity Max. magni cation 1 × External dimensions: Diameter × Length

• distance from camera lens mount ange ⌀80 × 130 mm Weight

(approx.) * excluding caps and hoods 750 g Filter size ⌀62 mm Q Improvements may result in unannounced changes to specifi cations and appearance. Q Owing to how this lens is constructed, the “Distance indicator” displayed by the camera may in some cases diff er from the actual focus distance. Use the “Distance indicator” as a guide only. R This lens uses linear motors to ensure fast and accurate autofocus while maintaining the highest image quality. When the camera is turned off , the lens is disconnected from the camera body, or the playback feature is turned on, there may be an audible sound and slight physical vibration due to the linear motor’s magnets being disengaged. This is perfectly normal and will not negatively aff ect image quality or lens performance.FR-1 FRANÇAIS Pour votre sécurité Lisez attentivement ces remarques avant toute utilisation Consignes de sécurité Nous vous remercions d’avoir acheté ce pro- duit. Pour le faire réparer, inspecter ou tester, contactez votre représentant FUJIFILM.

XF80mmF2.8 R LM OIS WR Macro

XF80mmF2.8 R LM OIS WR Macro

XF80mmF2.8 R LM OIS WR Macro

XF80mmF2.8 R LM OIS WR Macro