Ready Warm 6250 Ceramic Sky Style - Heating CECOTEC - Free user manual and instructions

USER MANUAL Ready Warm 6250 Ceramic Sky Style CECOTEC

1. Parts and components / 04

5. Cleaning and maintenance / 12

6. Technical specications / 12

7. Disposal of old electrical appliances / 12

8. Technical support service and warranty / 13

Read these instructions thoroughly before using the appliance. Keep this instruction manual for future reference or new users.

• Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the wall outlet is grounded.

• Do not cover the air inlet or outlet openings while the appliance is operating. Keep a minimum distance of 1 metre from the appliance to any object or wall on each side, front and back.

• Do not place the appliance close to heat sources, flammable substances, wet surfaces where it can fall or be pushed into water or allow it to come into contact with water or other liquids.

• The product’s surface might reach high temperatures during operation. Hold the heater only by the handle in order to move it.

• Do not reach for an appliance that has fallen into water, unplug immediately.

• Check the power cord regularly for visible damage. If the cord is damaged, it must be replaced by the ofcial Technical Support Service of Cecotec in order to avoid any type of danger.

• This appliance is intended for household use only. Do not use for industrial or commercial purposes.

• Do not allow the cord to come into contact with hot surfaces.

• Do not use the appliance to dry clothes or leave it unattended during operation.

• Do not insert or allow objects to enter any air inlet or outlet, as this may cause an electric shock, re or damage to the appliance.

• Do not immerse the cord, plug, or any non-removable part of the appliance in water or any other liquid, nor expose the electrical connections to water. Make sure your hands are dry before handling the plug or switching on the appliance.

• The appliance must not be located immediately below a socket-outlet.

• This appliance is not intended for use in bathrooms or similar locations which may be exposed to water, moisture or humidity.

• Always turn off and unplug the appliance when not in useENGLISH

and before moving it to a new location. Pull from the plug, not the cord, to disconnect it from the outlet.

• Avoid the use of an extension cord as this may overheat and cause a risk of re.

• The appliance is not intended to be used by children under the age of 8. It can be used by children over the age of 8, as long as they are given continuous supervision.

• This appliance can be used by children aged 8 and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, as long as they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.

• Supervise young children to make sure that they do not play with the appliance. Close supervision is necessary when the appliance is being used by or near children.

1. Take the product out of the box and remove any packaging materials.

2. Check for any visible damage, if any is observed, contact as soon as possible the Technical

Support Service of Cecotec for advice or reparation.

3. Place the heater on a at and stable surface.

4. Set the power-level switch at “0” and plug the product’s cord into an earthed power supply.

• Turn the power-level knob and thermostat to maximum for fast warming up of a room. Once the room has reached the desired temperature, set the power-level knob at a lower temperature to reduce electrical consumption.ENGLISH

12 READY WARM 6250 CERAMIC SKY STYLE

• When the temperature set at the thermostat is reached, the appliance will automatically switch off and will switch back on again when the room temperature falls below the set one.

• The indicator light will be ON while de thermostat is operating and will turn OFF when the set temperature is reached.

• Before removing the plug from the power supply, turn the power-level knob to “0”. SWING BUTTON Press this button in order to activate or deactivate the heat-oscillation function. OVERHEAT PROTECTION This heater is protected with an overheat protection that switches off the appliance automatically in case of overheating. It can block due to the total or partial obstruction of the air inlet or outlet. If this happens, follow the instructions below:

1. Unplug the appliance and wait about 30 minutes for it to cool down.

2. Remove the object which is obstructing the air inlet or outlet.

3. Switch it on again. The appliance should now operate normally.

5. CLEANING AND MAINTENANCE

• Always turn off, unplug and allow the appliance to cool down before cleaning.

• Do not use abrasive scouring pads, powders or cleaners to clean the product.

• Use a soft, dampened and clean cloth to clean the product’s outer housing. Be careful not to touch the heating elements.

• A common cause of overheating is deposits of dust or uff in the appliance. Ensure these deposits are cleared regularly by vacuum-cleaning air vents and grilles.

• If the heater is not going to be operated for a long period of time, store it in a dry and safe place where it is protected from dust.

6. TECHNICAL SPECIFICATIONS

Model: Ready Warm 6250 Ceramic Sky Style Product reference: 05311 2000 W, 220-240 V, 50/60 Hz Made in China | Designed in Spain

7. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), species that old household electrical appliances must not be disposed of with the normal unsorted municipal waste. Old appliances must be collected separately, inENGLISH

order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation to dispose of the appliance correctly. If the product has a built-in battery or uses batteries, they should be removed from the appliance and disposed of appropriately. Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.

8. TECHNICAL SUPPORT SERVICE AND WARRANTY

This product is under warranty for 2 years from the date of purchase, as long as the proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use, as explained in this instruction manual. The warranty will not cover the following situations:

• The product has been used for purposes other than those intended for it, misused, beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any other fault attributable to the customer.

• The product has been disassembled, modied, or repaired by persons, not authorised by the ofcial Technical Support Service of Cecotec.

• Faults deriving from the normal wear and tear of its parts, due to use. The warranty service covers every manufacturing defects of your appliance for 2 years, based on current legislation, except consumable parts. In the event of misuse, the warranty will not apply. If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at +34 963 210 728.FRANÇAIS

Information requirment for the electric local space heaters Model identier(s): 05311_Ready Warm 6250 Ceramic Sky Style Item Symbol Value Unit Item Unit Heat output Type of heat input, for electric storage local space hea- ters only (select one) Nominal heat output Pnom 2.0 kW manual heat charge control, with integrated ther- mostat

Minimum heat output (indicative) Pmin 1,0 kW manual heat charge control with room and/or out- door temperature feedback

Maximum continuous heat output Pmax,c 2,0 kW electronic heat charge control with room and/or outdoor temperature feedback

Auxiliary electricity consumption fan assisted heat output No At nominal heat output elmax N/A kW Type of heat output/room temperature control (select one) At minimum heat output elmin N/A kW single stage heat output and no room temperature control

In standby mode elSB 0 kW Two or more manual stages, no room temperature control

with mechanic thermostat room temperature control

with electronic room temperature control Yes electronic room temperature control plus day timer No electronic room temperature control plus week timer

Other control options (multiple selections possible) room temperature control, with presence detection No room temperature control, with open window detection