Spalty W 3704T - Log splitter Güde - Free user manual and instructions
Find the device manual for free Spalty W 3704T Güde in PDF.
📄
Document temporarily unavailable
The manual is currently being transferred to our new server. It will be accessible again in a few hours. Thank you for your patience.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product type | Hydraulic log splitter |
| Brand | Güde |
| Model | Spalty W 3704T |
| Voltage / Frequency | 230 V ~ 50 Hz |
| Motor power (P1, S6 40%) | 1500 W |
| Maximum splitting force | 4 tons |
| Maximum hydraulic pressure | 160 bar |
| Maximum splitting stroke | 230 mm |
| Wood diameter to split (min/max) | 50 / 250 mm |
| Wood length to split (min/max) | 250 / 370 mm |
| Forward speed | 0.04 m/s |
| Hydraulic oil tank capacity | 2.4 L |
| Hydraulic oil viscosity | SAE 20 / HPL 46 |
| Protection class | IP 54 |
| Insulation class | B |
| No-load speed | 2950 min⁻¹ |
| Dimensions (L × W × H) | 810 × 270 × 460 mm |
| Weight | 38 kg |
| Safety | Two-handed operation (two simultaneous controls) |
| Maintenance - Oil change | Every 150 hours of operation |
| Maintenance - Wedge sharpening | As needed according to wear |
| Maintenance - Lubrication | Lubricate the slide and control mechanism |
| Warranty | 24 months for consumer, 12 months for industrial use |
Frequently Asked Questions - Spalty W 3704T Güde
What type of hydraulic oil to use and how to change it?
Use hydraulic oil with viscosity SAE 20 or HPL 46. To drain, place the machine in resting position, loosen the oil drain screw (fig. 1/11) and collect the used oil in a 4 L container. Then refill with approximately 2.4 L of new oil. The level should be between the two marks on the dipstick integrated into the screw. Perform this operation every 150 hours of operation.
How to transport the splitter safely?
Before any transport, tighten the vent screw (fig. 2/12) to prevent oil leaks. Use the transport handle (fig. 1/5) and tilt the machine onto its wheels. At least two people are required to remove it from the packaging. Ensure the device remains in an upright position during transport.
What to do if the thrust plate does not retract or makes noise?
This may indicate low oil or air in the hydraulic system. Check the oil level and top up if necessary. If the problem persists, contact a specialist. Before each use, loosen the vent screw (fig. 2/12) a few turns to bleed the air.
What are the essential safety instructions?
Always wear work gloves and safety shoes. Use a 30 mA residual current device. Never split several pieces at once. Maintain a safety distance of at least 5 m for people nearby. Never bypass the two-handed control system. Disconnect the plug before any maintenance.
How to start the splitting cycle?
Place the wood to split flat on the support surface (fig. 1/3). Lower the hydraulic lever (fig. 1/10) with your left hand while operating the starter (fig. 1/7) with your right hand. The cycle stops immediately if you release either control. Release both to retract the thrust plate.
What is the maximum wood size I can split?
The maximum log diameter is 250 mm and the maximum length is 370 mm. The minimum diameter is 50 mm and the minimum length is 250 mm. The wood must be cut straight and placed horizontally on the support surface.
Why does the motor stop automatically?
This is probably due to thermal overload. The overload protection device has activated. Let the motor cool down and try again. If the problem persists, have the device checked by an electrician.
What is the splitting power of this device?
The maximum splitting force is 4 tons (approx. 39 kN). The maximum hydraulic pressure is 160 bar. The 1500 W motor provides a forward speed of 0.04 m/s.
How to maintain the splitting wedge?
The splitting wedge (fig. 1/4) is a wear part. Sharpen it if necessary with a file or grinder. Keep the support surface clean and regularly lubricate the slide with light oil.
Can I use the splitter upright or vertically?
No, the device must only be used in a horizontal position (lying down). Never split wood vertically or against the grain. This could damage the machine and cause injury risk.
User questions about Spalty W 3704T Güde
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Log splitter in PDF format for free! Find your manual Spalty W 3704T - Güde and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Spalty W 3704T by Güde.
