CHAUFFE-BIBERON EXPRESS AUTO ET MAISON - Chauffe-biberon TIGEX - Free user manual and instructions

USER MANUAL CHAUFFE-BIBERON EXPRESS AUTO ET MAISON TIGEX

Please read these instructions carefully before use. €) Keep them close at hand so that you can refer to them VAN

Device description: () Baby food tray (b) Heating accelerator ring (© Measuring cup (@) ON switch e) Light (D Heating tank (@) Mains cable {h) Car adapter lead © Switch Technical characteristics: Power Supply AC230V ; 50 Hz Consumption 500 W Ambient operating temperature | From 7°C to 37°C Conforms to applicable European standards For use in the home:For use in the car: Power supply DC Consumption 100W Ambient operating temperature From 7°Cto 37°C [é € IMPORTANT INSTRUCTIONS TO BE FOLLOWED AT ALL TIMES - Before using the appliance for the first time, check that the voltage of your electrical mains system is compatible with it. The bottle warmer should always be placed on à flat and dry surface, out of reach of children. Remember! Nothing can replace adult supervision. - The bottes should be placed in the tank, with the ring slightly loosened - Jars of baby food should be heated with their tops removed. - Never turn on the appliance without having filled the tank with the required quantity of water (the water used should be free of additives). - Allow the bottle warmer to cool for approximately 15 minutes between uses. Never touch the inside ofthe tank during or just after operation. - Don't forget to unplug the appliance after use. - Never submerge the appliance in water. - In the event of a malfunction, do not dismantle the appliance even to change a damaged lead. It must be repai- red by our after sales service department using special tools in order to avoid danger. - This device is not designed to be used by people (including children) with reduced physical, sensorial or men- tal capacities or people with no experience or knowledge, unless they can benefit, through a person who is res- ponsible for their safety, from supervision or prior instructions concerning the use of the device. Children must be supervised to ensure that they do not play with the device. For use in the car : - Never use the bottle warmer while the vehicle is moving. Leave your engine running when using the bottle war- mer to avoid draining your battery. - The car adapter lead (9 is specially designed for this Tigex bottle warmer: never use it with other appliances. Only use the leads provided. - Regularly check that the cigarette lighter is clean and if necessary clean it. - IFyou have just used your cars cigarette lighter, allow it to cool for five minutes in the open position before plug- ging in your bottle warmer.

OPERATING INSTRUCTIONS 1] Fill the bottle warmer's measuring cup (0) with water, following the instructions shown below, then pour this water into the tank (f). Volume contained. | mia temperture of | Amount of water to | Appt mount ofweter to. | Appronimate heating Bottles in the bottle …|the liquid to be heated|be poured in the tank | timeforuse |bepouredinthetank| — timeforuse foruseinthe house | inthehouse* | _forusein the car inthe cart 20 mt 20°C 8m 1min28s am 6 min 15 240 ml 20°C 8m 2 min 48 5 sm 8 min 065 330 ml 20°C 10m 2mina2s 6m Lo min 15 $ 220 mt 2 sm 2 mina7s 6m Ein 555 20m 2 ENT 2 min 525 6m A2 min 545 330 ml 2 18 ml 3 min os 7m 5 mins7s Volume contained || iteltemperature | Amount of water to Amount of water to. | Approximate heating Jars of in the jrs ofthe food |be poured inthe tank be poured in the tank | time foruse baby food | ofbaby food for use inthehouse | _inthehouse* | _foruseinthe car inthe car” Er 20°C an 2mins2s al 6 min 50 s 190$ 20° 29m 2 min 45 s mm 10 min 15 ER wc 33ml 3 min 59s EL 23 min gs 190$ wc am 5 min 385 ag ml 16 min 408 “Manufacturers data. The average heating time experenced in reality may vary sighiy according to the con the steam produced by the bolling ofthe water. The izes and material (glass or plastic) of the botte or jars of baby od as welas the type and quantit othe liquid t be heated have an effect on the final temperature oFthe contents. you find that your botles or jrs of baby faod are not warm enough at the end of the heating cycle, use a lt- Le more water next time, I, on the other hand they are 100 hot, vou Should reduce the amount of water used. S ofuse. Note: botties and baby food are heated up by 2] Place the bottle (slightly open) in the tank (D. For à jar of baby food (uith its top removed) use the baby food tray (a). Tigex Excellence tips In order to avoid the risk of bacteria reproducing you should prepare and heat your bottles and jars of baby. food just before the meal. Never keep an unfinished bottle. Food should not be heated up for long periods 3/ For small bottles, fit the adapter ring (b) to the tank (F).

Plug the appliance into the mains using the mains power cable — (8). Turn the switch (i) located on the back of the appliance to or, the "home" position.

• USE IN THE CAR Plug the car adapter lead (h) into the back of the appliance and turn the switch (i) located on the back of the appliance to the “car” position. Then plug the lead (h) into the cigarette lighter of your car. 51 Press the ON switch (d) to begin the heating cycle. The light comes on (e). The "ON" button cannot be used to turn off the appliance. The heater turns off automatically at the end of the heating cycle. CAUTION! The steam given off during the heating cycle is very hot. Do not bring your hand near the appliance while it is operating. 6/ Without waiting, carefully remove the bottle or small pot and then turn the switch () located at the back of the appliance to the OFF position. You can then unplug the appliance. For a bottle: tighten the ring and shake well to mix up the contents. Pour a few drops of liquid on the back of your hand to check the temperature. For jars of baby food: stir the contents and check the temperature. Make sure that the appliance is cool before cleaning it or putting it away. Cleaning your bottle warmer : Always unplug the appliance and wait until it is cool before cleaning it. Use à damp cloth to clean the inside and outside of the tank (f). Never submerge the tank (f) in water. Do not use abrasive products. Adapter ring (b), tray (a) and measuring cup (0) can be washed using a sponge with soap and water or can be cleaned in the dishwasher in the top tray. Descaling the tank : According to the quality of the water used, a limescale deposit can build up on the bottom of the tank (f) over time. You should regularly descale your bottle warmer by pouring à mixture of 100 ml of hot water + 100 ml of white vinegar into the tank (°). Leave this to act for approximately 30 minutes before emptying the tank (?) and wipe with à damp cloth. Detergent products should not be used. Warranty : Ifthe unit is looked after carefully, and the operating instructions are followed, the manufacturer guarantee it for 2 years from the date of purchase. We undertake to repair the unit free of charge if poor materials or design faults are to blame. Further claims will not be entertained. Damage caused by inappropriate use of the unit will not be compensated. The supply cable and plug are excluded from the warranty insofar as wear is concerned. Within the first two years from date of purchase, we will eliminate defects acknowledged as justified without invoicing any additional costs incurred. Clarify in advance who is going to accept responsibility for costs. The unit must in any case be sent in accompanied by the warranty note or other evidence of purchase date. no evidence of purchase date is supplied, we will invoice costs without making further enquiries. The unit will then be returned and payment demanded on delivery. This guarantee applies in all countries in which the product is sold. Regardless of the circumstances, the legal guarantee will always apply, in conformity with the law.